Manuale d’uso / di manutenzione del prodotto 4300 del fabbricante Hustler Turf
Vai alla pagina of 45
4200/4300/4400 4420/4500/4600 Hustler T ractor Owner’ s Manual ••••••• Hustler Turf Equipment ••••• P.O. Box 7000 ••• Hesston, Kansas • 67062-2097 728444 Rev.
The engine e xhaust from this product contains chemicals known to the State of Calif or nia to cause cancer , bir th def ects or other reproductiv e har m.
728444 Rev. 11/02 T ABLE OF CONTENTS 1. General Information .............................................................Sect. 1 2. Safety Precautions ................................................................Sect. 2 3. Operation ...............
.
728444 Rev. 11/02 1-1 This manual applies to the following equipment: 4200 Hustler tractor, number 924621 4300 Hustler tractor, number 924647 4400 Hustler tractor, number 924639 4500 Hustler tractor, .
728444 Rev. 11/02 1-2 Hustler T urf Equipment TWO YEAR LIMITED W ARRANTY FOR TRA CTORS AND PO WER UNITS WHAT IS COVERED BY THIS WARRANTY Hustler Turf Equipment, makes the following warranty to the original purchaser only: a .
728444 Rev. 11/02 operational instructions provided by Hustler Turf Equipment. ● Normal maintenance parts and service including, but not limited to, filters, fuel, lubricants, tune-up parts, belts, .
728444 Rev. 11/02.
728444 Rev. 11/02 2-1 This safety alert symbol is used to call attention to a message intended to provide a reasonable degree of PERSONAL SAFETY for operators and other persons during the normal operation and servicing of this equipment. DANGER – denotes immediate hazards which will result in severe personal injury or death.
• Do not operate where the machine could slip or tip. • Install a ROPS and seat belt on the tractor when operating on slopes. ▲ The Hustler mower is capable of operating horizontally (traverse) on moderately steep slopes.
Never operate the mower deck with side deflector removed or in raised position, except when the grass catcher attachment is being used. 728444 Rev. 11/02 Avoid skin contact with battery acid. Always wear eye protection when checking the battery, acid can cause serious injury to skin and eyes.
.
728444 Rev. 11/02 3-1 Contr ols For general location of the controls described in this section, refer to Figure 3-1. 1. Ignition switch (Fig. 3-2) – Models 4200,4400, 4420 and 4600.
4 . Electric PTO clutch switch (Fig. 3-2) – a two- position switch which controls the electric clutch on the PTO shaft. Down position is OFF and up position is ON. When clutch switch is on, the PTO shaft rotates and delivers live power to attachment requiring it.
attachment and is described in more detail in the operating instructions provided with the attachment. Instrumentation 11. Electronic hour meter (Fig. 3-5) – registers 1/10 hour increments up to 9,999.9 total hours. Connected to the ignition switch, the meter records the accumulative time while the ignition key is switched to the ON position.
2. Engage safety start interlock system, buckle seat belt if tractor has seat belt. 3. Set parking brake. 4. Set throttle at approximately 1/3 OPEN position.
Mo ving tractor with stalled engine Should it become necessary to transport the tractor because the engine stalls and cannot be restarted: 1. The hydraulic pump is equipped with tow valves. Before towing the tractor, turn the tow valves counterclockwise four complete revolutions, using a 5/16” allen wrench.
WARNING: Never drive the tractor at high speeds without a front end attachment mounted to the tool bars or with the attachment in a raised position. After starting engine, release parking brake (if se.
728444 Rev. 11/02 4-1 A large variety of attachments are specifically designed for your Hustler tractor to handle most ground maintenance chores. These mount directly on the tractor in various ways, and each is provided with individual Assembly Instructions, Parts Manual, and Owner’s Manual which includes operation and maintenance information.
.
728444 Rev. 11/02 5-1 •– Refer to break-in services for initial change. + – More often under dusty or dirty conditions and during hot weather. X – Torque after first 50 hours also. Y – Torque after first 2 hours of operation. XX – Check monthly or every 200 hours, whichever comes first.
Remain alert for unusual noises, they could be signaling a problem. Visually inspect the machine for any abnormal wear or damage. A good time to detect potential problems is while performing scheduled maintenance service. Correcting the problem as quickly as possible is the best insurance.
Steering Lever Neutral Adjustment with Turnbuckle Fine adjustment to the steering is made with the turnbuckle on the front end of the steering control lever linkage. Additional adjustment is available if necessary at the rear linkage straps near the pump.
728444 Rev. 11/02 5-4 Electrical Diagram • Models 4200 & 4400.
728444 Rev. 11/02 5-5 Electrical Diagram • Models 4200 & 4400.
728444 Rev. 11/02 5-6 Electrical Diagram • Models 4300 & 4500.
728444 Rev. 11/02 5-7 Electrical Diagram • Models 4300 & 4500.
728444 Rev. 11/02 5-8 Electrical Diagram • Models 4420 & 4600.
728444 Rev. 11/02 5-9 Electrical Diagram • Models 4420 & 4600.
connecting link to the rear pump steering linkage. Fig. 5-3 The unit is now ready to operate. T-Bar rotational resistance adjustment On units with serial numbers prior to and including 11374 (last five digits) Purpose of this spring and connecting link assembly (Fig.
storing and charging specifications. Common circuit failures are usually caused by shorting, corroded or dirty terminals; loose connections, defective wire insulation or broken wires. Switches, solenoids and ignition components may also fail, causing a shorted or open circuit.
The engine hood at rear is hinged. To raise it, unfasten the two latches and tilt hood up and forward. A hood support rod is stored clipped to the bottom side.
open flame or spark and store machine away from open flame or spark if there is fuel in the tank. Read and observe safety precautions at front of this manual. The 11 U.S. gallon (41.6 liter) fuel tank is located in the tractor’s right fender. It is equipped with a gauge built into the filler cap.
3. Damaged filter, seals or canister. 4. Incorrect air filter element size. 5. Use of poorly designed aftermarket air filter elements. Air cleaner servicing is an inexpensive maintenance check that can prevent costly non-warrantable premature engine damage.
2. Service elements only when restriction indicator shows red. Check restriction indicator daily or more frequently if operating in dusty conditions. 3.
Belt replacement Inspect the pump drive belts frequently for wear and serviceability. Replace a belt that shows signs of severe cuts, tears, separation, weather checking and cracking, or burns caused by slipping. Slight raveling of belt covering does not indicate failure, trim ravelings with a sharp knife.
728444 Rev. 11/02 6-1 The majority of operating problems that occur with a system can be traced to improper adjustments or delayed service. A consistently applied preventive maintenance program, as outlined in the maintenance section of this manual, will prevent many problems.
.
728444 Rev. 11/02 7-1 End of season tractor care When storing tractor at end of mowing season, the following steps should be taken to ensure readiness for the next mowing season. 1. Remove all grass, dirt, and trash from tractor. 2. If touchup is required order Hustler spray paint (13 oz.
.
728444 Rev. 11/02 8-1 This section contains sources of additional literature concerning your tractor. Literature should be ordered from your Hustler dealer, or direct from indicated source. NOTE: For parts information on your tractor, refer to the Hustler 4200/4300/4400/4420/4500/4600 Parts Manual (Hustler P/N 728436).
For more information: TRW Ross Gear Division 800 Heath Street Lafayette, Indiana 47902 Phone: 317-423-5377 Telex: 279413 NOTE: During warranty period, check with Hustler dealer before attempting repairs on any tractor system. Unauthorized repair work can void warranty of tractor, engine, and other components.
728444 Rev. 11/02 9-1 Hustler 4200 specifications Engine Make – Kubota Model – D950-B-26 Type – Three cylinder, in-line, 4-cycle diesel, liquid cooled. Displacement – 56.6 cu. in. (927 cc) Horsepower – 21.5 hp (16 KW) mfg. rating @ 3000 RPM Maximum Torque – 41 ft.
Operating RPM – 3000 (max. load), 3200 (no load) Starter – 12-volt Ford, external solenoid. Charging System – 12-volt, negative ground, 55 amp, belt driven alternator. Crankcase Capacity – 3.5 U.S. qts. (3.25 l) with filter change. Fuel – Unleaded gasoline.
728444 Rev. 11/02 10-1 INDEX PAGE Access to engine and hydraulic pumps...........................5-11 Auxiliary hydraulics .........................................................4-1 Belt replacement ..................................................
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Hustler Turf 4300 è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Hustler Turf 4300 - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Hustler Turf 4300 imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Hustler Turf 4300 ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Hustler Turf 4300, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Hustler Turf 4300.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Hustler Turf 4300. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Hustler Turf 4300 insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
