Manuale d’uso / di manutenzione del prodotto S-640 del fabbricante Weber
Vai alla pagina of 28
43165 US 01/30/07 LP G AS GRILL B uilt-In LP Gas Grill Installa tio n Guid e #43165 S-440 S-640 YOU MUST READ THIS O WNER’S GUIDE BEF ORE OPERA TING YOUR G A S GRILL DANGER If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open fl ames.
2 WWW . WEBER.COM ® LOC A TING YOUR GRILL When determining a suitable location for your Summit ® gas grill installation, give attention to concerns such as exposure to wind, proximity to traffi c paths, and keeping any gas supply lines as short as possible.
3 WWW . WEBER.COM ® 3 1 6 7 8 5 3 2 4 a c d b 1 1 1 3 2 b GENERAL CONSTRUCTION DET AILS Summit ® Built-In unit and all other accessory units should be on site before construction begins. All dimensions have a tolerance of plus or minus (+/-) 1 / 4 inch (6.
4 WWW . WEBER.COM ® OR S-440 S-640 Lid - 1 Cookbox - 1 Lid - 1 Cookbox - 1 Front Frame Rail - 1 Rear Frame Rail - 1 Rear Panel Assembly - 1 Bottom Shelf - 1 Left Door - 1 Right Door - 1 W arming Rack.
5 WWW . WEBER.COM ® 5 S-440 S-640 S-440 S-640 Flavorizer® Bars - 8 - 12 Stainless Steel Cooking Grates - 2 - 3 Collection T ray - 1 Catch-Pan Holder - 1 Catch-Pan - 1 Disposable Drip Pans - 2 Hinge .
6 WWW . WEBER.COM ® 1 1 2 2 3 1 2 Arrow stickers on Frame Rail (1) and Left Side Panel (2) should point toward each other (shown above). Door Stop Bracket (3) should be positioned as shown (left).
7 WWW . WEBER.COM ® 7 3 A TTENTION! Do not fully tighten screws. Clips should slide freely when installed. 4 ASSEMBL Y.
8 WWW . WEBER.COM ® 5 6 Back ASSEMBL Y.
9 WWW . WEBER.COM ® 9 7 ASSEMBL Y.
10 WWW . WEBER.COM ® CAUTION: Use two people to lift and install the Summit ® Built-In frame assembly . A.) Lift the frame assembly into the “island” structure opening. Make sure the frame is resting level on the fi nished surface of the structure.
11 WWW . WEBER.COM ® 11 9 10 C . (1) S440 S640 C.) Apply a bead of silicone sealant (1) around the perimeter and front edges of the grill that are in contact with the “island” structure. This will prevent moisture seepage. The sealant you use must have a temperature rating above 120°F (48.
12 WWW . WEBER.COM ® F)'# S440 11 (1) (3) (2) 12 ASSEMBL Y.
13 WWW . WEBER.COM ® 13 S640 S440 13 14 (1) (2) S640 S440 ASSEMBL Y.
14 WWW . WEBER.COM ® S640 S440 a b c 15 Match Holder ASSEMBL Y.
15 WWW . WEBER.COM ® 15 S640 S440 16 17 1/4” (6.35 mm) Drill Bit ASSEMBL Y.
16 WWW . WEBER.COM ® S640 S440 18 19 20 S440 S640 S640 S440 ASSEMBL Y.
17 WWW . WEBER.COM ® 17 ASSEMBL Y 21 S640 S440 .
18 WWW . WEBER.COM ® (1) (2) (3) 22 S-440 S-640 ASSEMBL Y.
19 WWW . WEBER.COM ® 19 + AAA + AAA + AAA a 23 - 1 S-440 S-640 - 2 - 2 S-440 S-640 - 4 S-640 The Weber Grill Out ™ Handle Light has a “T ilt Sensor”: Lid up - ON / Lid Closed - OFF . The power button (a) activates or deactivates the “T ilt Sensor .
20 WWW . WEBER.COM ® T able 10-1 Maximum Capacity of Pipe in Cubic Feet of Gas per Hour for Gas Pressures of 0.5 psi or Less and a Pressure Drop of 0.3 Inch W ater Column. (Based on a 0.60 Specifi c Gravity Gas) Nominal Iron Pipe Size (Inches) Internal Diameter (Inches) Length of Pipe (Feet) 10 20 30 40 50 60 70 80 90 100 125 150 175 200 1/4 .
21 WWW . WEBER.COM ® 21 GAS LINE PIPING • Refer to the piping chart at the bottom of previous page. • The corrugated gas line from the manifold is 58 inches (1,473.2 mm) long. Do not extend the gas line. • We have provided the means to make an SAE 45° fl are connection.
22 WWW . WEBER.COM ® OPERA TING W ARNING: Only use the Weber ® T ank Enclosure Kit outdoors in a well-ventilated area. Do not use in a garage, building, breezeway or any other enclosed area. W ARNING: Y our Weber ® T ank Enclosure Kit shall not be used under an unprotected combustible roof or overhang.
23 WWW . WEBER.COM ® 23 LOC A TING YOUR LP T ANK ENCL OSURE KIT When determining a suitable location for your LP T ank Enclosure Kit installation, give attention to concerns such as proximity to traffi c paths, and keeping any gas supply lines as short as possible.
24 WWW . WEBER.COM ® 4 8 4 1 2 4 2 2 P ARTS LIST 2 Hose and regulator - 1 T ank stand - 1 T ank stand base - 1 T ank Scale - 1 1/4-20 nut - 6 Nylon washer - 12 1/4-20 x 1/2” bolt - 6 Cylinder glide.
25 WWW . WEBER.COM ® 25 MOUNTING THE LP T ANK BRACKET Mount the LP tank bracket to the right hand side of the enclosure opening using non corrosive hardware. Mounting holes are provided on the sides and bottom of your LP tank bracket. Be sure to mount the bracket securley to the enclosure before use.
26 WWW . WEBER.COM ® A B C D E i ii iii iv v CONNEC T GAS SUPPL Y A 58 inch (1,473.2 mm) corrugated gas line is supplied with the grill. This line needs to pass through the gas inlet opening to the main gas supply . 1) Connect the corrugated gas line to the manifold located on the right hand side of grill under the control panel.
27 WWW . WEBER.COM ® 27 VENTILA TION W ARNING: Air holes must be provided in the structure at the top and bottom to provide ventilation in the event of a gas leak. Air holes can be located in a low visibility area and should be protected by screening material to prevent rodents and insects from entering the structure.
©2007 The following trademarks are registered in the name of W eber-Stephen Products Co., an Illinois corporation, located at 200 East Daniels Road, Palatine, Illinois 60067 U.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Weber S-640 è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Weber S-640 - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Weber S-640 imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Weber S-640 ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Weber S-640, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Weber S-640.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Weber S-640. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Weber S-640 insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
