Manuale d’uso / di manutenzione del prodotto Wind Tunnel vacuum cleaner del fabbricante Hoover
Vai alla pagina of 32
Self-Pr opelled WindT unnel ™ with Power ed Hand T ool by HOOVER ® ® This WindT unnel ™ vacuum cleaner takes HOOVER ® T ype “Y” Allergen Filtration filter bags This pr oduct was designed fo.
Fill in and r etain The model and serial number are located on the back of the handle as shown. For your personal records, please enter the COMPLETE model and serial number in the spaces provided and retain this information.
3 1. Assembling cleaner Car ton contents Remove all parts from carton and identify each item shown. Make sure all parts are located before disposing of packing. A. Handle screws (in bag with owner’ s manual) B. Hose, cleaning tools and wands C. Handle D.
Open tool cover . The powered hand tool is shipped in a plastic bag for protection. Remove tool from storage ar ea and discard bag. Reposition tool and close tool cover . Place smaller diameter end of wand, into bottom of rack. Snap wand into clip at the top.
13. Carpet height control: slide knob to correct setting for height of carpet being cleaned. 14. Headlight 15. ‘Dirt FINDER’ display* 16. Embedded ‘Dirt FINDER ’ sensitivity switch* 17. Check bag indicator 18. Bag door 19. Cord hooks: wrap cord around hooks for storage.
BRUSH ROLL CARPET HARD ON OFF 2-9 Br ush r oll control Note: When handle is in upright position, brush roll is automatically OFF . Move the brush roll contr ol only when the handle is in the upright position. Slide control to “Carpet” to turn brush roll ON for cleaning carpet or rugs.
7 Automatic brush r oll indicator (some models only) When red is in the OFF window , brush roll is STOPPED. When red is in the ON window brush r oll is ROT A TING. AUTOMATIC BRUSH ROLL ON OFF 2-10 2-11 2-12 2-13 Cleaning lightweight flexible rugs Stand on one end of rug and move cleaner toward other end or edge.
8 2-19 K Check bag indicator (some models only) The indicator (K) will begin to show red as the filter bag fills with dirt. There ar e three conditions that will cause the indicator to become completely red: 1. If the bag is full; change the bag. 2. If very fine materials have been picked up, clogging the bag pores; change the bag.
Replacing final filter The final filter assists in the filtration process to r eturn clean air to the room. The pleated filter will become dirty and needs to be replaced about once a year to maintain efficient filtration. The 3 layer filter (some models) can be washed in the same manner as the secondary filter and reused.
3-12 3-11 D C 3-9 3-10 Belt r eplacement The belts are located under the bottom plate of the cleaner and should be checked from time to time to be sur e they are in good condition. The flat (wide) belt is described below; the other is described under “Brush roll replacement”.
Installing brush roll Grasp brush roll and fit it into position by first sliding end, opposite the belt, into the rectangular slot (G) on side of clean- er . Push other side of brush roll (H) into place. Belt may fit loosely when proper- ly installed.
12 3-22 3-24 3-23 E Power ed hand tool Belt replacement The powered hand tool belt is designed to last a long time and is not normally replaced. However , if the belt is crack- ed, gouged or broken, it should be replaced. 6. With curved ends down, slide end plates (C) of brush roll into slots (E) on tool.
13 Ser vice T o obtain approved HOOVER service and genuine HOOVER parts, locate the nearest Hoover Factory Service Center or Authorized Hoover W arranty Service Dealer (Depot) by: • checking the Y e.
14 4-2 Full One Y ear W arranty (Domestic Use) Y our HOOVER® appliance is warranted in normal household use, in accordance with the Owner’ s Manual against original defects in material and workmanship for a period of one full year from date of purchase.
¡Salvaguar dias impor tantes! Al usar un artefacto eléctrico observe siempre las precauciones básicas, incluyendo la siguientes: LEA T ODA LAS INSTRUCCIONES ANTES DE USAR ESTE ARTEF ACTO Advertencia: Para reducir el riesgo de incendio, choque eléctrico o lesiones: • No use el artefacto a la intemperie o sobre superficies mojadas.
Esta aspiradora fue inspeccionada y empacada cuidadosamente antes de salir de fábrica. En caso de necesitar ayuda durante el ensamble u operación, llame al 1-800-944-9200 para una referencia automática de la ubicación de los cen- tros de servicio autorizados (EE.
Haga funcionar la aspiradora solamente al voltaje especificado en la placa de datos que se encuentra en la parte inferior de la aspiradora. Esta aspiradora está diseñada para uso doméstico. Interr uptor de encender-apagar Enchufe el cordón en la toma de corriente eléctrica.
Mueva hacia atrás la aspiradora para comenzar nuevamente, baje el frente de la aspiradora, y diríjala solamente hacia adelante. Limpieza de las orillas La aspiradora tiene limpiaorillas especiales en ambos costados de la parte delantera para recoger el polvo de la alfombra cerca de los zócalos y muebles.
solamente bolsas de papel originales HOOVER fabricadas por The Hoover Company . Las bolsas de papel HOOVER se identifican por estas marcas comerciales - Cómo cambiar la bolsa Desenchufe la aspiradora de la toma de corriente eléctrica.
Cómo quitar la placa inferior Desenchufe la aspiradora de la toma de corriente. Advertencia: El rodillo de escobillas puede empezar a girar repentinamente. Desenchufe la aspiradora cuando la invierta. Coloque el mango en la posición más baja e invierta la aspiradora de manera que la parte inferior quede vuelta hacia arriba.
Cuando reemplace la corr ea, pida la pieza No. 38528037 de HOOVER . 1. Retire la placa inferior , el protector de la correa y el r odillo de escobillas como se muestra en las figuras 3-19 a 3-21. 2. Sostenga la turbina (E) y jálela con firmeza para sacarla.
Causa posible Solución posible • El rodillo de escobillas está en la posición de apagado (OFF) • Mueva el control del rodillo de escobillas a la posición de encendido (ON) para aspirar alfombr.
Précautions impor tantes ! Lors de l'utilisation d'un appareil électrique, observez toujours les précautions de base, en particulier les suivantes : LISEZ TOUTES LES INSTRUCTIONS A V ANT .
Cet aspirateur a été inspecté et soigneuse- ment emballé avant d’être expédié de l’u- sine. Si vous avez besoin d’aide pendant l’assemblage ou le fonctionnement, veuillez appeler le : Hoover Canada – 1-800-463-3923 (Montréal) Contenu de la caisse Sortez toutes les pièces de la caisse et identifiez chaque article illus- tré.
usage ménager . Commutateur ON- OFF (mar che-arrêt) Branchez la prise dans la prise électrique. Pour mettre l’aspirateur en marche, relever le commutateur .
Guidez chaque côté parallèlement au bord de moquette ou de mobilier . Fixation du capot d’accessoir es Le capot d'accessoires est amovible lorsqu'il est ouvert en grand. Pour le refixer , alignez les charnières du capot avec les fentes du compartiment d’accessoires.
Retirez la porte. Retir ez et installez le sac filtrant Saisissez le collier du sac filtrant (A) et sortez le collier du tube (B). Remarque : Il ne faut pas réutiliser un sac filtrant usagé après l'avoir nettoyé. Jetez tout sac filtrant usagé.
Débranchez l’aspirateur lorsqu’il est retourné. Lorsque les brosses de l'agitateur sont usées, l'agitateur doit être remplacé. Pour vérifier l'état des brosses, déplacez le bord d'une carte en travers de la plaque inférieure tout en tournant l'agitateur .
3951 1004. Mode de remplace- ment Débranchez l'aspirateur de la prise élec- trique. A vertissement – L ’agitateur peut se met- tre en marche brusquement. Débranchez l’aspirateur lorsqu’il est retourné. Déposez la plaque inférieure comme décrit à la figure 3-9.
30 Une aspiration faible peut être due à un colmatage. V oir la procédure suivante pour rechercher les colmatages en contin- uant avec chaque étape jusqu'à identifi- er le colmatage : 1. Inspectez le remplissage du sac filtrant ; changez-le le cas échéant.
31.
HOOVER y son marcas r egistradas HOOVER et sont des marques déposées HOOVER and are r egister ed trademarks R1 3-02 U6430-/32-/35-/46-/60/70-/72-900, U6470-910 Litho USA 56511-B22.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Hoover Wind Tunnel vacuum cleaner è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Hoover Wind Tunnel vacuum cleaner - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Hoover Wind Tunnel vacuum cleaner imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Hoover Wind Tunnel vacuum cleaner ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Hoover Wind Tunnel vacuum cleaner, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Hoover Wind Tunnel vacuum cleaner.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Hoover Wind Tunnel vacuum cleaner. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Hoover Wind Tunnel vacuum cleaner insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
