Manuale d’uso / di manutenzione del prodotto 80860 i del fabbricante Electrolux
Vai alla pagina of 44
FAVORIT 80860 i Dishwasher User Instructions.
2 Dear customer, Please read these user instructions carefully. Please observe the safety instructions on the first few pages of thes e use r i nst ru ctio ns ! Please keep these us er ins tru cti ons for later reference. Pass them on to any subsequent owner o f the a ppl ia nce .
Contents 3 CONTENTS Operating Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Disposal . . . . . . . .
Contents 4 Technical Data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 1 Notes for Test Institutes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32 Installation and Connection Instructions .
Operating Instructions 5 OPERATING INSTRUCTIONS 1 Safety Instructions The safety aspects of AEG electrical appliances comply with accepted technical standards and the German Appliance Safety Law.
Operating Instructions 6 • Never place the dishwasher in ope ration if the mains cable, water inlet or drain hose is damaged; or the control panel, work top or plinth area is damaged such that the inside of the appliance is freely accessible.
Operating Instructions 7 • In the event of a fault, first close the tap, then switch off the appli- ance and unplug it from the mains. If the appliance is permanently wired to the mains: remove the fuse. 2 Disposal Disposing of the Pa ckaging Material Dispose of the dishwasher packaging material correctly.
Operating Instructions 8 Appliance Features and Control Panel Top Spray Arm Inlet for Fan Assisted Drying Container for Salt Rating Plate Container for Rinse Aid Filters Rubber Seal for Connecting the.
Operating Instructions 9 Control Panel The Control Panel comprises the ON/OFF switch and the programme buttons with LED indicators. Signal Tone Button: In addition to the wash programme printed on the front panel, this button can be us ed to set whether a signal tone is to indicate that a wash programme is finished.
Operating Instructions 10 Prior to using for the first time Prior to using for the first time, remo v e all the clips with which the dish racks are secured for transport. Then perform the following steps: 0 1. Adjust the water softener 2. Fill with Salt for the Water Softener 3.
Operating Instructions 11 0 1. The dishwasher must be switched off. 2. Press the signal tone and water so ftener buttons simultaneously and keep them pressed 3. Press the ON/OFF button. The LED indicator s for the signal tone and water softener buttons flash.
Operating Instructions 12 3 The water expelled by filling the salt container with special salt runs out of the salt container onto the base of the washing compartment. This is not a cause for concern, th e water will be pumped out at the start of the next wash programme.
Operating Instructions 13 4. Fill with rinse aid exactly up to the level marked “max”; this corresponds to a quantity of approx. 140 ml. 5. Close the lid and press until it locks into place. 6. Wipe up any spilt rinse aid with a cloth. Otherwise too much foam will be formed during the wash.
Operating Instructions 14 Setting the Audibl e Signal for the End of the Wash Programme The dishwasher can be set to emit an audible signal at the end of a wash cycle. 0 1. The dishwasher must be switched off. 2. Press the signal tone and water so ftener buttons simultaneously and keep them pressed.
Operating Instructions 15 Loading Cutlery and Dishes 1 Sponges, household cloths and any obj ect that can absorb water should not be washed in the dishwasher . • Before loading the dishes, you should: – Remove all scraps of food. – Soften remnants of burnt food in pans.
Operating Instructions 16 Loading Cutlery 1 Long bladed knives stored in an up right position are a potential hazard . 1 Long and/or sharp items of cutlery su ch as carving knives must be posi- tioned horizontally in the upper basket. 1 Take care when loading or unload ing sharp items such as knives.
Operating Instructions 17 I f you use the grid insert, it is not possible to open the cutlery basket. 1 To ensure that the cutlery basket cannot open on removal from the appliance, you should always hold both parts of the two part handle. 0 1. Place the cutlery basket on a table or work surface 2.
Operating Instructions 18 2. Fold the plate insert to the left. Loading Cups, Glasses and Coffee Services Load small, delicate items and long pointed cutlery in the upper rack. • Arrange items of crockery on the folding cups racks so that they are offset from each other and water can reach all items.
Operating Instructions 19 Adjusting the Height of the Upper Basket 3 The height of the basket can also be adjusted when it is loaded. Depending on the model, your applia nce is provided with one of the following types of upper basket: Lowering the Upper Basket: Type 1 0 1.
Operating Instructions 20 Filling with Detergent 1 Only use dishwasher detergent. Fill with detergent: – Prior to the start of a wash programme (not for the pre wash pro- gramme).
Operating Instructions 21 Bio Wash Programmes and Co ncentrated Detergents Based on their chemical compositio n, dishwasher detergents can be split into two basic types: – Conventional, alkaline de tergents with caustic components – Weak alkaline concentrate d dete rgents with natural enzymes.
Operating Instructions 22 Selecting the Wash Progr amme (Programme Table) Choose the most suitable wash program me with the aid of this table: 1) During BIO programmes the water i s briefly heated to more than 50 °C so that the active oxygen becomes effective.
Operating Instructions 23 4) The “ ENERGY SAVING “ wash programme washes normally soiled dishes with a ve ry low electricity consumption. If the dis hes need to be washed more qui ckly, as an alternati ve you can use the “ NORMAL BIO 50° “ wash programme.
Operating Instructions 24 Starting the Wash Programme 0 1. Check that when the dishes and cutl ery are loaded into the dishwasher the spray arms are free to rotate. 2. Open the tap fully. 3. Shut the door. 4. Press the ON/OFF button The ON/OFF button indicator illuminates.
Operating Instructions 25 0 1. Open the door of the dishwasher. The wash programme stops. 2. Shut the door. The wash programme continues. Cancelling the wash programme 0 1. Press the button for the wash programme in progress and keep it pressed. The programme indicator for the wash programme in progress flashes for a few seconds and then goes out.
Operating Instructions 26 Load Sensing – Sensor Logic If a wash programme is started even though there are only a few dishes in the upper and/or lower rack, an in telligent electronic system adjusts the amount of water and the durati on of the wash programme to the number of dishes.
Operating Instructions 27 Care and Cleaning 1 Do not under any circumstances use fu rniture care products or aggres- sive cleaners. • If necessary, clean the controls only with a soft cloth and pure warm water. • The s pray arms do not need cleaning.
Operating Instructions 28 7. Put the flat filter back in the base of the washing compartment 8. Place the coarse/fine filter in the microfilter and press together. 9. Put the filter combination in place and lock by turning the handle clock- wise to the stop.
Operating Instructions 29 • For all other faults that are indicated, please contact AEG Service Force sta ting the fault code. Symptom Pos s i b le C a u s e Solution The programme indicator for the.
Operating Instructions 30 ...there are problems with th e operation of the dish- washer. ...the wash result is not satisfactory. The dishes are still dirty. – The wrong wash programme was selected. – The dishes were arranged in such a manner that water has not reached all parts.
Operating Instructions 31 The dishes are wet and dull. – Rinse aid was not used. – The rinse aid container is empty. There are streaks, milky spots or a bluish coating on glasses and dishes. – Decrease rinse aid dosing. There are dried water drops on the glasses and dishes.
Operating Instructions 32 Notes for Test Institutes Testing in accordance with EN 60704 must be carried out with the appliance fully loaded and using the test programme (see Programme Table).
Installation and Connection Instru ctions 33 INSTALLATION AND CONNECTION INSTRUCTIONS Installing the Dishwasher • The dishwasher must be installed on a firm floor and adjusted such that it is stable and level.
Installation and Connectio n Instructions 34 Dishwashers That Can Be Integrated (see installation template supplied) 3 The door of the appliance can be fitted with a wooden/facing panel with the follo.
Installation and Connection Instru ctions 35 Connecting the Dishwasher Water Connection The dishwasher is fitted with safety devices that prevent the wash water returning into the drinking water system and comply with the applicable plumbing regulations.
Installation and Connectio n Instructions 36 Water drain Drain hose 1 The drain hose must not be kinked, crushed or entangled. • Connecting the drain hose : – Maximum permitted height: 1 metre. – Minimum required height 30 cm above the lower edge of the machine.
Installation and Connection Instru ctions 37 Leak Prevention System For protection from damage due to water leaks, the dishwasher is equipped with a leak prevention system, the AQUA CONTROL SYSTEM. In the event of a fault, the safety valve immediately interrupts the sup- ply of water to the appliance and the drain pump switches on.
Installation and Connectio n Instructions 38 Electrical Connection Any electrical work required to inst all this appliance should be car- ried out by a qualified elec tr ician or competent person. 1 WARNING - This appliance must be earthed. The manufacturer declines any resp onsibility should these safety measures not be observed.
Installation and Connection Instru ctions 39 Connections The water inlet and drain hoses, as well as the mains cable must be connected beside the dishwasher as there is insufficient space behind the appliance. The plumbing and electrical installa tion example given below can only be regarded as a recommendation.
Guarantee Conditions 40 GUARANTEE CONDITIONS Guarantee Conditions AEG offer the following guarantee to the first purchaser of this appliance. 1. The guarantee is valid for 12 month s commencing when the appliance is handed over to the first retail purchaser, which must be verifi ed by purchase invoice or similar doc- umentation.
41.
42.
Service & Spare parts 43 SERVICE & SPARE PARTS If you wish to purchase spare parts or require an engineer, co ntact your local AEG Service Force Centre by telephoning: 08705 929 929 Your telephone call will be automatically routed to the Service Centre covering your post code area.
AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.de © Copyright by AEG 822 946 237 - 00 - 1 1 0 1 Subject to change without notice.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Electrolux 80860 i è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Electrolux 80860 i - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Electrolux 80860 i imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Electrolux 80860 i ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Electrolux 80860 i, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Electrolux 80860 i.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Electrolux 80860 i. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Electrolux 80860 i insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
