Manuale d’uso / di manutenzione del prodotto LVT0862-001B del fabbricante JVC
Vai alla pagina of 24
For Customer Use: Enter below the Model No . and Serial No. which are located either on the rear , bot- tom or side of the cabinet. Retain this inf or mation f or future reference . Model No . Se r ia l N o. LVT0862-001B [B] UX-M5R — Consists of CA-UXM5R and SP-UXM5.
Caution –– STANDBY/ON button! Disconnect the mains plug to shut the power off completely. The STANDBY/ON button in any position does not disconnect the mains line. The power can be remote controlled. IMPORTANT FOR LASER PRODUCTS REPRODUCTION OF LABELS 1 CLASSIFICATION LABEL, PLACED ON EXTERIOR SURFACE 2 WARNING LABEL, PLACED INSIDE THE UNIT 1.
SAFETY INSTR UCTIONS “ SOME DOS AND DON ’ TS ON THE SAFE USE OF EQUIPMENT ” This equipment has been designed and manufactured to meet international safety standards b ut, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured.
– 1 – Introduction W e would like to thank y ou for pur chasing one of our JVC pr oducts. Bef ore operating this unit, read this manual carefull y and thoroughl y to obtain the best possib le performance fr om your unit, and retain this manual f or future reference.
– 2 – Contents Location of the Buttons and Controls ..................... 3 Front Panel ................................................................ 4 Remote Control ......................................................... 5 Getting Started .
– 3 – Location of the Buttons and Controls Become familiar with the b uttons and controls on your unit. Front Panel DISPLA Y MODE PHONES PROGRAM REC PRE EQ /HBS VOLUME SEARCH/TUNING RANDOM CD TUNE.
– 4 – Continued Front Panel See pages in the par entheses for details. 1 Disc compartment (12) 2 ST ANDBY/ON button (8) T urns the unit on or off (standby mode). 3 CD/RANDOM button (12, 13) Selects CD mode. Starts or stops random play in CD mode .
– 5 – Remote Control 1 ST ANDBY/ON button 2 CD/RANDOM button 3 TUNER/B AND button 4 REC (Recording) b utton 5 7 button 6 REMAIN/RDS MODE button 7 INTR O/RDS SEARCH button 8 TIMER button 9 DISPLA Y MODE button p PRE EQ/HBS button q MUTING button Interrupts and r esumes sound r epr oduction.
– 6 – Continued Getting Started Unpacking After unpacking, check to be sure that you ha ve all the follo wing items. The number in the parentheses follo wing each item name indicates the supplied quantity .
– 7 – 2 Connect the supplied AM loop antenna to the AM LOOP terminal. Place the antenna aw ay from the unit and adjust its position for the best reception. 3 Adjust the position of the FM antenna f or the best r eception. 4 Connect the A C power cord of the unit to the A C outlet after all other connections have been made.
– 8 – Common Operations T urning On or Off the Unit T o turn on the unit Press ST ANDBY/ON on the unit or remote control. The unit turns on with the last source selection remaining v alid. T o turn off the unit (on standby) Press ST ANDBY/ON on the unit or remote control.
– 9 – Digital Sound Control The unit’ s digital sound control feature enables you to select desired preset equalizer settings (selectable as sound modes) to enjoy special sound ef fects matching the m usic type. Y ou can also use the HBS (Hyper Bass Sound) system to enjoy po werful bass sound created by emphasizing low frequencies.
– 10 – T uning In a Station 1 When the unit is turned on, press TUNER/B AND to select tuner mode. The unit tunes in the last station tuned in (either FM or MW). 2 Press TUNER/B AND to select the band, FM or MW . Each time you press the button, the band selection alternates between FM and MW .
– 11 – Receiving FM Stations with RDS RDS (Radio Data System) allo ws FM stations to send an additional signal along with their regular pr ogram signals. For e xample, the stations send their station names, as well as information about what type of program the y broadcast, such as sports or music, etc.
– 12 – Playing Back CDs This unit can play back audio CDs and CD-R/R W discs. Loading a Disc 1 Press CD/RANDOM to select CD mode. 2 Press 0 OPEN/CLOSE. The disc tray slides out. 3 Load a disc with the label side facing up. 4 Press 0 OPEN/CLOSE to close the disc compartment.
– 13 – Random Play Y ou can play all the tracks in random order . Press CD/RANDOM bef ore or during playing. The RANDOM indicator lights up. T o exit random play mode, press CD/RANDOM again. The RANDOM indicator goes of f. • Acti vating the REPEA T ONE function during random play mode disables the random play mode.
– 14 – Playing Back T apes • Use only type I normal tapes. The use of tapes longer than 120 minutes is not recommended, since characteristic deterioration may occur and these tapes easily jam in the pinch roller and the capstan. Loading a T ape 1 Press 0 EJECT to open the tape deck door .
– 15 – Recording Recording T apes 1 Load a recordable tape into the tape deck. 2 Press T APE/REV .MODE repeatedly to either r ecord one side or both sides of the tape. : recording on one side only : recording on both sides • When you select , make sure that there is no content that should not be lost is recorded on either side of the tape.
– 16 – Using the T imers There are three timers a vailable – daily timer , recording timer and sleep timer . Before using the timers, you need to set the built-in clock (see page 8). Using Daily Timer W ith the daily timer , you can wake to your fa vourite music or radio program.
– 17 – Using Sleep T imer W ith the sleep timer, y ou can fall asleep to music. Y ou can set the sleep timer using the remote control when the unit is turned on. How the sleep timer actually works The unit automatically turns of f after the specified time length passes.
– 18 – NEWS: News. AFF AIRS: T opical program expanding or enlarging upon the ne ws – debate, or analysis. INFO: Program the purpose of which is to impart advice in the widest sense. SPOR T : Pro gram concerned with any aspect of sports. EDUCA TE: Educational programs.
– 19 – Maintenance T o get the best performance of the unit, keep your discs, tapes, and mechanism clean. Cassette decks If the head, capstan, and pinch roller of the cassette deck become dirty , .
– 20 – Specifications Amplifier section Output po wer 60 W (30 W + 30 W) at 8 Ω (MAX.) 22 W per channel, min. RMS, driv en into 8 Ω at 1 kHz, with no more than 10% total harmonic distortion (IEC 268-3) Audio output lev el PHONES: 800 mV/32 Ω Speakers/Impedance 8 Ω - 16 Ω T uner FM tuning range 87.
0502NNMBICORI EN 99_BCV_UXM5R_B.p65 5/22/02, 7:43 PM 2.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il JVC LVT0862-001B è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del JVC LVT0862-001B - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso JVC LVT0862-001B imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul JVC LVT0862-001B ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il JVC LVT0862-001B, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del JVC LVT0862-001B.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il JVC LVT0862-001B. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo JVC LVT0862-001B insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
