Manuale d’uso / di manutenzione del prodotto 2573-4 KA del fabbricante Electrolux
Vai alla pagina of 20
Öko Santo Super 2573-4 KA Fridge Operating Instructions.
2 Dear customer , Before placing your new refrigerator/freezer into operation please read these operating instructions carefully . They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference.
3 Contents Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Disposal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Appliance Packaging Information . . . . . . . . .
4 Safety The safety aspects of our refrigerators/freezers comply with accepted technical standards and the German Appliance Safety Law . Neverthe- less, we consider it our obligation to make you aware of the following safety information: Intended use • The refrigerator is intended for use in the home.
5 catches, if fitted. By doing this you ensure that children cannot lock themselves in the fridge when playing (there is risk of suffocation!)or get themselves into other dangerous situations. • Often children cannot recognise the hazards present in household appliances.
6 Disposal Appliance Packaging Information All materials are environmentally sound! They can be dumped or bur- ned at an incinerating plant without danger! About the materials: The plastics can be recycled and are identified as follows: >PE< for polyethylene, e.
7 Installation Installation Location The appliance should be set up in a well ventilated, dry room. Energy use is affected by the ambient temperature. The appliance should therefore – not be exposed.
8 E F D PR185 F F F Y our appliance needs air For safety reasons, minimum ven- tilationmust be as shown Fig. Attention: keep ventilation ope- nings clear of obstruction; NP005 100 mm 10 mm 10 mm Rehin.
9 4. Remove the centre hinge and slide the top door off pin (D); unscrew pin (D) and refit it on the opposite side. 5. Remove the two plugs, to reveal the holes for the hinge pivots, and remount them on the other side. 6. Refit the top door and the centre hinge (H) on the opposite side.
10 Prior to Initial Start–Up • Please clean the appliance interior and all accessories prior to initial start-up (see section: “Cleaning and Care”). Electrical Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.
11 Starting up and temperature regulation • Insert the plug of the connection lead into the plug socket with pro- tective earth contact. T urn the thermostat knob (B), clockwise, beyond the «O»(STOP) position. The pilot light (A) will light up, indi- cating that the appliance is in operation.
Interior Accessories Storage shelves • Y ou should always slide one of the full size glass storage shelf into the lowest set of guides, above the fruit and the vegetable contai- ners, and keep it in this position.
13 Useful hints: Meat (all types): wrap in polythene bags and place on the glass shelf above the vegetable drawer(s) For safety , store in this way only one or two days at the most. Cooked foods, cold dishes, etc : these should be covered and may be placed on any shelf.
14 14 Cleaning and Care For hygienic reasons the appliance interior , including interior acces- sories, should be cleaned regularly . W arning! • The appliance may not be connected to the mains during cleaning.
15 • Do not use any abrasive cleansers. 1. Remove the food from the refrigerator . 2. Defrost the freezer compartment prior to cleaning (see "Defrosting" section). 3. Switch the appliance off and remove the plug from the mains, or swit- ch off or turn out the circuit breaker or fuse.
16 The food is too warm. Interior lighting does not work. The appliance is near a heat source. T emperature is not properly adjusted. Please look in the "Initial Start Up" section. Light bulb is defective. Please look in the "Chan- ging the Light Bulb" section.
17 Heavy build up of frost, pos- sibly also on the door seal. Door seal is not air tight (possibly after changing over the hinges). Carefully warm the leaking sections of the door seal with a hair dryer (not hotter than approx. 50 °C). At the same time shape the war- med door seal by hand such that it sits correctly .
18 Regulations, Standards, Guidelines This appliance was designed for household use and was manufactu- red in accordance with the appropriate standards.
.
AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www .aeg.hausgeraete.de 2222 016-71.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Electrolux 2573-4 KA è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Electrolux 2573-4 KA - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Electrolux 2573-4 KA imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Electrolux 2573-4 KA ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Electrolux 2573-4 KA, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Electrolux 2573-4 KA.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Electrolux 2573-4 KA. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Electrolux 2573-4 KA insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
