Manuale d’uso / di manutenzione del prodotto CA-MXKB1 del fabbricante JVC
Vai alla pagina of 30
L VT1251-003A [B] COMP A CT COMPONENT SYSTEM CA-MXKB2 CA-MXKB1 INSTRUCTIONS MX-KB2[B].book Page 1 Wedne sday, A pril 28, 2004 2:16 PM.
G-1 W arnings, Cautions and Others IMPORT ANT for the U .K. DO NO T cut off the main s plug fr om this equipment. If the plug fit- ted is not suitable f or the power points in your home or the cab le is too shor t to reach a power point, then obtain an appropr iate saf ety approv ed extension lead or consult your dealer .
G-2 SAFETY INSTRUCTIONS “SOME DOS AND DON’ TS ON THE SAFE U SE OF EQUIPMENT” This equipment has be en disigned and manufactured to meet inte r national safety standards b ut, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured.
1 Introduction Thank you for purchasing the JVC Co mpact Component System. We hope it will be a valued addition to your home, giving you years of enjoy ment. Be sure to read this instruction manual ca refully before operating your new stereo system. In it you will find all the information you need to set up and use the system.
2 Table of Contents Introduction ................................................... ................................................................ 1 Features......................... ................... ....................... .....................
3 Getting Started Accessories Make sure that you have all o f the following items, which are supplied with the System. AM (MW) Loop Antenna (1) Remote Control (1) Batteries (2) If any of these items are missing, contact your dealer immediately.
4 Getting Started CAUTION: • Make all connections before plugging the System into an AC power outlet. About the FM Antenna Connecting the AM (MW) Antenna Rear Panel of the Unit • E ven when co nnecting an outside AM (MW) antenna, keep the indoor AM (MW) loop connected.
5 Getting Started Connecting the Speakers Connect the right speaker to the RIGHT speake r terminals and the left speaker to the LE FT speaker terminals. “Right” / “Left” i s labeled on the rear of the speaker. 1. Open each of the terminals to connect the speaker wire leads.
6 Getting Started Connecting to the Wall Outlet Plug the AC power c ord into the wall outlet. Now, your System is at your command! DEMO Mode When the System is connected to the wall outlet, a DEMO mode displaying some of the system’s features automa tically starts.
7 Basic Operations ) Turning the Power On and Off Turning the System On 1 Pre ss t h e STANDBY/ ON but t on. The display comes on. The STANDBY indicator goes out. The System comes on ready to co ntinue in the mode it was in when the power was last turned off.
8 Basic Operations Adjusting the Volume Turn the VOLUME co ntrol on the Unit clockwise to increase the volume or turn it countercloc kwise to decrease the volume. Press the VOLUME + button on the Remote Control to increase the volume or press the VOLUME – button on the Remote Control to decrease the volume.
9 Using the Tuner You can listen to FM and AM (M W) stations. Stations can be tuned in manually, autom atically, or from preset memory storage. ❏ Before listeni ng to the radio: • Make su re that both the FM and AM (MW) antennas are co r- rectly connected.
10 Using the Tuner • In AM (MW) broadcast, rec eption sensitivity will be ch ang- ed by turning the AM (MW) loop antenna. Turn the AM (MW) loop antenna for best recepti on. Presetting Stations You can preset up to 10 FM stat ions and up to 10 AM (MW) sta- tions.
11 Using the CD Player This unit has been designed to playback the following CDs: • Audio CD • CD-R (CD-Recordable) • CD-RW (CD-ReWritable) For CA-MXKB2 only • MP3 disc (MP3 files recorded on .
12 Using the CD Player About Disc Indicator: The Disc indicator consists of the follow ing three kinds of indicators: One Touch Play The power comes on, and operati ons are done automatically.
13 Using the CD Player Basics of Usin g the CD Player- Normal Play To Play CDs 1 Load CDs. 2 Press CD 6 b utton to p lay. The currently selected disc number (e.g. “CD DISC 1” ) ap- pears on the display. The first track of t he selected CD begins pl aying.
14 Using the CD Player Programming the Playing Order of the Tracks You can program the playing orde r of the tracks on all the CDs. Note that you can only make a program when the CD Player is stopped. ❏ You can program up to 60 tracks in any desired order including the same trac ks.
15 Using the CD Player Random Play The tracks of the s elected CD will pl ay in no special order when you use this mode. 1 In St op mode, set t he CD Player i n Random Play mode. On the Unit Press the RANDOM button to light the “RANDOM”, “REPAET” and “1 CD” indicator.
16 Using the Cassette Deck (Listening to a Tape) The Cassette Deck allows you to play, record, and dub audio tapes. ❏ Listening to typ e I tape is suitable for this Ca ssette Deck. One Touch Play By pressing the TAPE A 3 or TAP E B 3 button, the System will come on, and if a tape is in the d eck, it will start to play.
17 Using the Cassette Deck (Recording) Recording onto a cassette from any of the sound sources is simple. Just place a tape in Deck B, ha ve the source ready, make on e or two settings, and you’re ready to re cord. For each source, the pro- cedure is a litt le bit different so we explain each separately.
18 Using the Cassette Deck (Recording) Standard Recording This is the basic method for re co rding any source. The System also has special ways for recording CD to tape, and ta pe to tape, which save you time and effort, as well as give you some special effects.
19 Using an External Equipment Listening to the External Equipment You can listen to the external equipment such as MD recorder, cas- sette deck, or other auxiliary. ❏ First, make sure that the extern al equipment is properly connect- ed to the Syst em.
20 Using the Timers Three types of timers are available : DAILY Timer Use this timer to set wake up every day to music from any source, instead of an alarm cloc k. REC (Recording) Timer Unattended recording of radi o broadcasts. You can set the starting time a nd ending time.
21 Using the Timers Setting the Daily Timer Once you have set the Daily Timer, the time r will be activated at the same time every day. The Timer indicator ( ) and “DAILY” indicator on the display shows that the Daily Timer you have set is in effect.
22 Using the Timers Preparation for each music source: Perform the following operation according to the music source you have selected. Then, the Sy stem enters Volume Setting mode. When selecting TUNER FM or TUNER AM: Press the ¢ or 4 button to sele ct the preset station number, then press the SET button.
23 Using the Timers Using the Unit You can set the time in the same way as for setting the Daily Tim- er. 1 Inser t a blank or erasabl e tape into t he Deck B an d w i nd p ast the tap e leader. 2 Press the CLOCK/TIMER button unt il “ON TIME” immed iately after “REC TU” appe ars on the display.
24 Using the Timers Setting the SLEEP Timer Use the Sleep Timer to turn the System off after a certain number of minutes when it is playing. By setting the Sleep Timer, you can fall asleep to music a nd know that your System will turn off by it- self rather than play all night.
25 Care And Maintenance Handle your CDs and tapes carefull y, and they will last a long time. Compact Discs CAUTION: • Do not use any solvent (for example, conven- tional record cleaner, s pray thinner, benzine, etc.) to clean a CD. General Notes In general, you will have the best performance by keeping your CDs and the mechanism clea n.
26 Troubleshooting • If you are having a problem with your System, check this list for a possible solution before calling for service. • If you cannot solve the problem from the hint s given here, or the System has been phys ically damaged, call a qualified person, such as your dealer, for service.
0404HMMCREORI EN © 2004 Victor Company of Japan, Limited MX-KB2[B].book Page 1 Wedne sday, A pril 28, 2004 2:16 PM.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il JVC CA-MXKB1 è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del JVC CA-MXKB1 - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso JVC CA-MXKB1 imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul JVC CA-MXKB1 ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il JVC CA-MXKB1, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del JVC CA-MXKB1.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il JVC CA-MXKB1. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo JVC CA-MXKB1 insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
