Manuale d’uso / di manutenzione del prodotto PH2-2000 del fabbricante Kole Audio electronic
Vai alla pagina of 20
.
PH4-800 / PH4-1000 / PH4-1400 PH1-2000D / PH1-4000D / PH1-5500D PH2-700 / PH2-1000 / PH2-1500 / PH2-2000 / PH2-2400 OWNERS MANUAL.
.
- 2 - INTRODUCTION Kole Audio amplifiers provide high-performance sound reinforcement for your mobile audio equipment. Its versatility enables compatibility with optional Equalizers, Frequency Dividing Crossover Networks, and other audio processors in a customized system.
- 3 - Before beginning the installation, consider the following: 1. Do you plan to add additional mobile electronics equipment in the future? If you plan to expand your system by adding other components sometime in the future, ensure adequate space is left and cooling requirements are met.
- 4 - CONNECTING THE POWER (Fig.1) CAUTION: AS A PRECAUTION, DISCONNECT THE POWER WIRE FROM THE BATTERY WHILE MAKING THE POWER AND GROUND CONNECTIONS TO THE AMPLIFIER. 4/8 GAUGE (Thicker if planning for additional Amplifiers) wire is recommended for both the power and ground wires.
- 5 - RCA input jacks These RCA input jacks are for use with source units that have RCA or Line level outputs. A source unit with a minimum level of 200mV is required for proper operation. The use of high quality twisted pair cables is recommended to decrease the possibility of radiated noise entering the system.
- 6 - High pass x-over frequency control This control is used to select the desired high pass x-over frequency. PH4-800/PH4-1000/PH4-1400 : The frequency can be adjusted between 40Hz and 250Hz. PH2-700/PH2-1000/PH2-1500/PH2-2000/PH2-2400 : The frequency can be adjusted between 50Hz and 500Hz.
- 7 - LED Will illuminate GREEN to indicate the amplifier is on and operating normally, and will be illuminated RED if the amplifier shuts down due to short circuit, DC offset, or overheating detected by on board protection circuitry. REMOTE Controls the subwoofer amplifier gain, from a remote location for ease of adjustment during listening.
- 8 - MASTER MODE CONFIGURATION PH1-2000D / PH1-4000D / PH1-5500D 1.Lowest Recommended Impedance is 1ohm mono. 2.RCA Inputs are connected to both Left and Right channels 3.
- 9 - STRAPPED CONFIGURATION PH1-2000D / PH1-4000D / PH1-5500D STRAPPED 2-4ohms 1.Lowest Recommended Impedance is 2ohm Stereo 2.RCA Inputs are connected to both Left and Right channels 3.
- 10 - 2 CHANNEL STEREO CONFIGURATION PH2-700/1000/1500/2000/2400 HEAD UNIT FRONT P ANEL REAR P ANEL 2 CHANNEL BRIDGED CONFIGURATION PH2-700/1000/1500/2000/2400 HEAD UNIT FRONT P ANEL REAR P ANEL 1.Lowest Recommended Impedance is 2ohm Stereo 2.RCA Inputs are connected to both Left and Right channels 3.
- 11 - 2 CHANNEL TRI MODE CONFIGURATION PH2-700 / PH2-1000 / PH2-1500 / PH2-2000 / PH2-2400 HEAD UNIT 1.Lowest Recommended Impedance is 4ohm Stereo 2.RCA Inputs are connected to both Left and Right channels 3.
- 12 - 4 CHANNEL STEREO CONFIGURATION PH4-800 / PH4-1000 / PH4-1400 HEAD UNIT 1.Lowest Recommended Impedance is 2ohm Stereo 2.RCA Inputs are connected to both Left and Right channels 3.
- 13 - 4 CHANNEL BRIDGED CONFIGURATION PH4-800 / PH4-1000 / PH4-1400 HEAD UNIT 1.Lowest recommended impedance is 4ohm bridged mono 2.RCA Inputs are connected to both Left &Right channels 3.
- 14 - 4 CHANNEL TRI MODE CONFIGURATION PH4-800 / PH4-1000 / PH4-1400 3CH 4-8 Ohms 4CH 4-8 Ohms WOOFER 1CH 4-8 Ohms WOOFER 2CH 4-8 Ohms HEAD UNIT 1.Lowest Recommended Impedance is 4ohm Stereo 2.RCA Inputs are connected to both Left and Right channels 3.
- 15 - TROUBLE SHOOTING GUIDE Check fuses in amplifier. Be sure Turn-on lead is connected Repair power wire or connections Check connections to radio Check fuse Inspect for short circuit or an open connection. Reverse Left and Right RCA inputs to determine if it is occurring before the amp.
- 16 - MODEL# MAXIMUM POWER OUTPUT POWER OUTPUT @4Ohm POWER OUTPUT @2Ohm BRIDGED POWER THD FREQUENCY RESPONSE -1.0dB HPF LPF SUBSONIC FIL TER BASS BOOST ADJUST ABLE SENSITIVITY RANGE INPUT IMPEDANCE (LOW LEVEL) FUSE DIMENSION (D x W x H inch) PH2-700 700W 2 X 150W 2 X 180W 1 X 360W 0.
- 17 - MODEL# MAXIMUM POWER OUTPUT POWER OUTPUT @4Ohm POWER OUTPUT @2Ohm POWER OUTPUT @1Ohm BRIDGED POWER THD FREQUENCY RESPONSE -1.0dB HPF LPF SUBSONIC FIL TER BASS BOOST ADJUST ABLE SENSITIVITY RANGE INPUT IMPEDANCE (LOW LEVEL) FUSE DIMENSION (D x W x H inch) PH4-800 800W 4 X 80W 4 X 95W - 2 X 190W 0.
- 18 - W ARNINGS Investigate the layout of your automobile throughly before drilling or cutting any holes. Take care when to work near the gas tanks, lines, or hydraulic lines, and electrical wiring. Don't use power amplifier unmounted. Attach this system securely to the automobile to prevent damage, particularly in the event of an accident.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Kole Audio electronic PH2-2000 è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Kole Audio electronic PH2-2000 - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Kole Audio electronic PH2-2000 imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Kole Audio electronic PH2-2000 ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Kole Audio electronic PH2-2000, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Kole Audio electronic PH2-2000.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Kole Audio electronic PH2-2000. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Kole Audio electronic PH2-2000 insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
