Manuale d’uso / di manutenzione del prodotto KP10 del fabbricante Cambridge Audio
Vai alla pagina of 20
KP10 A-BUS keypad Installation Guide.
2 Incognito KP1 0 CONTENTS Introduction.......................................................3 System options.................................................4 Installation notes..............................................8 Rear panel connections..
Incognito A-BUS keypad 3 Thank you for purchasing this Cambridge Audio Incognito product. Incognito is a cost-effective, modular based system using standard Cat-5 or Cat-6 cable to distribute hi-fi quality sound and video around a home.
The KP10 k eypad can be used in two main configurations: 1. As par t of a full Incognito system, where it is plugged int o an Incognito hub (AH1 0), perhaps with other Incognito accessories such as a video switching unit (VH1 0) or local input module (LM10) fitt ed.
Incognito A-BUS keypad 5 Speaker cable PS10 Speaker cable SS10 SS10 AH10 Cat-5/5e cable KP10-EU KP10-EU KP 10 A-BUS k eypad.
A-BUS Ready / Incognito Ready For use with an A-BUS Ready/Incognito R eady unit (see diagram opposite) the Mode switch MUST be in the "Standar d A-BUS/Incognito Ready" position as shown belo w: In this configuration the keypad is wired directly t o the amplifier/receiver .
Incognito A-BUS keypad 7 Impedance 4 - 8 ohms Loudspeaker Terminals Important Please ensure that loudspeaker terminals are fully tightened Veuillez s'assurer que les bornes de l'enceinte son.
8 Incognito KP1 0 The KP10 is fitt ed on the wall by fixing it int o a standard UK 4 7mm depth single-gang electrician’s back-box (pattress). All knock -outs in the back-box should be remo ved t o provide maximum ventilation.
Incognito A-BUS keypad 9 Safety precautions Care should be taken when choosing the sit e for a KP1 0, the keypad must nev er be installed in a back-box which also contains mains wiring or in areas of high humidity . The KP10 runs on 2 4 V DC supplied through the connecting cable.
Cat5 to KP10 punch down connectors A Cat-5 cable (t erminated with an RJ45 jack plug) is used to connect the KP1 0 to an AH1 0 hub or A-BUS Ready receiver . The KP10 has punch down connectors f or the eight individual conductors of the Cat-5 cable (use a small flat-bladed screwdriver).
Incognito A-BUS keypad 11 Line-in/Line-out connections on subwoofer Screened audio cable Preamp output connections on rear of KP10 Gain adjust The maximum output of the KP10 can be limit ed by turning these do wn. Alternatively , if the sound level is t oo quiet, the Gain can be turned up.
12 Incognito KP1 0 The six LEDs indicate the function status of the KP10. List ed below are each of the functions of the corresponding LEDs: Minimum volume / Source select Volume / Source select / Bas.
Incognito A-BUS keypad 13 Standby/On Press to switch the k eypad between On and Standb y mode. By pressing and holding the Standby button f or about 2 seconds, all KP10s connected t o the AH10 hub will be turned off. If the KP10 is connected t o a Cambridge Audio Incognito R eady Amplifier rather than an AH10 hub, the am plifier will be turned off.
14 Incognito KP1 0 OPERA TING INSTRUCTIONS Important! As mentioned previously , the KP10 can be switched between two modes of operation; a standard A-BUS mode for compatibility with o ther manufacturers A-BUS Ready equipment (Standard A-BUS/Incognito Ready mode), and an Incognit o A-BUS hub mode (AH10 mode).
After holding both buttons down f or a short period, the second LED on the ke ypad will light indicating that Bass adjust mode has been activated. In this mode pressing the V olume up/down ke ys will adjust the Bass (low frequencies) lev el.
16 Incognito KP10 Note: This feature is only a vailable if the KP1 0 is part of a full Incognito multi-room system with one or two Local Input Modules (LM1 0) f itted. The local source selection mode will need to be activated t o configure the KP10 correctly .
Incognito A-BUS keypad 17 Continuing to hold V olume up and Po wer buttons will light LED 5, t o indicate that Off mode is available f or selection, and no source will be selected. T o select these modes, wait till the corresponding LED is lit and then release Power and V olume up buttons.
18 Incognito KP1 0 Input impedance 45 k ohms Frequency response 20Hz – 20kHz +/- 1dB THD <0.2% @ 1W , 20Hz – 20 kHz S/N ratio > 80 dB ‘A’ w eighted Volume control range - 80 dB, 36 steps.
Incognito A-BUS keypad 19 Cambridge Audio warrants this pr oduct to be free from def ects in materials and workmanship (subject t o the terms set f orth below). Cambridge Audio will repair or replace (at Cambridge A udio’s option) this product or any def ective par ts in this product.
Incognito KP10- EU www.cambridge-audio.com Part No. AP18303/2.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Cambridge Audio KP10 è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Cambridge Audio KP10 - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Cambridge Audio KP10 imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Cambridge Audio KP10 ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Cambridge Audio KP10, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Cambridge Audio KP10.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Cambridge Audio KP10. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Cambridge Audio KP10 insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
