Manuale d’uso / di manutenzione del prodotto MOV230 del fabbricante Dacor
Vai alla pagina of 20
Installa tion Instr uc tion s Dis cove r y W al l O ven For use with models: EO, MO and PO Part No. 65433 Rev . F Preliminary - For Review Only No Scheduled Release Date.
All specifications are subject to change without notice. Dacor ® assumes no liability for changes to specifications. © 2007 Dacor , all rights reserved.
1 Planning the Installation ................................................... 6 Selecting the Location ...................................................... 6 Cabinet Cut-Out ............................................................... 6 Cabinet Cut-Out (continued) .
2 Impor tant Safety Instructions Read the accompanying use and care manual 1. before operating this appliance. Keep packaging materials away from children. 2. Plastic sheets and bags can cause suffocation. If you receive a damaged product, immediately 3.
3 Model Identification EO230xxx A = MODEL tYPE Epicure Oven = EO Millennia Oven (vert. trim) = MOV Millennia Oven (horiz. trim) = MOH Preference Oven = PO B = CONFIGURA tION Single Oven = 1 Double Ove.
4 Product Specifications Model Number K L M N P Q R S EO127 27” (686mm) 27 15/16” (710mm) 23 3/8” (594mm) 2 5/16” (59mm) 7 3/8” (187mm) 6 3/8” (162mm) 26 3/8” (670mm) 25 3/8” (644mm) P.
5 Product Specifications Single W all Oven Dimension Double W all Oven Dimension “R” “N” “P” “Q” “M” 1 1/16” (27mm) 66” (1676mm) Flexible Conduit “K” “L” 1 1/4” (32mm.
6 “C” 9 5/8” (244mm) Recommended (May be altered) 1 ¾“ (45mm) Clear to T op of Drawer for Heat Exhaust “B” “A” 4“ T ypical T oe Kick (Shown) Recommended Electrical Location 3/4” (.
7 1 ¾” (45mm) Min. to Combustible Floor “A” “B” “A” “B” 1 1/2” (38mm) T ypical Counter 4“ T ypical T oe Kick (Shown) Alternate Electrical Locations 3/4” (19mm) Support Platform 4“ (102mm) Min. Between Cutout 3/4” (19mm) Support Platform Recommended Electrical Location 1“ (25mm) Min.
8 Planning the Installation Cabinet Cut-Out (continued) Suppor t Platform W ARNING The top surface of the support platform must be installed flush with the cutout in the front of the cabinet or wall and any trim. Failure to install the platform properly may cause the exhaust vent to deform and/or become obstructed.
9 Planning the Installation Electrical Specifications IMPORt ANt Preheat times and cavity temperature recovery times • will be increased slightly if operating on less than a 240 V ac circuit. This appliance is provided with electrical connec- • tion leads in a flexible metal conduit.
10 Installation Instructions Before proceeding, turn off power to the circuit to which 1. the oven will be connected at the circuit breaker or fuse box. Position the oven directly in front of the cabinet cutout. 2. Feed the appliance conduit into the electrical junction 3.
11 Installation Instructions Connecting to a Three Wire Electrical System - Where Local Codes Per mit W ARNING Do not connect the green appliance conduit wire to the neutral (white) junction box wire unless local building codes permit. Separate the wires coming out of the appliance conduit.
12 Installation Instructions Final Installation W ARNING A minimum of two people are required to safely • install this appliance. Do not attempt to disengage the hinge catches with • the door removed from the oven. The hinge springs could release, causing personal injury .
13 Raise the door so that it is at a 15° angle from the front 3. of the oven. Hold the door with one hand on each side. Lift the door up and out. Install the Oven in the Cabinet W ARNING Use an appliance dolly to move the appliance when • installing it or removing it from the wall for service.
14 Grasp the oven door on opposite sides and hold it at a 1. 15° angle from the front of the oven. See facing page. Slide the hinges into the hinge openings, resting the 2. bottom of the hinge arms on the hinge receptacles. Continue to hold the door at a 15° angle with one hand 3.
15 Installation Instructions Door Installation Installation Checklist W ARNING T o ensure a safe and proper installation, the follow- • ing checklist should be completed by the installer to ensure that no part of the installation has been overlooked.
16 Notes.
.
Dacor ● 1440 Bridge Gate Drive, Diamond Bar , CA 91765 ● T el: (800) 793-0093 ● F AX: (626) 403-3130 ● www .Dacor.com.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Dacor MOV230 è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Dacor MOV230 - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Dacor MOV230 imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Dacor MOV230 ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Dacor MOV230, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Dacor MOV230.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Dacor MOV230. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Dacor MOV230 insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
