
Thank you for choosing our product. We hope you will enjoy using the appliance.
Symbols in this user manual Important notes for your safety are marked distinctively. Pay absolute attention to them to avoid accidents and damage to the device:
These symbols may be found on the device and are intended as warnings:
The lightning flash is intended to alert the user to the presence of dangerous voltage within the device.
The exclamation mark is intended to alert the user to the presence of important operating and maintenance instruction accompanying this device.
Before using this device, carefully read this user manual and keep it together with the Warranty Certificate, cashier receipt and if possible, the original package inclusive its interior pack- ing. If you hand on the device to any third person, include the user manual as well.
Children and disabled persons • For the safety of your children, keep any packing parts (plastic bags, cartilage, Styrofoam etc.) out of their reach.

Front (Fig. 1) 1 Telescopic antenna 2 LCD Display 3 TUNING+/TUNING- buttons (Scan forwards / backwards) 4 ENTER/AUTO-SCAN button (Enter/Scan) 5 VOL+/VOL- buttons (volume) 6 PRESET button 7 INFO/SETUP button (show information/manual DAB search) 8 DAB/FM button 9 STANDBY button (Standby/Operation) 10 ALARM/SLEEP button (Alarm time/Sleep) 11 SNOOZE button (Snooze) 12 Speakers
Rear view (Fig. 2) 13 DC 6 V connector 14 Battery compartment 15 POWER OFF/ON switch (On / Off) 16 PHONES Headphones jack 17 AUX jack
Installation
1. Fully extend the telescopic antenna (1). Stand it upright for initial installation. 2. Switch the device on at the back of the device using the POWER OFF ON switch (15). The device automatically searches for DAB stations. SEARCHING… and a progress bar appears on the display. The figure on the right of the display shows the number of radio stations found. The first alphanumeric DAB station is played. When playing a radio station, the time and date is taken from the broadcasting service.
DAB/FM button (8) For switching between DAB and FM mode.
Battery Operation (Batteries not included) You also have the option of operating the unit with 4 Type R6 “AA” batteries.
VOL+/VOL- Volume (5) Adjust to your preferred volume level. The higher the volume, the more blocks are filled in.

PHONES headphone jack (16) When listening via headphones, please use headphones with a 3.5 mm stereo jack plug which you will connect to the head- phone jack. The speakers will be deactivated.
Delayed shut-off (SLEEP) The device automatically switches off when the selected time is reached.
The SLEEP TIMER OFF setting deactivates this function.
Scan DAB stations Digital Audio Broadcasting (DAB) is a digital broad casing standard for terrestrial reception of digital radio. A list of radio stations which can be received in Germany is available on the Internet at www.digitalradio.de
NOTE: In Germany approx. 70% of the country’s area is covered by digital radio broadcasts (as of Nov. 2011). In the individual areas however, coverage and provision vary greatly. If the DAB stations in your region cannot be received or only with interferences depending on location, in this case you can switch to the FM band to receive this station. This is only possible however if these stations are broadcast via UKW. Find out more on the internet site of the radio station.
AUX Jack For connecting analogue playback devices. Using this jack, you can also hear the sound from other playback devices such as MP3 players, CD players, etc. through the loudspeak- er.
1. Connect the external device with a 3.5 mm stereo jack plug to the AUX jack (17). 2. Turn the device on. The device will automatically switch to AUX mode. The radio sound is muted. 3. You will hear the audio playback from the external device through the loudspeakers. Adjust the volume on the external device. The VOL+/VOL buttons on the device are not functional. 4. For how to proceed further, please refer to the user manual of the external audio source.
1. Press the DAB/FM button (8) repeatedly until “SWITCH TO DAB” appears on the display. 2. Press the ENTER/AUTO-SCAN button (4). “AUTO TUNE FULL SCAN” appears briefly on the display. The device then searches for the radio stations which can be received. 3. You can select the next or the previous station by using the TUNING+/TUNING- buttons (3). 4. If the reception is too weak and the received station “motorboats”, try to improve the reception by changing the position of the antenna.
Scan FM stations 1. Repeatedly press DAB/FM button (8) until the display shows “SWITCH TO FM”. 2. You have two options for tuning a station: - Press the TUNING+/TUNING- buttons (3). - Press the ENTER/AUTO-SCAN button (4). The device searches for the next radio station. 3. If the reception is too weak and there is noise on the re- ceived station, try to improve the reception by changing the position of the telescopic antenna.
Searching for a DAB station manually 1. Keep the INFO/SETUP button (7) pressed. The message “MANUAL TUNE” will appear on the display. 2. Then press the ENTER/AUTO-SCAN button and select the frequency with the TUNING+/TUNING- buttons (3). The message “TUNING…” will appear on the display. The device is searching for radio stations which can be received.
Show FM information Press the INFO/SETUP button (7) to show the following information, if broadcasted by a radio station.

Display additional DAB information In DAB mode, you can display the following additional infor- mation if broadcast by the radio station. To do so, press the INFO/SETUP button (7).
To set the second alarm time, proceed as described above. Do however press the ALARM/SLEEP button twice at point 1. The message ALARM2 will appear in the display.
The activated alarm function is shown on the display by the “
“ symbol. A “1” will appear behind the symbol for the first alarm time, and a “2” for the second alarm time.
Turn off the alarm signal To turn off the alarm, press the STANDBY button (9).
Snooze The automatically set alarm function can be switched off by the SNOOZE button (11) for 9 minutes. To operate the but- tons, press the top of the device. It tilts forward slightly and activates the function.
Save station 1. If you have found the desired station, hold down the PRE- SET button (6). The first preset location appears on the display. If the preset location is still empty, the message “PRESET EMPTY” will appear on the display 2. For choosing the memory position, please press TUNING+/TUNING- buttons (3). 3. Press ENTER/AUTO-SCAN button to save the settings. The message “PRESET STORED” appears briefly on the display.
Deactivate alarm function 1. Press the ALARM/SLEEP button (10). “ALARM 1” is show on the display. To turn off the second alarm time, press the ALARM/SLEEP button twice. 2. Use the TUNING+/TUNING- buttons to select “OFF”. Confirm with the ENTER/AUTO-SCAN button.
Select a preset station 1. Press the PRESET button (6). 2. You will select a preset location with the TUNING+/ TUNING buttons (3). 3. Confirm your selection with the ENTER/AUTO-SCAN button (4).
Troubleshooting
You can set the device in such a way that it switches on at a specific time. Two alarm times can be set.
Problem Cause Solution The unit cannot be operated
Pull the mains plug for approximately 5 seconds. Then con- nect the unit again No DAB Ra- dio reception
The unit is blocked and “hangs”
Telescopic antenna incorrectly aligned
Fully extend the telescopic antenna and align it vertically. No Digital Radio can be received in your area
Setting the alarm time 1. Press the ALARM/SLEEP button. “ALARM 1” appears on the display. The display “OFF” flashes. 2. Select the “ON” setting.

Problem Cause Solution Problems with DAB radio reception
Switch to FM mode to receive these sta- tions. If these stations are transmitted via UKW. Find out more on the internet site of the radio station. No sound Volume is too low Increase the volume Poor sound quality
Depending on the location, you may not be able to receive some stations at all or with interference in your region. see also note on page 22
Meaning of the “Wheelie Bin” Symbol Take care of our environment, do not dispose of electrical applicances via the household waste.
Radio signal too weak Try to adjust the
Dispose of obsolete or defective electrical appliances via municipal collection points.
antenna position. Batteries too weak Insert new batteries or operate the de- vice with the mains cable.
Please help to avoid potential environmental and health impacts through improper waste disposal.
You contribute to recycling and other forms of utilization of old electric and electronic appliances.
Your municipality provides you with information about col- lecting points.
Model: DAB 4130 Battery operation: 4x 1.5 V Type AA, R6 Power consumption: 5 W Net weight: 0.403 kg Radio:
Frequency ranges: VHF/FM 87.5 ~ 108.0 MHz
DAB/DAB+ 174 ~ 240 MHz
External power adaptor Input: AC 100-240 V, 50/60 Hz Output: DC 6 V / 0.6 A Polarity: Protection Class: II
The right to make technical and design modifications in the course of continuous product development remains reserved.
This device complies with all current CE directives, such as electromagnetic compatibility and low voltage directive and is manufactured according to the latest safety regulations.




www.etv.de Elektro-technische Vertriebsges. mbH
Stand 07/12
Pagine di riferimento in questo manuale: produttore, supporto e download.
Problemi comuni, cause probabili e soluzioni.
| Problema | Possibile causa | Soluzione | |
|---|---|---|---|
| The unit cannot be operated | The unit is blocked and “hangs” | Pull the mains plug for approximately 5 seconds. Then con- nect the unit again | p.4 |
| No DAB Ra- dio reception | Telescopic antenna incorrectly aligned | Fully extend the telescopic antenna and align it vertically. | p.4 |
| No DAB Ra- dio reception | No Digital Radio can be received in your area | p.4 | |
| Problems with DAB radio reception | Depending on the location, you may not be able to receive some stations at all or with interference in your region. see also note on page 22 | Switch to FM mode to receive these sta- tions. If these stations are transmitted via UKW. Find out more on the internet site of the radio station. | p.5 |
| No sound | Volume is too low | Increase the volume | p.5 |
| Poor sound quality | Radio signal too weak | Try to adjust the antenna position. | p.5 |
| Poor sound quality | Batteries too weak | Insert new batteries or operate the de- vice with the mains cable. | p.5 |
I possessori del prodotto e il nostro team di solito rispondono entro 24 ore, e la tua domanda sarà utile anche ad altri.
Invia la prima domanda: risponderanno altri possessori o il nostro team.