
Operating and Installation Instructions for your Dometic Wine Cellar
Data plate Check the data plate, inside the wine cellar at the top left, to ensure you have received the right model. The data plate shows details that you will need to quote if you have to contact service personnel. It is a good idea to make a note of them here.
Introduction Thank you for choosing the Dometic Wine Cellar. Please read the following instructions carefully before installing your new wine cellar. We trust you will be completely satisfied with your purchase. The wine cellar must be installed and used according to these instructions in order for it to operate correctly and economically.

Model designation Product number Serial number Voltage
Transit damage Inspect the wine cellar for transit damage. You must report any damage the company responsible for the delivery within the legal or stated time for this type of product. If there is no such established report time, the damage must be reported within seven days of delivery.
Installation Please follow these installation instructions: For best performance, air needs to circulate freely over the cooling unit behind the wine cellar. The free- standing design of the cellar means that it should stand at least 25 mm from the rear and side walls. Allow a clearance of at least 100 mm above the wine cellar. FIG 1
Accessories Please check that the following accessories are attached to the Wine Cellar. On the back or inside the Wine Cellar.

At the back:
Inside the Wine Cellar:

Necessary additional tools not incuded

Adjust the feet of the wine cellar so that it stands in a vertical position in both directions. Use a spirit level if necessary.




FIG 4a FIG 4b

Electrical connection. It is essential that the electrical installation is carried out correctly, taking into account all relevant regula- tions and codes of practice. Your wine cellar will operate on a mono-phased alternating current. Please check that the voltage shown on the data plate corresponds to your power supply.

The wine cellar is fitted with a plug intended for an earthed socket. Dometic and its subsidiaries will not be held responsible for any incident due to non-existent or defective earth wires.
Electrical leads must be routed and secured so that they cannot come into contact with hot or sharp parts of the wine cellar.
FIG 4c

Temperatur inställning Plug in the wine cellar and turn it on with the S1 switch (see fig. 5). The wine cellar is equipped with an electronic regula- tor. This allows you to programme the temperature inside the wine cellar. Your wine will then be stored between 10°C and 15°C according to expert advice. The temperature is shown on the display.

The temperature, [pre-set at 12°C], can be changed according to the wine stored.

It is important to avoid rapid temperature changes inside your wine cellar.
Maintenance We recommend that you keep your wine cellar as clean as possible. Unplug the cellar before cleaning. Do not use any abrasive or strong scented substances Use a smoth cloth or sponge and light detergent. It is very important to check regularly that the air circulation underneath and behind the cellar is not blocked. Condensation collects in a small cup placed at the back of the wine cellar. The cup has a sponge which helps the condensation to evaporate. Check that the plastic pipe routing the water from the inside to the cup is not blocked by dust or dirt.
The wine cellar is equipped with overheating protec- tion. An authorised service technician can check whether these have been triggered or not.
You should replace the inside ventilation charcoal filter every second year. The filter is fitted in the upper left corner inside the wine cellar.
Storing the wine. Please see illustrations on side 10. Bottles should be stored in your wine cellar according to their size. The best known bottles are the “Bor- deaux” and the “Burgundy”. These bottles are not all identical. The most widely recognised bottles are the “Tradition” and the “Légère”. The “Champenoise” and the “flûte d’Alsace” bottles have different diameters and heights. Take these differences into account when storing your wine and avoid mixing the bottles. It is important to store bottles on their side in order for the cork to remain in contact with the wine. Our illustrations show the best way to stack the “Bordeaux Tradition”.



How to store bottles.

The maximum number of Bordeaux tradition bottles that can be stored in the wine cellar:
Model No. of No. of bottles shelves CS 52 5 36 CS 52 0 54
Shelf supports and shelf locks. The wine cellar is equipped with 5 shelves and 20 shelf supports. The shelves are at delivery fixed to the side of the wine cellar with a shelf lock. These can easily be removed with a screwdriver. See fig 7


Installation of the shelf supports. Place the support hooks in front of the desired holes press in direction of arrow 1 and then push the hook down as arrow 2 indicates See fig 8


I possessori del prodotto e il nostro team di solito rispondono entro 24 ore, e la tua domanda sarà utile anche ad altri.
Invia la prima domanda: risponderanno altri possessori o il nostro team.