Manuale d’uso / di manutenzione del prodotto HCW-5 del fabbricante Henny Penny
Vai alla pagina of 26
Henny Penny Humidified Counter W armer Model HCW -2 Model HCS-2 Model HCW -3 Model HCW -5 Model HCS-5 Model HCW -8 OPERA T OR’S MANUAL.
.
Model HCS-2/HCW-3/HCW-5/HCW-8 FM05-019-F Revised 02-14-07 LIMITED W ARRANTY FOR HENNY PENNY EQUIPMENT Subject to the following conditions, Henny Penny Corporation makes the following limited warrantie.
Model HCS-2/HCW-3/HCW-5/HCW-8 T ABLE OF CONTENTS Section Page Section 1. INTRODUCTION ....................................................................................................... 1 - 1 1-1. Heated Display Cabinet ...........................
Model HCS-2/HCW-3/HCW-5/HCW-8 SECTION 1. INTRODUCTION 1-1. HEA TED DISPLA Y The Henny Penny Heated Display Cabinet is a basic unit of food CABINET processing equipment used to display the food product and maintain the temperature of hot foods in the commercial food service operation.
Model HCS-2/HCW-3/HCW-5/HCW-8 1-5. SAFETY The only way to ensure safe operation of the Henny Penny Heated Display Cabinet is to fully understand the proper installation, operation, and maintenance procedures. The instructions in this manual have been prepared to aid you in learning the proper procedures.
Model HCS-2/HCW-3/HCW-5/HCW-8 SECTION 2. INST ALLA TION 2-1. INTRODUCTION This section provides the installation instructions for the Henny Penny Heated Display Cabinet. Installation of this unit should be performed only by a qualified service technician.
Model HCS-2/HCW-3/HCW-5/HCW-8 2-2. UNP ACKING (Continued) 2. Open top flaps and remove packing. 3. Lift carton off skid. 4. Remove four bolts from under skid.
Model HCS-2/HCW-3/HCW-5/HCW-8 2-3. LOCA TION Place the unit on a table, preferably with a cut-out opening below the cabinet to allow easy service connections and serviceability . When setting up the Henny Penny Heated Display Cabinet, be sure to level the table.
Model HCS-2/HCW-3/HCW-5/HCW-8 2-5. DRAIN CONNECTION The drain can be connected to a 1 inch N.P .T . directly below the water well or to a 3/4 inch N.P .T . from the operator ’ s side. W e recommend the 1 inch N.P .T . connection as this will allow straight down draining of the water .
Model HCS-2/HCW-3/HCW-5/HCW-8 2-6. ELECTRICAL CONNECTION The electrical power can be connected from the bottom or from the (Continued) operator ’ s side. There is a 1-3/32 inch diameter hole for either connection. Again, we recommend the bottom connection as this will give a cleaner appearance to the unit.
Model HCS-2/HCW-3/HCW-5/HCW-8 2-8. W A TER SUPPL Y CONNECTION (Continued) This unit as manufactured requires the installation of an appropriate back-siphoning device (as per National Plumbing Code ASA-A40.8-1955) to be connected to the water inlet line.
Model HCS-2/HCW-3/HCW-5/HCW-8 2-10. CABINET DIMENSIONS 1006 2-7 Model HCS-2 Model HCW-3.
Model HCS-2/HCW-3/HCW-5/HCW-8 2-10. CABINET DIMENSIONS (Continued) 2-8 1006 Model HCW-5.
Model HCS-2/HCW-3/HCW-5/HCW-8 SECTION 3. OPERA TING INSTRUCTIONS 3-1. INTRODUCTION This section provides operating procedures for the heated display cabinets. The Introduction, Installation and Operation sections should be read, and all instructions should be followed before operating the cabinet.
Model HCS-2/HCW-3/HCW-5/HCW-8 3-2. OPERA TING CONTROLS (Continued) 3-2 1 03 Figure 3-1 Figure 3-2 Figure 3-3 Figure 3-4 Figure 3-5 Figure 3-6.
Model HCS-2/HCW-3/HCW-5/HCW-8 3-2. OPERA TING CONTROLS (Continued) 103 3 - 3 Figure 3-7 Figure 3-8 Figure 3-9 Figure 3-10 Figure 3-1 1 Figure 3-12.
Model HCS-2/HCW-3/HCW-5/HCW-8 Fig. Item Description Function No. No. 3- 1 1 W ater V alve An electrical solenoid valve energized by the float switch or the water control switch (in manual position) th.
Model HCS-2/HCW-3/HCW-5/HCW-8 Fig. Item Description Function No. No. 3-10 13 W ater Control A three-position switch with center position being OFF; Switch i n the position marked AUTOMA TIC (up), the .
Model HCS-2/HCW-3/HCW-5/HCW-8 Fig. Item Description Function No. No. 3 - 11 2 2 Float Switch An electro-mechanical sensing device used to automati- cally control the water level in the water pan; the .
Model HCS-2/HCW-3/HCW-5/HCW-8 4. Install the perforated bun pans over the water well. This will help in a more rapid heat up of the water . 5. Close the doors. 6. Turn the power switch to the ON position. 7. T urn the light switch to the ON position. 8.
Model HCS-2/HCW-3/HCW-5/HCW-8 3-5. SHUT -DOWN AND 1. T urn the water thermostat to OFF . CLEANUP 2. T urn the radiant heat to OFF . 3. T urn the water control switch to OFF . 4. Open the doors. 5. Remove all the pans. 6. Remove the drain standpipe. 7.
Model HCS-2/HCW-3/HCW-5/HCW-8 4-1. TROUBLESHOOTING GUIDE Product not • Doors are not kept closed • Keep doors closed when holding possible temperature • Product held too long • Only hold produ.
Model HCS-2/HCW-3/HCW-5/HCW-8 G L O S S A R Y HENNY PENNY HOLDING CABINETS air temperature probe a round device located inside the cabinet that measures the inside air temperature and sends that infor.
Model HCS-2/HCW-3/HCW-5/HCW-8 probe clip a metal holder that attaches to the outside of the control panel to hold the food probe when not in use; the clip is an optional accessory product load capacit.
*FM0 5 - 0 19 - F * Henny Penny Corp., Eaton, Ohio 4532 0, R evised 02-14-07 Henny Penny Corporation P.O.Box 60 Eaton,OH 45320 1-937-456-8400 1-937-456-8402 Fax Toll free in USA 1-800-417-8417 1-800-417-8434 Fax www.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Henny Penny HCW-5 è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Henny Penny HCW-5 - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Henny Penny HCW-5 imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Henny Penny HCW-5 ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Henny Penny HCW-5, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Henny Penny HCW-5.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Henny Penny HCW-5. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Henny Penny HCW-5 insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
