Manuale d’uso / di manutenzione del prodotto 10052700 del fabbricante Windsor
Vai alla pagina of 24
86221970 PRV NO 980282 H AUTOMATIC SCRUBBER MODELS: SCC172 QSCC172 SCH172 10066320 10066300 10066350 SCHC172 HCC172 QSCC172IA 10066330 10066270 10066310 QSCC172IS AS17 AS17B 10066080 10066210 10066220.
MACHINE DATA LOG/OVERVIEW 86221970 17” SCRUBBER 01/03/07 2 OVERVIEW The Automatic Scrubber is a battery powered, hard floor scrubber intended for commercial use. The appliance applies a cleaning solution o nto a hard floor, scrubs the floor with a brush or pad, and then vacuums the soiled water back into the recovery tank.
TABLE OF CONTENTS 86221970 17” SCRUBBER 01/03/07 3 Machine Data Log/ Overview . ............................... 2 Table of Co ntents ................................................. 3 HOW TO USE THIS MANUAL How to use this Manual. .................
HOW TO USE THIS MANUAL 86221970 17” SCRUBBER 01/03/07 1-1 This manual contains the f ollowin g sections: - HOW TO USE THIS MANUAL - SAFETY - OPERATIONS - MAINTENANCE - PARTS LIST The HOW TO USE THIS MANUAL section will tell you how to find important information for ordering correct repair parts.
86221970 17” SCRUBBER 01/03/07 2-1 IMPORTANT SAFETY INSTRUCTIONS When using a battery powered appliance, basic precaution must always be followed, including the following: READ ALL INSTRUCTIONS BEFO RE USING THIS MACHINE. To reduce the risk of fire, electric sho ck, or injury : Use only indoors.
HAZARD INTENSITY LEVEL 86221970 17” SCRUBBER 01/03/07 2-2 The following symbols are used throughout this guide as indicated in the ir descriptions: HAZARD INTENSITY LEVEL There are three levels of hazard intensity identified by signal words - WARNING and CAUTION and FOR SAFETY.
SAFETY LABEL LOCATION 86221970 17” SCRUBBER 01/24/07 2-3 NOTE: These drawings indicate the location of safet y labels on the machine . If at any time the labels become illegible, promptly replace them. OR FIRE. DO NOT USE OR MATERIALS CA N CAUSE EXPLOSI ON FLAMMABLE MATERI AL.
TECHNICAL SPECIFICATIONS 86221970 17” SCRUBBER 01/03/07 3-1 ITEM DIMENSION/CAPACITY Rated Voltage 24 VDC Rated Amperage 30 Amps Batteries 2 x 12 Volt 105-130 AH Scrub Brush Motor 0.75hp (0.56 kw) Vacuum Motor 24 VDC 2 stage by pass Mass (GVW) 319 lbs (144.
TECHNICAL SPECIFICATIONS 86221970 17” SCRUBBER 01/03/07 3-2 ITEM MEASURE Height 35 in (0.89 m) Length 42 in (1.07 m) Width without squeege e 20 in (0.51 m) Width of squeegee 31 in (0.79 m) Width of scrub path 17 in (0.43 m) SPECIAL NOTES: The A-weighted sound pressure level em itted by the appliance was measu red t o be 74.
HOW THIS MACHINE WORKS 86221970 17” SCRUBBER 01/03/07 3-3 This Automatic Scrubber is a battery powered, hard floor scrubber intended for commercial use. The appliance applies a clea ning solution onto a hard floor, scrubs the floor with a bru sh, and t hen vacuums the soiled water back into the recovery tank.
COMPONENTS 86221970 17” SCRUBBER 01/03/07 3-4 14 13 12 11 10 9 8 7 6 5 4 3 2 1 1. Control Panel 2. Control Handle 3. Recovery Tank 4. Recovery Tank Drain Hose 5. Recovery Tank Domel 6. Scrub Brush/Pad 7. Solution Tank 8. Solution Tank Cover 9. Solution Tank Drain Hose 10.
CONTROLS 86221970 17” SCRUBBER 01/03/07 3-5 1. Solution Control Lev er 2. Brush Switch 3. Brush Lift Pedal 4. Vacuum Switch 5. Squeegee Lift Lever 6.
CONTROLS 86221970 17” SCRUBBER 01/03/07 3-6 1. SOLUTION CONTROL LEVER Controls solution flow to scrub deck. To increase flow push the kno b forward to the desired flow. To decrease flow pull the knob back. 2. BRUSH SWITCH Controls the scrub brush motor.
MACHINE OPERATIONS 86221970 17” SCRUBBER 01/03/07 3-7 PRE-RUN MACH IN E INSPECTION Do a pre-run inspection to find possi ble problems that could cause poor perf ormance or lost time from breakdown. Follow the same pro cedure each time to avoid missing steps.
MACHINE OPERATION 86221970 17” SCRUBBER 01/03/07 3-8 TO BEGIN SCRUBBING When operating the machine around people, pay close attention for unexpecte d movement. Use extra caution around children. Flammable liquids and/or reactive metals can cause explosions or fire! Do not pick up.
MAINTENANCE 86221970 17” SCRUBBER 01/03/07 4-1 BATTERIES (WET CELL BATTERIES ONLY) The batteries provide the power to ope rate the machine. The batteries require regul ar maintenance to keep them operating at peak efficiency.
MAINTENANCE 86221970 17” SCRUBBER 01/03/07 4-2 CHECKING BAT TERY SPECIFIC GRAVITY Use a hydrometer to chec k the battery specific gravity. CHECKING GRAVITY A. Hydrometer B. Battery NOTE: Do not take readings immediately after adding distilled water, if the water and acid are not thoroughly mixed, the readi ng m ay not be accurate.
MAINTENANCE 86221970 17” SCRUBBER 01/03/07 4-3 MACHINES WITHOUT ON BOARD CHARGER Use a 24 volt, 12 amp maximum output, DC charger which will automatically shut off when the batteries are fully charged to charge the two battery pack. 1. Stop the machine in a clean, well ventilated area next to the charger.
MAINTENANCE 86221970 17” SCRUBBER 01/03/07 4-4 SCRUB BRUSHES NOTE: All original equipment brushes a re equi pped with “Perform Alert © ”. This feature will tell the operator when it is time to replace the scrub brush. “Perform Alert © ” brush es have pre-trimm ed bright yellow tufts to indicate the length of a worn out brush.
MAINTENANCE 86221970 17” SCRUBBER 01/03/07 4-5 REPLACING OR REMOVING SCRUB BRUSHES 1. Turn the machine off. FOR SAFETY: Before leavi ng or serv icing the machine; stop on level surfac e, turn OFF machine. 2. Raise the scrub deck up by pushin g down on the pedal.
MAINTENANCE 86221970 17” SCRUBBER 01/03/07 4-6 SERVICE SCHEDULE MAINTENANCE DAILY WEEKLY MONTHLY ANNUALLY Check battery acid level * Check vac hose connections * Clean the squeegee blades * Inspect .
TROUBLESHOOTING 86221970 17” SCRUBBER 01/03/07 4-7 PROBLEM CAUSE SOLUTION Poor or no water pick-up Debris caught on sque egee Remove debris Worn squeegee blades Repl ace squeegee blade s Vacuum hose.
TROUBLESHOOTING 86221970 17” SCRUBBE R 01/03/07 4-8 PROBLEM CAUSE SOLUTION Little or no solution flow to the floor Solution tank empty Fill solution tank Solution flow turned off or set too low Turn.
NOTES: 86221970 17” SCRUBBER 01/03/07 4-9.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Windsor 10052700 è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Windsor 10052700 - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Windsor 10052700 imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Windsor 10052700 ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Windsor 10052700, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Windsor 10052700.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Windsor 10052700. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Windsor 10052700 insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
