Manuale d’uso / di manutenzione del prodotto (V)CB36P(E) del fabbricante Desa
Vai alla pagina of 36
VENTED GAS FIREPLACE INST ALLA TION AND OWNER’S OPERA TION MANU AL 4" B-VENT DECORA TIVE GAS FIREPLACES MODELS (V)CB36N(E) AND (V)CB36P(E) W ARNING: If the information in this manual is not fol- lowed exactly , a re or explosion may result causing property damage, personal injury or loss of life.
www .desatech.com 1 17437-01B 2 W ARNING: Improper in - stallation, adjustment, alteration, service or maintenance can cause injury or property dam - age. Refer to this manual for correct installation and operational proce - dures. For assistance or additional information consult a qualified in - staller , service agency or the gas supplier .
www .desatech.com 1 17437-01B 3 Do not place clothing or other ammable material on or near the appliance. Never place any objects on or around replace. Firepl ace reaches high tempera - tures. Keep children and adults away from hot surface to avoid burns or clothing ignition.
www .desatech.com 1 17437-01B 4 4. Never install the replace • in a recreational vehicle • in windy or drafty areas where curtains or other combustible (ammable) objects can make contact with the replace front • in high trafc areas 5.
www .desatech.com 1 17437-01B 5 PRODUCT FEA TURES These are a few facts that can help you understand and enjoy your vented decorative replace: • The (V)CB36N(E) and (V)CB36P(E) series of vented decorative replaces may be recessed into an exterior chase, an interior ush wall enclosure or a framed-in corner installation.
www .desatech.com 1 17437-01B 6 • A hear th ext ensio n is n ot re quired with this appliance. If one is installed, it is for aesthetic purposes only and does not have to meet stan- dard requirements for hearth extensions.
www .desatech.com 1 17437-01B 7 Figure 6 - Framing Clearances for Corner Installation 28 5 / 8 " (72.7 cm) 21" (53.3 cm) T o Center of T op Vent 14 3 / 4 " (37.
www .desatech.com 1 17437-01B 8 Figure 9 - Clearances for Combustible Mantels Figure 8 - Side Clearances for Combustible Mantels PRE-INST ALLA TION PREP ARA TION Continued 1 1 / 2 " (3.8 cm) 3 1 / 2 " (8.9 cm) Outer Surround Combustible Material May Be Used Perpendicular Side Wall 5 1 / 4 " (13.
www .desatech.com 1 17437-01B 9 This appliance may be vented through a manu- factured chimney liner system if all are listed, inspected and approved by local codes and/or building authorities. The examples shown in Figure 10 are typical of most B-vent installations and code practices.
www .desatech.com 1 17437-01B 10 Lowest Discharge Opening Listed V ent Cap 8 Ft. Min. Roof Pitch x/12 Listed Clearance 12 x Listed Gas V ent H (Min) Height From Roof Figure 1 1 - B-V ent Termination Roof Pitch H (Min.) Flat to 6/12 1.0 ft (0.3 m) 6/12 to 7/12 1.
www .desatech.com 1 17437-01B 1 1 Remote Receiver or Wall Switch to T erminal Marked “TH” Wire Harness From High Limit Switch Male Connector to Remote Receiver or Wall Switch 9. Strip back outer Romex to about 4" and con - nect black, white and green wires accordingly using 3 wire nut connectors.
www .desatech.com 1 17437-01B 12 6. Use clips to mount receiver on remote mount - ing bracket as shown in Figure 16. INST ALLING OPTIONAL CONTROLS Continued 9-V olt Battery Battery Housing Battery Cov.
www .desatech.com 1 17437-01B 13 Fi gu re 2 0 - Mi ll iv ol t Ig ni ti on W ir in g Di ag ra m Figure 21 - Electronic Ignition Wiring Diagram TH TP TH/TP WHITE RED DO NOT CONNECT TO 120V HIGH LIMIT SW.
www .desatech.com 1 17437-01B 14 FI REP LA CE I N ST ALL A TI ON CHECK GAS TYPE Use only the correct type of gas (natural or pro - pane/LP). If your gas supply is not the correct gas type, do not install replace.
www .desatech.com 1 17437-01B 15 FI REP LA CE I N ST ALL A TI ON Continued W e recommend that you install a sediment trap/ drip leg in supply line as shown in Figure 23. Lo- cate sediment trap/drip leg where it is within reach for cleaning. Install in piping system between fuel suppl y and replace.
www .desatech.com 1 17437-01B 16 T est Pressures Equal T o or Less Than 1/2 PSIG (3.5 kPa) 1. Cl os e eq ui pm en t sh ut of f v al ve ( se e Fi gur e 2 5).
www .desatech.com 1 17437-01B 17 Figure 28 - Removing Louver Panel Louver Panel Spring Latch Removing/Replacing Glass Door W A RN I N G: H a n dl e g la s s door panel with care. Do not strike, slam or otherwise abuse glass. Do not operate fire - place with glass door removed, cracked or broken.
www .desatech.com 1 17437-01B 18 INST ALLING LOGS AND GLOWING EMBERS A 4 piece ceramic log set comes packed inside the unit rebox. Removal of glass door is necessary to unpack and assemble logs and add hearth treat - ments. Follow steps under Removing/Replacing Glass Door , page 17 to access logs and burner .
www .desatech.com 1 17437-01B 19 O F F P I L O T O N OPERA TING FIREPLACE MANU AL IGNITION SY STEM FOR YOUR SAFETY READ BEFORE LIGHTING W ARNING: If you do not fol- low these instructions exactly , a re or explosion may result causing property damage, per - sonal injury or loss of life.
www .desatech.com 1 17437-01B 20 OPERA TING FIREPLACE Continued MANUAL LIGHTING PROCEDURE 1. Rem ove gla ss doo r (se e Remov in g/Re pl aci ng Glass Door , page 17). 2. Follow steps 1 through 8 under Lighting Instructions , page 19). 3. Press gas control knob and light pilot with match.
www .desatech.com 1 17437-01B 21 OPERA TING FIREPLACE Continued O F F P I L O T L O I H ON OFF REMOTE ON OFF O N Blower Control Knob (Optional Accessory) V ariable Control Knob Selector Switch in Remo.
www .desatech.com 1 17437-01B 22 INSPECTING B URNERS Check pilot ame pattern and burner ame pat - terns often. PILOT ASSEMBL Y The pilot assembly is factory preset for the proper ame height. Alterations may have occurred dur - ing shipping and handling.
www .desatech.com 1 17437-01B 23 CLEANING AND MAINTENANCE W ARNING: T urn off replace and let cool before cleaning. CAUTION: Y ou must keep control areas, burners, and cir - cu lat in g air pas sag es of re pla ce clean. Inspect the se areas of replace before each use.
www .desatech.com 1 17437-01B 24 LOGS • If you remove logs for cleaning, refer to In- stalling Logs and Glowing Embers , page 18, to properly replace logs. • Use a vacuum cleaner to remove any carbon buildup on logs. • Replace log(s) if broken. See Replacement Parts, page 34.
www .desatech.com 1 17437-01B 25 TROUBLESHOO TING W ARNING: T urn off heater and let cool before servicing. Only a qualied service person should service and repair heater . CAUTION: Never use a wire, needle or similar object to clean ODS/pilot. This can damage ODS/pilot unit.
www .desatech.com 1 17437-01B 26 TROUBLESHOO TING Continued POSSIBLE CAUSE 1. Gas con trol kno b no t fu lly pressed in 2. Gas control knob not pressed in long enough 3. Equipment shutof f valve not fully open 4 . Pilot flame not touching ther moco uple , which allow s th er mo co up le to co ol , cau si ng pilo t to go ou t.
www .desatech.com 1 17437-01B 27 TROUBLESHOO TING Continued POSSIBLE CAUSE 1. T urning gas control knob to HI position when burner is cold 2. Air in gas line 3. Dirty or partially clogged burner orice 1. Flame impingement on logs 2 . Debris around burner air mixer 1.
www .desatech.com 1 17437-01B 28 TROUBLESHOO TING Continued POSSIBLE CAUSE 1 . No gas supply , or shutoff valve is OFF 2. Air in gas line 3. Constr uction debris clogging pilot orice 4. Low gas pressure 5. Kinked pilot line 6. Cont rol valv e is not ope ning 7.
www .desatech.com 1 17437-01B 29 TROUBLESHOO TING Continued W ARNING: If you smell gas • Shut off gas supply . • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor ’ s phone.
www .desatech.com 1 17437-01B 30 ILL USTRA TED P ARTS BREAKDOWN FIREPLACE ASSEMBL Y FOR MODELS (V)CB36N, (V)CB36P , (V)CB36NE AND (V)CB36PE 12 14 1-2 1-1 1-4 1-3 20 8 1 1 10 5 6 7 18 9 13 26 27 17 21 .
www .desatech.com 1 17437-01B 31 P ARTS LIST This list contains replaceable parts used in your replace. When ordering parts, follow the instructions listed under Replacement Parts on page 34 of this manual.
www .desatech.com 1 17437-01B 32 ILL USTRA TED P ARTS BREAKDOWN BURNER ASSEMBL Y FOR MODELS (V)CB36N (V)CB36P , (V)CB36NE AND (V)CB36PE H IG H V O L T A G E 3 4 5 6 7 8 9 1 21 20 24 28 25 26 29 27 30 .
www .desatech.com 1 17437-01B 33 P ARTS LIST This list contains replaceable parts used in your replace. When ordering parts, follow the instructions listed under Replacement Parts on page 34 of this manual.
www .desatech.com 1 17437-01B 34 ACCESSORIES NOTE: All accessories may not be available for all replace models. Purchase these replace accessories from your local retailer . If they can not supply these acces- sories, call DESA ’ s Sales Department at 1-866- 672-6040, for information.
www .desatech.com 1 17437-01B 35 RECEIVER AND HAND-HELD ON/OFF REMOTE CONTROL KIT HRC100 SERIES Allows the replace to be turned on and off con - veniently with dual safety lock feature. REMOTE CONTROL KIT - WRC SERIES Standard ON/OFF electronic remote control kit.
117437 01 2701 Industrial Drive P .O. Box 90004 Bowling Green, KY 42102-9004 www .desatech.com NOT A UPC WARRANTY INFORMA TION KEEP THIS WARRANTY Always specify model and serial numbers when communicating with the factory . W e reserve the right to amend these specications at any time without notice.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Desa (V)CB36P(E) è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Desa (V)CB36P(E) - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Desa (V)CB36P(E) imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Desa (V)CB36P(E) ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Desa (V)CB36P(E), ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Desa (V)CB36P(E).
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Desa (V)CB36P(E). Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Desa (V)CB36P(E) insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.