Manuale d’uso / di manutenzione del prodotto DFKTWC75GS del fabbricante Electrolux
Vai alla pagina of 20
Use & Care Guide Installation Instructions Vent Hood 316495007 - 09/2007.
2.
3 Finding Information Purchase date Electrolux model number Electrolux serial number (see picture for location) Please read and save this guide Thank you for choosing Electrolux , the new premium brand in home appliances.
4 Safety Important Safety Instructions Read all instructions before using this appliance. Save these instructions for future reference. Do not attempt to install or operate your appliance until you have read the safety precautions in this manual. Safety items throughout this manual are labeled with a WARNING or CAUTION based on the risk type.
5 Safety TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:* 1. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off the burner. BE CAREFUL TO PREVENT BURNS. If the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT.
6 Unpack hood and check contents. You should receive: 1 - Hood 1 - Decorative Flue Assembly 1 - Parts Bag containing: 1 - Mounting Bracket 1 - Discharge Collar 1 - Flue Mounting Bracket 6 - Mounting Screws (4,8 x 38mm Pan Head) 7 - Mounting Screws (3,9 x 9,5mm Pan Head) 2 - Mounting Screws (3.
7 Installation 1. Decide where the ductwork will run between the hood and the outside. 2. A straight, short duct run will allow the hood to perform most efficiently. 3. Long duct runs, elbows, and transitions will reduce the performance of the hood. Use as few of them as possible.
8 Installation Wiring GROUNDING INSTRUCTIONS This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a cord having a grounding wire with a grounding plug.
9 Installation Install mounting bracket FRAMING BEHIND DRYWALL 37"= bottom of hood 24" above cooktop 43"= bottom of hood 30" above cooktop 37” to 43” above cooktop 1. Construct wood wall framing that is flush with inte- rior surface of wall studs.
10 Installation Prepare the hood NOTE On stainless steel hoods, carefully remove the plastic protective film from all exterior surfaces of the hood and decorative flues, prior to final installation. 1. Remove the polystyrene block and the tape (Fig.1).
11 DUCTED CONFIGURATION 1. Install the discharge collar into the duct connector of the range hood. Fig. 6. FIG. 6 DISCHARGE COLLAR DUCT CONNECTOR Non - Ducted Recirculation Kit, Model DFKTWC75GS. 5” diameter duct. 1. Discard discharge collar/damper supplied with the hood.
12 Installation FIG. 9 MOUNTING SCREWS (4.8x38mm) MOUNTING SCREWS (4.8x38mm) RECTANGULAR OPENING WALL MOUNTING BRACKET MOUNTING SCREWS (3.9x9.5mm) FIG.10 PLATE OF THE ELECTRICAL SYSTEM MOUNTING SCREWS (3.9x9.5mm) Install the hood 1. Raise the hood into its mounting position.
13 9. Carefully place the decorative flue on the hood. Fig. 13. - On ducted installation in rooms with 8-foot ceilings , the air vents are concealed. Install the flue with the air vents down. - On non-ducted installations in rooms with 8-foot ceilings , the air vents are exposed.
14 (DUCTED AND NON-DUCTED HOODS) 1. To remove the GREASE filters, pull the metal latch ta b outside and unlock the filter. 2. To install the GREASE filters, align rear filter tabs with slots in the hood. Depress the metal latch tab, push filter into position and release.
15 The grease filters should be cleaned when the filter reset switch will be illuminated. Use a warm detergent solution. Grease filters are dishwasher safe.
16 Operation Controls Dead-front mode IMPORTANT The HEAT SENTRY thermostat can start the blower even if the hood is turned OFF. When this occurs, it is impossible to turn the blower OFF with its switch. If you must stop the blower, do it from the integral disconnecting switch located inside the blower housing.
17 Remove the grease filters. Open the fuse box. Replace with the same type of fuse (5x20mm, 4A, 125V). Fuse Key : 5304455332 FUSE BOX This range hood requires two halogen bulbs (max 20W, 12V, Type T3 bulb, G4 Base).
18 Warranty Information In the U.S.A., your appliance is warranted by Electrolux Home Products North America, a division of White Consolidated Industries, Inc.
19.
04307838/3S.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Electrolux DFKTWC75GS è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Electrolux DFKTWC75GS - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Electrolux DFKTWC75GS imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Electrolux DFKTWC75GS ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Electrolux DFKTWC75GS, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Electrolux DFKTWC75GS.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Electrolux DFKTWC75GS. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Electrolux DFKTWC75GS insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
