Manuale d’uso / di manutenzione del prodotto Gas Cooktop CIR60XS del fabbricante Smeg
Vai alla pagina of 24
Index 1. INSTRUCTIONS FOR SAFE AND PROPER USE ________________ 4 2. POSITIONING OF HOB ____________________________________ 6 3. GAS CONNE CTION ______________________________________ 11 4. ELECTRICAL CO NNECTION ______________________________ 12 5. GAS CONNE CTION ______________________________________ 13 6.
Introduction 1. INSTR UCTIONS FOR SAFE AND PR OPER USE THIS MANUAL IS AN INTE GRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT I N ITS ENTIRETY AND I N AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE COOKING HOB. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTI ONS THEREIN BEFORE USING THE COOKING H OB.
Introduction THE IDENTIFICATION PLATE, WITH TECHNIC AL DATA, SERIAL NUMBE R AND MARKING IS CLEARLY VISIBLE UNDER THE CASING. THE PLATE ON THE CASING MUST N OT BE REMOVED. BEFORE CONNECTING THE DEVICE, MAKE SURE THAT IT H AS BEEN REGULATED FOR THE TYPE OF GAS THAT WILL FEED IT, CHECKING THE LABEL UNDER THE CASING.
Instructions for the installer 6 2. POSITIONING OF HOB It is the law that all gas applia nces are installed by authorised persons . Clearance around th e appliance must com ply with the requireme nts of AS5601. The following operati on requires bui lding and/or carpe ntry work so must be carried out by a competent tradesman.
Instructions for the installer 7 In case of installation on a hollo w compartment with doors, a separating panel has to be placed under the hob. Keep a minimum distance of 10 mm between the bottom of the unit and the panel surface. The pa nel has to be easily removable to allow access in the event of technical service.
Instructions for the installer 8 2.2 Clearance above and around domestic appliances Extract from AS5601 REQUIREMENTS 1 Overhead clearances – (Mea surement A ) Range hoods and exhaust fans sha ll be installe d in accordanc e with the manufacturer’s instructio ns.
Instructions for the installer 9 be protected in accordance wit h Clause 5.12 .1.2 to a height C of not less than 150 mm above the hob for the full dime nsion (width or depth) of the cooking surfac e area. Where the cook ing applianc e is fitted with a ‘splashback’, protection of the rear wall is not requir ed.
Instructions for the installer 10 2.3 Room ventilation Caution – This hob may only be insta lled and op erated in rooms permanently v entilated in a ccordance wit h current regulations. For proper operation of a gas applia nce it is es sential for the air nec essary for combustion of the gas to be able to flow naturally into the r oom.
Instructions for the installer 11 3. GAS CONNECTION This appliance is s uitable for inst allation wit h Natural Gas or ULPG (propane). Refer to page 12 for the relevant burner press ure and appr opriate injector sizes. W hen the app liance is to be connected to Natural Gas then t he pressure regulator suppl ied must be fitted to th e gas inlet.
Instructions for the installer 12 4. ELECTRICAL CONNECTION Make sure that the voltage a nd capacity of th e power line conform to the data shown on the plate l ocated under the casin g.
Instructions for the installer 13 5. GAS CONNECTION Connection to the gas ma ins may be made with a rigid copper pipe or with a flexible pipe and conforming to the prov isions defined by standar d regulations in force. To facilitate connection, fitting A o n the rear of the applianc e may be adjusted latera lly.
Instructions for the installer 14 5.1 Connection to LPG Use a pressur e regulator an d make the con nection to the tank according to the provisions of standar ds regulatio ns in force. Make sure that feed pressure conforms to the l evels shown in the table in pa ragraph “ 6.
Instructions for the installer 15 6. AD APT A TION T O DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, detach the appliance from the electrical socket.
Instructions for the installer 16 6.2 Regulation for LPG Loosen screw A and push support B all the w ay. Use a do uble hea d wrench to remove n ozzle C and ass emble the suitabl e one, following the instructions indicated in the referenc e charts, with r espect to the type of gas to use.
Instructions for the installer 17 6.3 Regulation for natural gas The hob has been adj usted for natural gas at a pressure of 1.0kPa. To allow the unit to work ba ck with this type of gas, after it has been adjusted for L PG, perform the s ame operations described in paragrap h “ 6.
Instructions for the installer 18 7.3 Arrangement of burn ers on hob BURNERS 1 Auxiliary 2 Semi-rapid 3 Rapid 4 Rapid 5 WOK 7.4 Lubrification of gas taps After a while, the gas tap may become hard to turn o r lock. If this happens, it has to be cleaned i nside and re-greased.
Instructions for the user 19 8. USING THE HOB Before turning on the burners, make sure that the burner rin gs, caps and grids have been fitted correctly. In the ultrarapid burner, notch A must be aligned with pin B . Grid C provided is intended for use with wok s (Chinese pans).
Instructions for the user 20 8.2 Practical advice for u sing the burners For better burner performance and minimum ga s consumption, flat bottomed, even reci pients must be used, with covers and proporti onal in siz e to the burners (se e paragra ph “ 8.
Instructions for the user 21 8.4.2 Using the electric elements The electric elements are idea l for ultrarapid cooking. The settings shown in the table are merely in dicative. POSITION HEAT INTENSITY POSSIBLE COOKING - 0 Off To melt butter, chocolate, etc.
Instructions for the user 22 9. CLEANING AND MAINTENANCE Before any intervention, disconnect the power supply of the device. 9.1 Cleaning Clean the cooking top regul arly every time you use it, obv iously after it has cooled. NEVER USE A STEAM JET TO CLEAN THE APPLIANCE.
Instructions for the user 23 9.2.1 Ignition plugs and safety devices For good functioning of the lighting ig nition plugs a nd the sa fety devices, keep them very clean. Check frequently and clea n with a damp cloth whe n necessary. 9.2.2 The cover Clean the glass or steel cover, w here mo unted, with warm water.
Instructions for the user 24 10. PR OBLEMS AND CA USES Each of the followi ng cases is caused by a n abnormal op eration of th e appliance and should be dealt with by a authoris ed persons: pleas e contact your local de aler or Service Ce nter in case you detect a ny of these malfunctioning.
.
914772609/ B.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Smeg Gas Cooktop CIR60XS è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Smeg Gas Cooktop CIR60XS - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Smeg Gas Cooktop CIR60XS imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Smeg Gas Cooktop CIR60XS ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Smeg Gas Cooktop CIR60XS, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Smeg Gas Cooktop CIR60XS.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Smeg Gas Cooktop CIR60XS. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Smeg Gas Cooktop CIR60XS insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
