Manuale d’uso / di manutenzione del prodotto 7191 061 del fabbricante Foster
Vai alla pagina of 20
Foster spa via M.S. Ottone, 18/20 42041 Brescello (RE) - Italy tel. +39.0522.687425 - tel. Servizio Assistenza +39.0522.684450 fax +39.0522.686019 - fax Servizio Ricambi +39.0522.962166 e-mail: service@fosterspa.com www .fosterspa.com USER'S MANUAL FOR BUILT-IN OVEN KS 60 gas, c od.
A A A A 1.
EN The s ymbol on the pr oduct or on its packag ing in dic ates th at this pro duct m ay not b e treat ed as hous eh old w aste. Instead it sh all be han ded over t o the ap plic abl e collect ion p oint f or th e recycli ng of electric al and el ectron ic equipmen t.
.
6* $ .
INSTALLATION ATTENTION: This appliance can be installed and operated only in rooms that are continuously ventilated according to UNI 7129/UNI 7131. IMPORTANT: The installation must be carried out by professionally qualified personnel following the manufacturer' s instructions.
Installation room For proper operation of the gas appliance, it is essential that the room has a natural air flow from openings on the external walls providing sufficient air for combustion of the gas. These openings must have a free air - flow cross - section of at least 100 cm² (it is possible to make one or more openings).
.
CONNECTION TO THE GAS SUPPLY The supply system must be compliant with the current local standards in the country of use. The type of gas for which the oven has been regulated is indicated on the serial number plate located on one of the side edges of the cavity (visible with the door open) and on the packaging.
Adaptation to the gas in use Other types of gas can be used by changing the burner s etting as follows: 1) Make sure that the oven is not connected to the electrical mains. 2) Open the oven door completely. 3) Extract the bottom of the oven after having removed the retaining screws 4) Take off the burner by unscrewing the screw.
Setting of the minimum The oven thermostat is equipped with a by-pass for the minimum; when changing the type of gas it is also necessary to adjust the setting in the following manner: Remove the thermostat knob; If the front panel is in glass, remove it by unscrewing the two locking ring nuts located under the ot her two knobs (fig.
BEFORE USING THE OVEN - PRECAUTIONS AND GENERAL S UGGESTIONS Unplug the appliances before performing any maintenance and/or cleaning. Any repairs or other work on the appliances must be carried out by qualified technicians only.
TURNING ON THE OVE N The oven is equipped with electric ignition. To turn on the oven, open the door completely. Press the thermostat knob slightly and turn it counter-clockwise to the maximum. Press the knob completely to trigger the electric ignition and keep the knob pre ssed for a few seconds.
Pilot light Th e light turns on when the selector knob is in any position different from 0. Selector knob It allows to choose between th e di ff ere nt cooking functions. Use of the selector and symbols : Oven light How to use the oven It allows to choose the preferred temperature of cooking.
.
INSTRUCTIONS FOR INSTALLING KNOB GUARD OPEN OVEN DOOR INSTALL KNOB GUARD IN SLOTS OF FRONT FASTEN KNOB GUARD ONTO FRONT BY MOVING IT TO THE RIGHT MAKE SURE THE KNOB GUARD IS ATTACHED BY PULLING IT OUTWARDS CLOSE OVEN DOOR ATTENTION: During operation the knob guard gets very hot.
Panettone or focaccia 175 2 55 - 65 Real focaccia 175 3 60 - 70 ‘Sublime’ cake 175 3 60 - 70 Pie crust 200 3 8-10 Pie crust with soft cheese 200 3 25 - 35 Pie crust with fruit 200 3 25 - 35 Pie cr.
CLEANING AND MAINTENANCE OF THE OVEN Important: Before performing any maintenance, you must either unplug the oven or disconnect the power supply via the omni - polar switch of the electrical system. Cleaning the oven: Let the oven cool after each use and clean it to keep bur nt on residues from being repeatedly heated.
How to remove the oven door To make it easier to clean the oven, it is possible to remove the door from the hinges as follows: The hinges A are equipped with 2 mobile U - bolts B. When the U - bolts B are lifted, the hinges are disconnected from their housing.
Cleaning the side racks The side r a cks has to be hooked onto the wall of the oven. Slide the racks and tray provided into the side r a il s . To remove the side racks press on part A as shown .
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Foster 7191 061 è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Foster 7191 061 - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Foster 7191 061 imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Foster 7191 061 ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Foster 7191 061, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Foster 7191 061.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Foster 7191 061. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Foster 7191 061 insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
