Manuale d’uso / di manutenzione del prodotto 1GR35M ML-136407, 1GR45M ML-136408, 1GR65M ML-136409, 1GR85M ML-136410, 2GR45MF ML-136417, 2GR65MF M del fabbricante Vulcan-Hart
Vai alla pagina of 20
VULCAN-HART DIVISION OF ITW FOOD EQUIPMENT GROUP, LLC WWW.VULCANHART.COM INST ALLA TION & OPERA TION MANUAL For additional information on Vulcan-Hart or to locate an authorized parts and service provider in your area, visit our website at www .vulcanhart.
— 2 — GR SERIES GAS FRYERS IMPORT ANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREP ARED FOR PERSONNEL QUALIFIED T O INST ALL GAS EQUIPMENT , WHO SHOULD PERFORM THE INITIAL FIELD ST ART -UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL.
— 3 — GR SERIES GAS FRYERS T ABLE OF CONTENTS IMPORTANT FOR YOUR SAFETY ................................................................................................. 2 INTRODUCTION ..............................................................
— 4 — GR SERIES GAS FRYERS EXTENDING SHORTENING LIFE ........................................................................................... 14 DRAINING THE TANK .................................................................................
— 5 — GR SERIES GAS FRYERS INTRODUCTION GENERAL Vulcan Fryers are produced with quality workmanship and material. Proper installation, usage and maintenance will result in many years of satisfactory performance. Before installing the fryer, thoroughly read this manual and carefully follow all instructions in the order given.
— 6 — GR SERIES GAS FRYERS RECEIVING AND UNPACKING This fryer was carefully inspected before leaving the factory. Upon acceptance of the shipment, the transportation company assumes full responsibility for safe delivery. Immediately after unpacking the fryer, check for possible shipping damage.
— 7 — GR SERIES GAS FRYERS INST ALLA TION WARNING: THIS EQUIPMENT SHALL BE INSTALLED ONLY BY A LICENSED GAS FITTER. Caution: Do not use the door or its handle to lift the fryer.
— 8 — GR SERIES GAS FRYERS Air Supply and Ventilation WARNING: DO NOT OBSTRUCT THE FLOW OF COMBUSTION/ VENTILATION OR AIR OPENINGS AROUND THE FRYER. ADEQUATE CLEARANCE AROUND THE FRYER IS NECESSARY FOR SERVICING AND PROPER BURNER OPERATION. • Install fryer in an area with sufficient air supply for gas combustion at fryer burners.
— 9 — GR SERIES GAS FRYERS FLUE CONNECTION Caution: Ensure that your ventilation system does not cause a down draft at the fryer's flue opening. Down drafts will not allow the fryer to exhaust properly and will cause overheating which may cause permanent damage.
— 10 — GR SERIES GAS FRYERS Quick-Disconnect for Units on Casters For an appliance equipped with casters: • The installation shall be made with a connector that complies with the Standard for Connectors for Movable Gas Appliances, ANSI Z21.69 or Connectors for Moveable Gas Appliances, CAN/CGA-6.
— 11 — GR SERIES GAS FRYERS OPERA TION WARNING: HOT OIL AND PARTS CAN CAUSE BURNS. USE CARE WHEN OPERATING, CLEANING, AND SERVICING THE FRYER. WARNING: SPILLING HOT FRYING COMPOUND CAN CAUSE SEVERE BURNS. DO NOT MOVE FRYER WITH- OUT DRAINING ALL FRYING COMPOUND FROM THE TANK.
— 12 — GR SERIES GAS FRYERS CAUTION: Solid shortening should NOT be used with GRM Fryers with millivolt controls. Melting solid shortening will damage the fryer tank and void your warranty. • Close the drain valve. • Fill the fryer tank with liquid shortening.
— 13 — GR SERIES GAS FRYERS TURNING OFF THE FRYER (FREE-STANDING MODELS) 1 . Turn the thermostat OFF. 2 . To keep the pilot lit, turn the gas valve knob to “I” in PILOT. 3 . To shut off all gas to the system, including the pilot, turn the gas valve knob to OFF.
— 14 — GR SERIES GAS FRYERS BASIC FRYING INSTRUCTIONS • Set the desired temperature and allow shortening to heat up to that temperature. • Fry items that are about the same size together to ensure equal doneness. • Drain or wipe dry raw or wet foods to minimize splatter when lowering into the hot shortening.
— 15 — GR SERIES GAS FRYERS DAILY FILTERING – ALL MODELS WARNING: HOT OIL AND HOT PARTS CAN CAUSE BURNS. USE CARE WHEN OPERATING, CLEANING, AND SERVICING THE FRYER. WARNING: WHEN HANDLING HOT OIL, WEAR INSULATED AND OIL- PROOF GLOVES. • Filter shortening at least once a day.
— 16 — GR SERIES GAS FRYERS BOIL OUT PROCEDURE Weekly or as required 1 . Drain the tank as described under DRAINING THE TANK. 2 . Once the shortening has been drained, flush out scraps and sediment with a small amount of warm shortening, using tank brush.
— 17 — GR SERIES GAS FRYERS MAINTENANCE WARNING: HOT OIL AND HOT PARTS CAN CAUSE BURNS. USE CARE WHEN OPERATING, CLEANING, AND SERVICING THE FRYER. WARNING: SPILLING HOT FRYING COMPOUND CAN CAUSE SEVERE BURNS. DO NOT MOVE FRYER WITHOUT DRAINING ALL FRYING COMPOUND FROM THE TANK.
— 18 — GR SERIES GAS FRYERS TROUBLESHOOTING WARNING: FRYERS WITH KLEENSCREEN™ FILTERS: CERTAIN PROCEDURES IN THIS SECTION REQUIRE ELECTRICAL TESTS OR MEASUREMENTS WHILE POWER IS APPLIED TO THE MACHINE.
— 19 — GR SERIES GAS FRYERS.
F-31233 Rev. B (May 2006) PRINTED IN U.S.A ..
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Vulcan-Hart 1GR35M ML-136407, 1GR45M ML-136408, 1GR65M ML-136409, 1GR85M ML-136410, 2GR45MF ML-136417, 2GR65MF ML-136418, 2GR85MF ML-136419, 3GR45MF M è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Vulcan-Hart 1GR35M ML-136407, 1GR45M ML-136408, 1GR65M ML-136409, 1GR85M ML-136410, 2GR45MF ML-136417, 2GR65MF ML-136418, 2GR85MF ML-136419, 3GR45MF M - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Vulcan-Hart 1GR35M ML-136407, 1GR45M ML-136408, 1GR65M ML-136409, 1GR85M ML-136410, 2GR45MF ML-136417, 2GR65MF ML-136418, 2GR85MF ML-136419, 3GR45MF M imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Vulcan-Hart 1GR35M ML-136407, 1GR45M ML-136408, 1GR65M ML-136409, 1GR85M ML-136410, 2GR45MF ML-136417, 2GR65MF ML-136418, 2GR85MF ML-136419, 3GR45MF M ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Vulcan-Hart 1GR35M ML-136407, 1GR45M ML-136408, 1GR65M ML-136409, 1GR85M ML-136410, 2GR45MF ML-136417, 2GR65MF ML-136418, 2GR85MF ML-136419, 3GR45MF M, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Vulcan-Hart 1GR35M ML-136407, 1GR45M ML-136408, 1GR65M ML-136409, 1GR85M ML-136410, 2GR45MF ML-136417, 2GR65MF ML-136418, 2GR85MF ML-136419, 3GR45MF M.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Vulcan-Hart 1GR35M ML-136407, 1GR45M ML-136408, 1GR65M ML-136409, 1GR85M ML-136410, 2GR45MF ML-136417, 2GR65MF ML-136418, 2GR85MF ML-136419, 3GR45MF M. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Vulcan-Hart 1GR35M ML-136407, 1GR45M ML-136408, 1GR65M ML-136409, 1GR85M ML-136410, 2GR45MF ML-136417, 2GR65MF ML-136418, 2GR85MF ML-136419, 3GR45MF M insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.