Manuale d’uso / di manutenzione del prodotto YM-CL8W del fabbricante Yeoman
Vai alla pagina of 34
PM426 Issue 3 (March 201 1) IMPORTANT This appliance will become hot whilst in operation, it is therefore recommended that a suitable guard should be used for the protection of young children, the elderly or infirm. Do not attempt to burn rubbish in this appliance.
COVERING THE FOLLOWING MODELS: MODELS: YM-CL3MF / YM-CL5W / YM-CL5MF / YM-CL8W / YM-CL8MF 2 APPLIANCE COMMISSIONING CHECKLIST 3 USER INSTRUCTIONS 4 General Points 4 Using the Appliance for the first t.
3 APPLIANCE COMMISSIONING CHECKLIST To assist us in any guarantee claim please complete the following information:- Retailer appliance was purchased from Name: ...........................................................................................
4 USER INSTRUCTIONS 1. GENERAL POINTS 1.1 Before use of this appliance please read these instructions fully. The appliance must be fitted by a registered installer * , or approved by your local building control officer.
5 USER INSTRUCTIONS Airwash Control CL O S E O PEN Primary Control CL O S E O PEN PR8721 PR8722 DOOR OPERATION 1.14 Use a protected gloved hand to operate.
6 USER INSTRUCTIONS Do not burn construction timber, painted, impregnated / treated wood, manufactured board products or pallet wood . 3.2 Solid fuel Burn only anthracite or manufactured briquette smokeless fuels listed as suitable for use with closed heating appliances.
7 USER INSTRUCTIONS 5.6 Burning Solid Fuel Solid Fuel can only be burned in a multi-fuel stove. Only for use with recommended fuels (see User Instructions, Section 3 ). Set air contr ols (see Dia gra m 9). PR8727 Airwash: 50% Primary Air: 50% 5.7 De-ash the fire bed before re-fuelling (see User Instructions, Section 7 ) .
8 USER INSTRUCTIONS 5.12 Do not burn bituminous coal, ‘petro-coke’ or other petroleum based fuels, as this invalidates the product guarantee . Do not load fuel above the log guard and the secondary combustion inlets at the back of the firebox (s ee Diagram 6).
9 7. ASH REMOVAL 7.1 Multi-fuel stove Riddle with the tool provided (see Diagram 9). PR8728 Push/Pull to operate Open Door (see Diagram 10). PR8729 — Using gloves carefully remove ashpan with the tool provided. Heat can remain long after use. — Place the ash into a Stovax Ash Caddy (Stovax Part No.
10 13.2 The chimney, any connecting flue pipe and the appliance flue ways, if incorporated, must be regularly cleaned. 13.3 Ensure adequate access for cleaning where it is not possible to sweep through the chimney.
11 This is caused by burning damp wood and running the appliance at too low a temperature. Use well seasoned wood and operate the appliance within the ideal temperature range. Tar is a major cause of chimney fires . If the appliance experiences problems with tar build up consult a chimney sweep before continued use of the appliance.
12 TECHNICAL SPECIFICATION YEOMAN 1. STANDARD FEATURES • Primary Air (under grate air for full multi-fuel use). • Airwash (for wood burning / clean glass). • Preset Secondary Air control (to ensure complete burning of flue gases). • Riddling grate system for clean de-ashing (multi-fuel only).
13 TECHNICAL SPECIFICATION Description Model A B C D E F (Ø) G H J K Yeoman CL3 YM-CL3MF 360 510 306 93 416 128/5" 400 22 240 195 Yeoman CL5 YM-CL5W 435 518 303 90 424 128/5" 408 24 315 199 YM-CL5MF Yeoman CL8 YM-CL8W 563 572 363 105 478 153/6" 449 24 441 225 YM-CL8MF YEOMAN DIMENSIONS All dimensions are in mm (25.
14 1. FLUE OR CHIMNEY 1.1 The flue or chimney system must be in good condition. It must be inspected by a competent person and passed for use with the appliance before installation. Products of combustion entering the room can cause serious health risks.
15 150mm minimum Constructional Hearth 840mm minimum Constructional Hearth 840mm minimum 150mm minimum 150mm minimum 225mm minimum PR8730 SITE REQUIREMENTS 1.
16 SITE REQUIREMENTS WALLS NEXT TO A HEARTH Position of Appliance & Hearth in relation to walls Requirement for the walls Distance of hearth from wall 'C' Distance of Appliance to wall M.
17 PRE-INSTALLATION CHECKS 1. FLUE Model Yeoman CL3 - YM-CL3MF Yeoman CL5 - YM-CL5W / YM-CL5MF Yeoman CL8 - YM-CL8W / YM-CL8MF Yeoman CL3 Yeoman CL5 Yeoman CL8 Flue / Chimney Size Without Liner System.
18 PRE-INSTALLATION CHECKS 3.5 All open flued appliances can be affected by temporary atmospheric conditions which may allow fumes to enter the boat. An electronic carbon monoxide detector conforming to the latest edition of BSEN50292 must be fitted and maintained.
19 LEGAL REQUIREMENTS Before installation and/or use of this appliance please read these instructions carefully to ensure that all requirements are fully understood. The appliance must be fitted by a registered installer*, or approved by your local building control officer.
20 INSTALLATION INSTRUCTIONS —Secure with self tapping screw. —Seal the connecting joints. Do not use a 90˚elbow to make this connection. The flue must be installed in accordance with manufacturers instructions. PR8735 Seal Collar with Fire Cement Self tapping screw Tee Size Stovax Part No.
21 INSTALLATION INSTRUCTIONS 3. FITTING AND REMOVAL OF THE FIREBRICKS 3.1 Remove the firebricks as part of the routine maintenance. This can be carried out without the use of tools. 3.2 Allow the appliance to cool fully before removing firebricks. 3.3 Take care when handling, as bricks can become fragile after use.
22 6. HEARTH FIXING 6.1 If the appliance is to be fixed to the hearth then use the hearth mount locking tabs shown in Diagram 10. —Position the appliance where required on the hearth and mark the location of the two fixing holes in the hearth mounts.
23 7. CAST TOP This appliance can be fitted with an optional cast top plate. The type of plate will depend on whether the appliance is installed with a top* or rear flue exit.
24 COMMISSIONING 1.1 To commission: — Replace the baffle and log guard. — Check the door alignment and catch operation and adjust if required (see Maintenance & Servicing, Section 7 ). — Check the soundness of door seals, castings and joints.
25 MAINTENANCE and SERVICING For a complete list of spare parts and accessories contact your Yeoman retailer or call 01392 474011 1. ANNUAL SERVICE 1.1 Before the start of the heating season strip, inspect and clean the appliance as detailed: — Allow appliance to cool.
26 1.5 During this time the appliance may give off some unpleasant odours. Keep the room well ventilated to avoid a build-up of fumes. 1.6 Your Yeoman retailer can carry out service and maintenance. 2. REMOVAL OF THE LOG GUARD 2.1 To remove the Log guard: — Lift Log Guard clear of the supporting brackets.
27 Length (mm) Seal Yeoman CL3 Yeoman CL5 Yeoman CL8 Door rope seal C 1400 1600 2300 Door rope seal D 175 175 410 Mid door rope seal E (CL8 models only) n/a n/a 450 — Remove the old rope. — Scrape old glue from the locating groove. — Clean the locating groove with a clean dry cloth removing all dust and debris.
28 PR8741 M6 screws x 4 — Use an M6 hexagon key to loosen the 4 x M6 screws. The hinge plate assembly is slotted so it can be moved up, down and sideways by approximately 3mm to adjust the position of the door in relation to the appliance.
29 SPARES LIST YM-CL3MF YM-CL8MF YM-CL5MF Re f. No. Product Code Drawing No . (if different) Description 1 CA7668 5” CAST FLUE 2 SS13 MEC7026 5” FLUE BLANK 3 SM15 ME7027 SECONDAR Y AIR COVER 4 CE7.
30 SPARES LIST YM-CL8W YM-CL5W 1 CA7668 5” CAST FLUE 2 SS13 MEC7026 5” FLUE BLANKING PLA TE 3 SM15 ME7027 SECONDAR Y AIR COVER 4 CE7812 BRICK RIGHT HAND 5 CA7645 PLINTH 6 CA7630 CLEANBURN AIR DUCT CASTING 7 CA7664 LOG RET AINER 8 MEC8628 DOOR ASSEMBL Y 9 S5.
31 SPARES LIST YM-CL3 YM-CL5 YM-CL8 YM-CL5 cont. 1 CA7597 CAST DOOR 2 MEC8619 D OOR HANDLE ASSEMBL Y 3 F A500024 W AVE SPRING - YRW -0087S17 4 F A9508 F A500016 SPRING 6.
SERVICE RECORDS 32 1ST SERVICE Date of Service:........................................................................... Next Service Due:....................................................................... Signed:................................
33.
A division of Stovax Ltd Falcon Road, Sowton Industrial Estate, Exeter, Devon, England EX2 7LF Tel: (01392) 474500 Fax: (01392) 219932 E-mail: yeoman@stovax.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Yeoman YM-CL8W è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Yeoman YM-CL8W - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Yeoman YM-CL8W imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Yeoman YM-CL8W ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Yeoman YM-CL8W, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Yeoman YM-CL8W.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Yeoman YM-CL8W. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Yeoman YM-CL8W insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
