Manuale d’uso / di manutenzione del prodotto 65852 G del fabbricante Electrolux
Vai alla pagina of 32
65852 G Instruction Booklet Gas Hob GB IE.
2 Welcome to the world of Electrolux Thank you for choosing a first class product from Electrolux, which hopefully will provide you with lots of pleasure in the future. The Electrolux ambition is to offer a wide variety of quality products that make your life more comfortable.
3 Contents Important Safety Information ..................................................................................... 2 Instructions for the User ............................................................................................... 5 Description of the Hob .
4 Important Safety Information You MUST read these warnings carefully before installing or using the hob. If you need assistance, contact our Customer Care Department on 08705 350350 Installation # Th.
5 # Ensure the control knobs are in the ‘OFF’ position when not in use. # When using other electrical appliances, ensure the cable does not come into contact with the hot surfaces of the cooking appliance. # Unstable or misshapen pans should not be used on the hob as unstable pans can cause an accident by tipping or spillage.
6 1 . Hob Top 2 . Semi-rapid Burner 3 . Triple Crown Burner 4 . Auxiliary Burner 5 . Control knob for front left burner (semi-rapid) 6 . Control knob for back left burner (semi-rapid) 7 .
7 Hob burners control knobs The symbols on the knobs mean that : # there is no gas supply there is maximum gas supply there is minimum gas supply Lighting the burners For easier lighting, proceed before putting a pan on the pan support. To light a burner: # turn the relevant knob anticlockwise to maximum position ( ).
8 Burner minimum maximum diameter diameter Triple crown (ultra-rapid) 180 mm 260 mm Medium (semi-rapid) rear 120 mm 220 mm front 120 mm 180 mm Small (auxiliary) 80 mm 160 mm As soon as a liquid starts boiling, turn down the flame so that it will barely keep the liquid simmering.
9 Using the W ok Stand A wok stand is provided to enable you to use a round bottomed wok on the hob. The wok stand must only be used on the triple crown burner , and should not be used with any other type of wok or pan.
10 Before any maintenance or cleaning can be carried out , you must DISCONNECT the hob from the electricity supply. The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool. This appliance cannot be cleaned with steam or with a steam cleaning machine.
11 The Burners The burner caps and crowns can be removed for cleaning. Wash the burners caps and crowns using hot soapy water, and remove marks with a mild paste cleaner. A well moistened soap impregnated steel wool pad can be used with caution, if the marks are particularly difficult to remove.
12 Something Not W orking? If the hob is not working correctly, please carry out the following checks before contacting your local Service Force Centre. SYMPTOM % There is no spark when lighting the gas. % The gas ring burns unevenly. SOLUTION & Check that the unit is plugged in and the electrical supply is switched on.
13 OVERALL DIMENSIONS Width: 594 mm Depth: 510 mm CUT OUT DIMENSIONS Width: 560 mm Depth: 480 mm SUPPLY CONNECTIONS Gas: R 1/2 inch (1/2 inch male) Rear right hand corner Electric: 230 V ~ 50 Hz supply, 3 core flexible cable with non rewireable plug fitted with a 3 amp cartridge fuse.
14 Burner Burner Burner Burner Burner Dia. Tap By-pass Dia. Tap By-pass Dia. Tap By-pass Dia. Tap By-pass Dia. Tap By-pass 1/100 mm 1/100 mm 1/100 mm 1/100 mm 1/100 mm Auxiliary 2 8 Semi-rapid 3 2 Triple crown 5 6 Aeration adjustment none BURNER SEMI-RAPID AUXILIARY TRIPLECROWN POSITION M A X M I N MA X MI N MAX MI N NOMINAL THERMAL POWER kW 2 .
15 Important safety requirements This hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations (Current Edition) and the IEE Wiring Regulations (Current Edition). For appliances installed in the Republic of Ireland please refer to NSAI- Domestic Gas Installation I.
16 CLEARANCES REQUIRED WHEN FITTING THE GAS HOB WITHOUT A COOKER HOOD ABOVE FO 0813 FO 0812 Installation IMPORT ANT This hob must be installed by a competent person to the relevant Gas Standards. Any gas installation must be carried out by a registered competent person.
17 A) End of shaft with nut B) Washer C) Elbow FO 0814 FO 0264 It is important to install the elbow correctly, with the shoulder on the end of the thread, fitted to the hob connecting pipe. Failure to ensure the correct assembly will cause leakage of gas.
18 Cut Out Size The dimensions of the cut-out are given in the diagram. Building In Building over a cupboard or drawer If the hob is to be installed above a cupboard or drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work surface.
19 ON/OFF SWITCH FLEX OUTLET ON/OFF SWITCH FLEX OUTLET 1 2 Building over a kitchen unit with door Proper arrangements must be taken in designing the furniture unit , in order to avoid any contact with the bottom of the hob which can be heated when it is operated.
20 Seal Seal Seal Seal Seal Fitting the Hob into the W orktop Carry out the building in of the hob as follows: 1. place the seals supplied with the hob on the front edge of the cut ou t. Then, p lace them at 11 mm from the side edges and a t 10 mm from the rear edge, as shown in the diagram, taking care that the seals meet without overlapping.
21 Electrical connections Any electrical work required to install this hob should be carried out by a qualified electrician or competent person, in accordance with the current regulations. THIS HOB MUST BE EARTHED. The manufacturer declines any liability should these safety measures not be observed.
22 Permanent Connection In the case of a permanent connection, it is necessary that you install a double pole switch between the hob and the electricity supply (mains), with a minimum gap of 3 mm between the switch contacts and of a type suitable for the required load in compliance with the current electric regulations.
23 Fault Finding Preliminary Electrical Systems Check START Isolate appliance and carry out: A: Earth Continuity check. Has inlet fuse blown? Carry out: C: Polarity check. Electricity supply should now be satisfactory. Carry out: D: Resistance to Earth check.
24 A. EARTH CONTINUITY CHECK Appliance must be electrically disconnected - meter set on W (Ohms) x 1 scale and adjust zero if necessary. — Test leads from any appliance earth point to earth pin on plug. Resistance should be less than 0.1 W (Ohm), check all earth wires for continuity and all contacts clean and tight.
25 Check gas supply at burner Ignition System / Gas Ignition YES Check plug top fuse and replace if necessary Check polarity and earth continuity of supply point Check earth continuity of appliance Ig.
26 Commissioning When the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedure below. 1) Turn the gas tap to the MAX position and ignite. 2) Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX several times.
27 Conversion from N atural Gas to LPG IMPORT ANT The replacement/conversion from natural gas to LPG should only be undertaken by a competent person. It is important to note that this model is designed for use with natural gas but can be converted for use with butane or propane gas providing the correct injectors are fitted.
28 Guarantee/Customer Service Standard guarantee conditions We, AEG-Electrolux, undertake that if within 12 months of the date of the pur- chase this AEG-Electrolux appliance or any part thereof is pr.
29 Service and Spare Parts In the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local Service Force Centre by telephoning 0870 5 929 929 Your telephone call will be automatically routed to the Service Force Centre covering your postcode area.
30 This appliance is guaranteed by Electrolux in each of the countries listed at the back of this user manual, for the period specified in the appliance guarantee or otherwise by law.
31.
35693-3101 07/06 R.0 Subject to change without notice Grafiche MDM - Forlì www.aeg-electrolux.co.uk.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Electrolux 65852 G è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Electrolux 65852 G - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Electrolux 65852 G imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Electrolux 65852 G ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Electrolux 65852 G, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Electrolux 65852 G.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Electrolux 65852 G. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Electrolux 65852 G insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
