Manuale d’uso / di manutenzione del prodotto RS576PXP del fabbricante Whirlpool
Vai alla pagina of 24
d304NCH SLIDE-IN ELECTRIC RANGE WITH CONVERTIBLE COOKTOP Model RS576PXP -Oven Vent Y Plug-In Surface Unlts / Heat Deflector Cooktop Module Reflector Bow Control Panel Model and Serial Number Plate Automatic Oven Front Frame FIberglass Uen,C.
Your responsibilMzs. l l Proper Installation and safe use of the range are your personal responslbilltles. Read this “Use and Care Guide” and the “Cooking Gulde”carefully for important use and safety information. Installation You must be sure your range is.
I . FOR YOUR SAFETY l I DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS AND LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE. I.
Using your range Oven Selector / Manual Oven Light Switch / / / Adjustable Oven Oven Signal Light Clean Light Lock Light l Left Coo top Module Temperature Control Signal Light SETTING THE CLOCK Push in and turn the Minute Timer Knob to set the Clock. 1.
Surface Unlt Minute Timer Control Knob I Stop Time Knob Right Cooktop Module Signal Light SurGce UnItI Cooktop Module lndlcator Start Ti&e Knob THE UVEN CONTROLS The oven is controlled by two knobs: the Oven Selector and the Oven Tempera- ture Control.
BAKING OR ROASTING Put the rack(s] where you want them before turning on the oven. Rack(s) should be placed so food can be centered in the oven. Always leave at least 1 1 2 to 2 inches (4-5 cm) between the sides of the pan and the oven walls and pans.
1. Place the rack where you 2. Put the broiler pan and want it for broiling. food on the rack. 4. Set the Oven Temperature 5. During broiling, the oven Control on BROIL (or on a door must be partly lower temperature for open. A built-in stop will slower broiling).
USING THE AUIOMAnC MEALTIMER* CLOCK The Automatic MEALTIMER Clock is designed to turn the oven on and off at times you set...even when you are not around. IMPORTANT: follow these steps In order. To start and stop baklng automatically: 1. Put the racks where you 2.
If the steps for using the Automatic MEALTIMER’ Clock are not followed in order, the electric oven door lock may be turned on. The door will then either: 0 not open; l not close all the way [the oven light stays on]. If the Door Won’t Open: 1. Make sure the Clock and Start and Stop Times are set to the right time of day.
SURFACE UNIT CONTROLS Uni Ill you get used to the settings, use the followlng as a gulde. , Control knob y-L be pushed In b t turnlng them to a set- ting. They can be set anvwhere between HI an6 OFF. PUSH IN. Turn to setting. The slgnal light will glow when a surface unlt Is on.
CHANGING COOKTOP MODULES The Cooktop Modules will work on either side of the cooktop. Make sure all controls are OFF and modules are cool before removlng them. SURFACE UNIT MODULES 1. To remove, lift slightly by the handle. 4. Replace in reverse order.
USING THE COOKIOP MODULES OPTIONAL GRIDDLE , Before using the griddle for the first time: 1. Wash, rinse and dry griddle. l Use warm sudsy water. l DO NOT immerse griddle. l DO NOT use metal scouring pads or abrasive cleansers. They will damage griddle.
GRILL MODULE A range hood (Whirlpool Model No’sRH8330 or RH8336) should be used to help get rid of smoke while using the Grill Module. Approximate Grill Module Cooklng Tlmes Preheat grill for five minutes at suggested setting.
OPTIONAL ROTISSERIE Rotlrrerle Parts The Rotisserie has 4 parts. It IS used with the Grill Module. 1. Remove the grills from the Grill Module. 2. Insert rear sup- port tabs into slots at rear of the Grill Module. 3. Slide forward to lock. Tilt top to level.
Approximate rotlsserle cooklng tlmes: Internal Control Spit Food Temperature Weight Setting(s) POSItIOn Time Comments Beet Rolled rib 140 F 3121bs Hi High 1 hr. Meat with an (rare) (60 Cl II.5 kg) 55 min. outer layer of fat Rolled rump 140 F 3141bs. Hi High 2 hr.
Cleaning and caring for your range CONTROL PANEL AND KNOBS 1. Flrst make sure knobs are set on OFF then pull knob stralght otf. 2. Use warm soapy water and a soft cloth to wipe the panel. Rinse and wipe dry 3. Wash knobs In warm soapy water Rinse well and 4.
Terminal 3. Hold the surface unit as level as possible with the terminal just started into the 4. While pushing the surface unit terminal into the receptacle, lift a little on the edge of the unit nearest the receptacle. 5. When the terminal is pushed into the re- ceptacle as far as it will go, the surface unit will fit into the reflector bowl.
SPECIAL TIPS 4. Keep the kitchen well 2. Clean the oven before 3. If the cleaning cycle ventilated durrng the It gets heavrly soiled doesn’t get the oven as cleanrng cycle to help Cleonrng a very so.
4. Set the Oven Temper- ature Control to CLEAN. 7. Turn the Oven Temper- ature Control to OFF. 5. The Lock Light comes on when the oven gets above normal baking temperatures. The door can’t be unlocked when the Lock Light is on. 6. When the Lock Light goes off, turn the Oven Selector to OFF.
CLEANING CHART PART WHAT TO USE HOW TO CLEAN Surface Units Do not clean l Sol1 burns off. l Do not Immerse Griddle Module and Cover Warm soapy water l Do not Immerse grlddle. l Wash, rinse and dry well. l Do not use metol scouring pads or harsh cleansers l Use olastlc scourlna ood If needed.
STORAGE DRAWER The storage drawer is for storing pots and pans. Never store anything that can burn or melt in the drawer. 1. Pull drawer straight out to 2. Lift front and pull out to 3. Lift back slightly and the first stop. the second stop. slide drawer all the way out.
If the Self-Cleanlng cycle will not operate: l Are the Oven Selector and the Oven Tem- perature Control set to “CLEAN?” l Does the Start Time Dial show the correct time of day? l Is the Stop Time .
THIS PAGE INTENTIONALLY LEFT BLANK.
FSP quality parts. Look lor thk symbol of quallty whenever you need a replacement part ’ for your Whirlpool appliance. FSP replacement parts will fit right and work right. because they are made to the same exacting speclftcatiorw used to build every new Whirlpool appliance.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Whirlpool RS576PXP è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Whirlpool RS576PXP - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Whirlpool RS576PXP imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Whirlpool RS576PXP ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Whirlpool RS576PXP, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Whirlpool RS576PXP.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Whirlpool RS576PXP. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Whirlpool RS576PXP insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
