Manuale d’uso / di manutenzione del prodotto HCFU-28C13 del fabbricante Haier
Vai alla pagina of 24
OPERA TION MANUAL No. 0010571703 CONVERTIBLE TYPE ROOM AIR CONDITIONER AC184ACMAA AU184AFMDA (HCFU-18C13) AC284ACMAA AU284AHMBA (HCFU-28C13) AC424ACMAA AU424AIMAA (HCFU-42CA13).
CONTENTS CAUTIONS .......................................................................... SAFETY PRECAUTIONS ..................................................... FEA TURES AND FUNCTIONS ............................................ NAME OF P AR TS .
CAUTIONS 1 Disposal of the old air conditioner Before disposing an old air conditioner that goes out of use, please make sure it's inoperative and safe. Unplug the air conditioner in order to avoid the risk of child entrapment. It must be noticed that air conditioner system contains refrigerants, which require specialized waste disposal.
CAUTIONS 2 D L K1 When installation in under ceiling, dial switch "K1" in the PC board to "D" position. When installation in floor console, dial switch to "L" position (Brand new unit is in "D" position).For series 18.
3 SAFETY PRECAUTIONS W ARNING! DANGER! CAUTION! Do not attempt to install this air conditioner by yourself. This unit contains no user-serviceable parts. Always consult authorized service personnel for repairs. When moving, consult authorized service personnel for disconnection and installation of the unit.
4 FEA TURES AND FUNCTIONS AUTOMA TIC OPERA TION SLEEP HEA T & COOL TYPE Merely press the ON/OFF button, and the unit will begin automatic operation in any of the Heating, Cooling and Blow modes as appropriate, in accordance with the thermostat setting and the actual temperature of the room.
NAME OF P AR TS 5 Fig.1 Indoor Unit 1 Operating Control Panel (Fig.2) 2 Emergency switch 3 Remote Control Signal Receiver 4 Power Indicator Lamp (Red) 5 OPERA TION Indicator Lamp (Green) 6 TIMER Indicator Lamp (Y ellow) 7 Compressor Run Lamp (Green) 8 Intake Grill (Fig.
INTRODUCTION TO SP ARE P AR TS 6 C Buttons and display of the remote controller . Operation CLOCK MODE SWING Power ON/OFF TEMP F AN SLEEP SET HOUR RESET LOCK TIMER Used for unit start and stop. Used to set auto fan direction. Used to select AUTO run, COOL,DR Y ,HEA T and F AN operation.
INTRODUCTION TO SP ARE P AR TS 7 Hints LO MID HI AUTO AUTO Buttons and display of the remote controller . Operation DR Y COOL AUTO SWING F AN SPEED SLEEP Clock set TIMER ON TIMER OFF LOCK CLOCK TEMP .
8 INST ALLA TION W ARNING ! CAUTION ! Please ask the dealer or specialist to install, never try by the users themselves. After the installation please be sure of the following conditions. Incorrect installation may cause water leaking, shock and fire hazard.
REMOTE CONTROLLER OPERA TION 9 When in use, put the signal transmission head directly to the receiver hole on the indoor unit. The distance between the signal transmission head and the receiver hole should be within 7m without any obstacle as well. Don't throw the controller , prevent it from being damaged.
GUIDE TO OPERA TION 10 F AN operation Remote controller can memorize settings in each operation mode. T o run it next time just select the operation mode and it will start with the previous setting.
1 1 LOCK RESET GUIDE TO OPERA TION AUT O run, COOL,HEA T and DR Y operation Use COOL in summer . Use HEA T in winter . Use DR Y in spring,autumn and in damp climate. (1) Unit start (2) Select operation mode (3) Select temp.setting Press ON/OFF button, unit starts.
12 GUIDE TO OPERA TION C C C C C Press F AN button. For each press, fan speed changes as follows: (4) Fan speed selection Unit runs at the speed displayed on LCD. In HEA T mode, warm air will blow out after a short period of time due to cold-draft prevention function.
LOCK RESET 13 GUIDE TO OPERA TION TIMER operation Hints Set Clock correctly before starting T imer operation(refer to page 7) Y ou can let unit start or stop automatically at following times: Before you wake up in the morning, or get back from outside or after you fall asleep at night.
GUIDE TO OPERA TION 14 LOCK RESET Every time the button is pressed, time increases 10min. If button is kept depressed, time will change quickly . Every time the button is pressed, time decreases 10min. If button is kept depressed, time will change quickly .
GUIDE TO OPERA TION 15 Adjusting up/down air flow direction Up/down direction can be adjusted by using the SWING button on the remote controller . Each time pressing this button, the mode changes in the following sequence. Change to the AIRFLOW mode. Louver moves in upward and downward directions continuously .
GUIDE T O OPERA TION 16 about 6 hrs 1 hr 1 hr increase 1 increase 1 LOCK RESET Press SLEEP button once to make the air conditioner have the previous-set sleep time (first power-on is "1h"), the sleep symbol will appear . Press time button / , you can choose the time in 1~8 hours.
GUIDE T O OPERA TION 17 Remote Control: There is a telecommunication interface for remote control on the control panel of the indoor unit. After the peripheral equipment have been installed in accorda.
18 CLEANING AND CARE CAUTION! Before cleaning the air conditioner ,be sure to turn it off and disconnect the Power Supply Cord. Be sure the Intake Grill is installed securely . When removing and replacing the air filters, be sure not to touch the heat exchanger , as personal injury may result.
19 CLEANING AND CARE CAUTION! Before cleaning the air conditioner ,be sure to turn it off and disconnect the Power Supply Cord. Be sure the Intake Grill is installed securely . When removing and replacing the air filters, be sure not to touch the heat exchanger , as personal injury may result.
20 TROUBLE SHOOTING Followings are not problems Sound of water flowing is not a problem. Sound of cracking is heard. Smell are generated. During operation, white fog or steam comes out from the indoor unit. No outlet air or fan speed can't be changed in dry mode.
21 TROUBLE SHOOTING Before ask for services, please first check your unit against the following. Air conditioner won't start. Poor cooling or heating Is power supply switch turned on? Power supply switch is not set at ON.
22 Operation and Performance *Heating Performance *Microcomputer-contr olled Automatic Defrosting Heat-pump air conditioners heat your entire room by recirculating air throughout the room, with the result that some time may be required after first starting the air conditioner until the room is heated.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Haier HCFU-28C13 è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Haier HCFU-28C13 - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Haier HCFU-28C13 imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Haier HCFU-28C13 ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Haier HCFU-28C13, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Haier HCFU-28C13.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Haier HCFU-28C13. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Haier HCFU-28C13 insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
