





The document describes how to control your BenQ projector via RS232 from a computer. Follow the
procedures to complete the connection and settings first, and refer to the command table for RS232
commands.
Available functions and commands vary by model. Check the specifications and user manual of the purchased projector for product functions.




Choose one of the connections and set up properly before RS232 control.
D-Sub 9 pin (male) on a projector

D-Sub 9 pin (female)

On-screen images in this document are for reference only. The screens may vary depending on your Operating System, I/O ports used for connection, and the specifications of the connected projector.

PC or laptop · Communication cable (crossover)

COM6 is selected.



RJ45 port on a projector

Settings 1. Find the Wired LAN IP address of the connected projector from the OSD menu and make sure the
projector and the computer are within the same network.

RJ45 port on a projector

D-Sub 9 pin RJ45
LAN cable D-Sub 9 pin
Settings 1. Determine the COM Port name used for the RS232 communications in Device Manager.
COM6 is selected.














Read Light level status for custom mode *lampcustom=?# NO









© 2018 BenQ Corporation
All rights reserved. Rights of modification reserved.
I possessori del prodotto e il nostro team di solito rispondono entro 24 ore, e la tua domanda sarà utile anche ad altri.
Invia la prima domanda: risponderanno altri possessori o il nostro team.