Manuale d’uso / di manutenzione del prodotto 8050 ES RBTL07107.0 del fabbricante Reebok
Vai alla pagina of 32
Serial Number Decal Model No. RBTL07107.0 Serial No. CAUTION Read all precautions and instruc- tions in this manual before using this equipment. Save this manual for future reference. USER'S MANUAL QUESTIONS? As a manufacturer, we are com- mitted to providing complete cus- tomer satisfaction.
The decals shown here have been applied in the locations shown. If a decal is miss- ing or illegible, call the telephone num- ber on the front cover of this manual and request a free replacement decal. Apply the decal in the location shown. Note: The decals may not be shown at ac- tual size.
1. Before beginning any exercise program, con- sult your physician. This is especially impor- tant for persons over the age of 35 or persons with pre-existing health problems. 2. It is the responsibility of the owner to ensure that all users of this treadmill are adequately informed of all warnings and precautions.
4 20. Use the included dumbbells only as de- scribed in this manual. Properly store the dumbbells in the dumbbell holders on the console when you are not using them (see page 5). If the dumbbells are improperly stored, they may fall off the console, causing the user to trip.
5 T hank you for selecting the revolutionary REEBOK ® 8 050 ES treadmill. The 8050 ES treadmill offers an im- pressive selection of features designed to make your workouts at home more enjoyable and effective.
1. Make sure that the power cord is unplugged. With the help of a second person, carefully tip the treadmill onto its left side as shown. Insert an Extension Leg (89) into the base of the Uprights (84) as shown. Hold two Extension Leg Nuts (67) in the bottom of the Extension Leg.
7 2. With the help of a second person, carefully tip the treadmill onto its right side as shown. Insert the other Extension Leg (89) into the base o f the Uprights (84) as shown.
7. While the second person continues to hold the console assembly, locate the wire harne ss un- derneath the console assembly. Conne ct th e wire harness from the console as- sembly to the Wire Harness (77) . See the inset drawing. The connectors should slide to- gether easily and snap into place.
1. Remove the key from the console and unplug the power cord. Remove the Screw (3) and the Access Door (76) from the back of the Console Base (85). 2. Connect the wire on the receiver (A) to the indi- cated wire extending from the Console Base (85). Hold the receiver so the small cylinder is oriented as shown and is facing the Console Base.
OPERA TION AND ADJUSTMENT T HE PRE-LUBRICATED WALKING BELT Your treadmill features a walking belt coated with high- performance lubricant. IMPORTANT: Never apply sil- icone spray or other substances to the walking belt or the walking platform. Such substances will deteriorate the walking belt and cause excessive wear.
1 1 ETPF79506 PFTL79506 FEATURES OF THE CONSOLE The revolutionary treadmill console offers a selection of features designed to make your workouts more effective and enjoyable. When you select the manual mode of the console, you can c hange the speed and incline of the treadmill with the touch of a button.
HOW TO TURN ON THE POWER I MPORTANT: If the treadmill has been exposed to cold temperatures, allow it to warm to room tem- p erature before turning on the power. If you do not do this, the console displays or other electrical components may become damaged.
13 5. Follow your progress with the display. N ote: The display features several different background colors. To select a background c olor, press the Display Color button repeat- edly. When the manual mode is se- lected, the display will show a track that repre- sents 1/4 mile.
14 HOW TO USE A CROSS TRAINER PROGRAM 1 . Insert the key into the console. S ee HOW TO TURN ON THE POWER on page 12. 2. Select one of the nine cross trainer programs.
15 4. Perform the first strength exercise when prompted. When the f irst strength exercise segment be- gins (only one indicator will flash in the Current Segment column), the walking belt will slow to a stop and the name of the first strength exercise will appear in the display for a few sec- onds.
16 HOW TO CREATE A CUSTOM PROGRAM 1. I nsert the key into the console. S ee HOW TO TURN ON THE POWER on page 12. 2. Select one of the custom programs. To select a custom pro- gram, press the Custom Programs button repeat- edly, until “P10” or “P11” ap- pears in the display.
17 HOW TO USE A CUSTOM PROGRAM 1. I nsert the key into the console. S ee HOW TO TURN ON THE POWER on page 12. 2. Select one of the custom programs. To select a custom program, press the Custom Pr og ra ms button repeatedly, until “P10” or “P11” ap- pears in the display.
18 THE INFORMATION MODE T he console features an information mode that keeps track of treadmill usage information. The information m ode also allows you to select miles or kilometers as the unit of measurement, to select an audio trainer set- ting, to adjust the volume, and to turn on and turn off the demo mode.
HOW T O FOLD AND MOVE THE TREADMILL HOW TO FOLD THE TREADMILL FOR STORAGE B efore folding the treadmill, adjust the incline to the lowest position. If you do not do this, you may damage the treadmill when you fold it. Remove the key and unplug the pow er cord.
HOW TO LOWER THE TREADMILL FOR USE 1 . Hold the upper end of the treadmill with your right hand. Pull the latch knob to the left and hold it. It may be necessary to p ush the frame forward as you pull the knob to the left. Pivot the frame downward and release the latch knob.
TROUBLESHOOTING Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual. PROBLEM: The power does not turn on SOLUTION: a.
Raise the Uprights (84) to the vertical position. Remove the three Screws (3) from the Hood (41), a nd carefully pivot the Hood off. Locate the Reed Switch (63) and the Magnet (46) on the left side of the Front Roller (47). Turn the Front Roller until the Magnet is aligned with the Reed Switch.
PROBLEM: The walking belt is off-center or slips when walked on S OLUTION: a . I f the walking belt is off-center, f irst remove the key and UNPLUG THE POWER CORD .
24 These guidelines will help you to plan your exercise program. For detailed exercise information, obtain a reputable book or consult your physician. Remember, proper nutrition and adequate rest are essential for successful results.
SUGGESTED STRETCHES T he correct form for several basic stretches is shown at the right. Move slowly as you stretch—never bounce. 1 . Toe Touch Stretch Stand with your knees bent slightly and slowly bend forward from your hips. Allow your back and shoulders to relax as you reach down toward your toes as far as possible.
P ART LIST—Model No. RBTL07107.0 R 1007A To locate the parts listed below, see the EXPLODED DRAWING near the end of this manual. 26 Key No. Qty. Description Key No.
101 1 Roller Ground Wire 1 02 4 Isolator 103 1 Idler Arm Spring 104 1 Pulley Bolt 105 1 Idler Arm 1 06 1 Idler Arm Pulley 1 07 1 Idler Arm Pulley Nut 108 2 Thin Base Pad 109 1 15 1/2" Wire Tie 1 .
5 1 5 5 5 16 19 10 1 1 69 49 9 15 47 46 1 5 5 5 5 9 51 52 48 22 55 22 54 12 1 1 58 17 10 15 6 53 21 23 53 21 23 70 3 102 3 102 18 6 19 12 70 7 7 90 90 101 18 29 50 30 39 96 97 30 3 102 3 102 28 EXPLODED DRA WING A—Model No.
11 0 63 59 3 2 38 40 28 28 32 32 36 42 3 3 61 22 4 13 43 45 26 27 24 103 41 73 73 73 95 32 107 106 105 99 104 7 7 7 66 66 66 66 7 93 25 33 3 22 22 22 22 22 33 92 56 3 29 EXPLODED DRA WING B—Model No.
84 82 22 82 22 68 60 65 31 83 44 33 80 89 81 78 44 31 83 108 68 108 22 80 67 89 81 78 77 60 3 3 22 8 64 20 8 62 62 3 3 3 3 8 64 8 3 3 3 3 3 77 33 57 67 65 82 22 82 22 14 87 86 87 88 72 30 EXPLODED DRA WING C—Model No.
3 76 79 75 2 74 71 34 85 3 3 3 91 9 98 37 3 5 35 33 100 2 94 109 31 EXPLODED DRA WING D—Model No. RBTL07107.0 R 1007A.
Part No. 259281 R1007A Printed in USA © 2007 ICON IP, Inc. ORDERING REPLACEMENT P ARTS To order replacement parts, please see the front cover of this manual.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Reebok 8050 ES RBTL07107.0 è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Reebok 8050 ES RBTL07107.0 - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Reebok 8050 ES RBTL07107.0 imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Reebok 8050 ES RBTL07107.0 ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Reebok 8050 ES RBTL07107.0, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Reebok 8050 ES RBTL07107.0.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Reebok 8050 ES RBTL07107.0. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Reebok 8050 ES RBTL07107.0 insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
