Manuale d’uso / di manutenzione del prodotto SHRL 33/40 DV INS del fabbricante Lennox Hearth
Vai alla pagina of 42
D R A F T 3 / 2 9 / 2 0 10 INST ALLER: Leave this manual with the appliance. CONSUMER: Retain this manual for future reference. INST ALLA TEUR : Laissez cette notice avec l'appareil. CONSOMMA TEUR : Conservez cette notice pour consul- tation ultérieure.
2 CO N GR A TUL A TIO N S! When you purchased your new gas fireplace insert, you joined the ranks o f t housa nds of indi vidual s whose answer to their home heating needs reflects their concern for aesthetics, efficiency and our environment.
3 IM POR T AN T SA FET Y AN D W A RN IN G IN FOR MA TI ON W ARNING Y oung chil dren shou ld be carefull y supervised when they are in the same room as the appliance. T od- dlers, young childr en and others may be susce ptibl e to accidental contact burns.
4 FOR YOUR SAFETY do not insta ll or oper ate this appl ianc e witho ut first reading and understanding this manual. Any installation or operation of the appliance deviating from that which is stated in this manual WILL void the warranty and may be hazardous.
5 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE Millivolt Models with Manually-Modulated Gas Valves Natural Gas Propane (LP) Gas Model Input Rate (BTU/HR) Input Rate (BTU/HR) SHR33 19,500 to 33,0.
6 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE CODES AND APPROV ALS Listing and Safety Standards - Gas appliances must be tested and certi- fied by a nationally recognized testing and certification laborator y to ANSI (American National Standard Institute) gas appliance safety standards.
7 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE NEW YORK CITY , NEW YORK (MEA) (NYC MEA Approval #138-07-E) Installation of these appliances are approved for installation in New Y ork City in the US state of New Y ork.
8 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE Figure 1 Front View Side View T op View Insert Dimensions Inches (millimeters) A Left front of unit to center line 13-1/8 (333) B Right front of un.
NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE Figure 2 - Existing Fireplace Minimum Dimensions Minimum Fireplace Dimensions and Minimum Clearances Inches (millimeters) A Minimum front opening req.
10 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE W ARNING THIS FIREPLACE HAS BEEN AL TERED TO ACCOMMODA TE A FIREPLACE INSERT AND SHOULD BE INSPECTED BY A QUALIFIED PERSON PRIOR TO RE-USE AS A CONVENTIONAL FIREPLACE.
11 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE Venting Requirements Approved Vent Systems: Len nox He art h P rod uct s Co- lin ear Ch im ney Li ner Ki t R eco mme nde d: • The Flex Kit, Cat. No. H0909 includes one 35 feet flex liner and four gear clamps.
12 Vertical V enting The combustion air intake pipe can be connected to the termination cap (see Figure 6b ) or it can terminate inside the chimney (see Figure 6a ) .
13 T ools Needed: 5/32” Allen Wrench or T -Handle Cat. No. Description H5746 Shoreline Door Assembly (Figure 9) 1. Locate the three bottom tabs on the bottom of the door . These tabs on the bottom of the door will insert in the slots along the bottom of the insert.
14 4. Slide the top panel in place with the detailed side down. Make sure panel is positioned all way back and resting on side panels. T op panel should be flush in front with the side panels. See Figure 18 . 3. Position and slide the side panels against the rear panel.
15 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE A C D E F B G A Lo g su p p or ts A B C D E T o Install Log Set: 1. Open the box and carefully remove and identify the different items. Start with the rear log (A). Set it down on the log supports located on the left rear of firebox.
16 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE 2. Separate the glowing embers (F) into quarter size pieces and place along ports on burner pan. DO NOT cover burner secondar y holes on burner pan. The pattern for the glowing embers should be similar to what is shown in Figure 22 .
17 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE 2 Slide the insert into its final location in the fireplace. In case of uneven wall sur face open the right surround access door and make any adjustments needed to ensure there is enough clearance to open the access door (see Page 18 ).
18 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE T ools Needed: 7/16” wrench Adjustment Procedure: Step 1 Open the surround access door . Inspect the tension or lack of tension while opening the door to determine if it should open easier or tighter .
19 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE W e r e co mm en d t ha t a qu a li fied i n di vi du al su c h as a pl um be r or g a s fit t er b e us ed to cor rec tly siz e an d ro ute the gas sup ply lin e to the app lia nce .
20 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE La chimenea caliente cau- sará quemaduras graves Nunca permita que los niños toquen el vidrio ni otras partes de la chimenea ADVERTENCIA Un foye.
21 Lighting Instructions STOP! Read the safety information on the front cover of the manual before proceeding. 1. Op en the rig ht sid e acce ss do or . Ens ur e th e gas supp ly shu t- of f cock s are op en a nd O N/ OF F Roc ke r Swi tc h is “OFF ”.
22 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE T o T urn Off Gas T o Appliance 1. T urn of f t he “ON /OF F” roc ker sw itc h a nd/ or the rmo st at (if in sta lle d). 2. T urn of f e lec tri c p owe r t o t he app lia nce if se rvic e i s t o b e p erfor med .
23 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE Flame Appearance and Sooting Y our Shoreline™ fireplace insert is designed for maximum heating efficiency . Therefore, upon lighting of the main burner the flames will be semi-transparent or “bluish.
24 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE CAUTION: Label all wires prior to disconnection when servic- ing controls. Wiring errors can cause improper and dangerous operation. A TTENTION: Au moment de l'entretien des commandes, étiquetez tous les fils avant de les débrancher .
25 Shoreline™ Main Burner Operation Y our Shoreline fireplace insert comes with an “ON/OFF” rocker switch used to turn the burner on and off while the pilot is on. The rocker switch is located in the con trol panel abo ve the blower rheo stat switch and to the left of the igniter .
26 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE CAUTION: Wear gloves and safety glasses for protection while doing required maintenance. Verify proper operation after servicing. S'assurer que l'appareil fonctionne adéquatement une fois l'entretien terminé.
NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE Glass Door Only doors certified with the appliance shall be used. Seules des portes certifiées pour cet appareil doivent être utilisées. CAUTION: DO NOT abuse glass door by striking or slamming shut.
28 MAINTENANCE T ASK ACCOMPLISHING PERSON PROCEDURE Inspecting/Cleaning Burner , Logs and Controls Qualified Service T echnician Inspect valve and ensure it is properly operating. Check piping for leaks. Vacuum the control compartment, fireplace logs and burner area.
29 NOTE: When troubleshooting the gas control system, be sure the external gas shut off valve, located at the gas supply inlet is in the “ON” position. IMPORT ANT : Call your gas supplier or plumber for additional help with any gas control problem.
30 Item # Part/Cat. No. Description 2 H5723 Air Intake Assembly 3 H5724 Blower Box Assembly w/blower 4 H5725 Flue Collar Assembly 5 H5726 Blower Snap Switch Assembly 6 H5727 Rear Leveling Leg Assembly.
31 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE 23 24 24 30 23 3 4 5 26 25 27 2 30 P AR T IDENTIFICA TION Item # Description 2 Air Intake Assembly 3 Blower Box Assembly 4 Flue Collar Assembly 5 .
32 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE Item # Description 8 Burner Assembly 9 Pilot Assembly w/Shield 10 Main Orifice 11 Bulkhead Assembly 12 Cassette Plate Assembly 13 Valve Assembly .
33 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE 8 P AR T IDENTIFICA TION Item # Description 2 Air Intake Assembly 3 Blower Box Assembly w/Blower 6 Rear Leveling Leg Assembly 7 Outer Bottom Assem.
34 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE P AR T IDENTIFICA TION 22 Ceramic Log Set Item # Description 8 Burner Assembly 16 Louver Assembly 17 Blower Rheostat 18 Control Panel/Valve Cover .
35 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE P AR T IDENTIFICA TION 4-Piece Surround Assembly 3-Piece Surround Assembly Item # Description 31 Surround Flange Hinge 32 Bal l Sc re w Ass em bl .
36 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE OPTIONAL ACCESSORIES Standard Remote Control System The Model RCL (Standard) Remote Control System, features a simple On/Off control function for the insert.
37 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE Refractory Brick Panel Set (5 pieces) These decorative brick panels sets are offered in 3 attractive styles. One set required. Surround Kits These surround panels install around the insert body providing an attractive finished look.
38 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE OPTIONAL ACCESSORIES V e n t K i t s C a t . N o . M o de l D e s c ri p t io n H0909 FKDVI Flex Liner Kit, DVI 3” X 35’ (requires 2, one for .
39 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE SAFETY / LISTING LABEL MINIMUM CLEARANCES TO COMBUSTIBLES - SHR40/SHR33 E = T op Facing to Bottom of Insert 35” F = Center of Fireplace to Side .
40 NOTE: DIAGRAMS AND ILLUSTRA TIONS ARE NOT TO SCALE LIGHTING INSTRUCTIONS LABEL FOR YOUR SAFETY READ BEFORE OPERA TING 1. To turn off the burner , switch the rocker switch to “OFF” or adjust the thermostat to a setting below room temperature (if installed).
41 NOTES.
Printed in U.S.A. © Lennox Hearth Products 2007 P/N 850,050M REV . D 03/2010 Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Lennox Hearth SHRL 33/40 DV INS è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Lennox Hearth SHRL 33/40 DV INS - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Lennox Hearth SHRL 33/40 DV INS imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Lennox Hearth SHRL 33/40 DV INS ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Lennox Hearth SHRL 33/40 DV INS, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Lennox Hearth SHRL 33/40 DV INS.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Lennox Hearth SHRL 33/40 DV INS. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Lennox Hearth SHRL 33/40 DV INS insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
