Manuale d’uso / di manutenzione del prodotto 120 VAC Models del fabbricante Vita-Mix
Vai alla pagina of 28
120 V AC Models T ouch and Go TM Blending Station ® High Performance Commercial Blender Owner ’ s Manual Read And Save These Instructions FOODSERVICE.
2 1. Read all instructions. 2. T o protect against risk of electrical shock, do not put motor base in water or other liquid. 3. Close adult supervision is necessary when appliance is used by or near children.
14. W ARNING: When processing hot liquids: • The 2-part latching lid must be securely in place. This allows steam to escape naturally , and will prevent the lid from coming off when the machine is turned on. • Use caution with hot liquids. Spraying from under the lid plug can occur , or escaping steam may cause scalding.
T ouch and Go TM Blending Station ® ON/OFF switch - Located on the side of the Motor Base the ON/OFF switch controls the power to the machine. With the machine plugged in, switch the machine to ON to ready the machine for blending. ST ART/STOP button - Pressing ST ART/ST OP once starts and runs the machine and turns the blades.
Due to the difference of recipes, your results may vary . See page 6 for information on Custom Programming these six buttons. DISPLA Y WINDOW - This area depending on what button is pressed, displays a variety of operation messages. A ‘Ready’ message appears when there is power to the machine.
The T ouch and Go TM Blending Station ® advanced electronic control can be custom programmed, requiring an optional programming chip, available from Vita-Mix for a nominal fee and with a minimum unit purchase. Contact your Vita-Mix representative for more information .
4. Within 10 seconds the SIX PRE-SET buttons will be re-programmed and the DISPLA Y WINDOW will read ‘Saved’ then ‘Ready’. If nothing happens when the programming chip is fully inserted, turn the chip in the opposite direction and try again. 3.
T wo-part Lid 48 oz. polycarbonate container The two part lid is easy to clean and easy to put on, take off & seal. • T o remove fully latched lid, squeeze tabs together on both sides of the container , pull upward and off. • T wist the center lid plug to fasten or remove.
T amper One Piece Lid (optional) 64 oz. polycarbonate container The one piece lid is easy to clean and easy to put on and take off. (Note: Brand new lids are a little stiff. This is temporary .) • There is no latch on this lid. • Add ingredients through port on top.
Preparing the counter area: • Before cutting holes, make sure that there is adequate clearance under the counter for the motor . The motor will extend about 5-2/3" (14.4 cm) below the counter but it is best to allow at least 10" from the under-counter to shelves or any other equipment under the counter .
Electrical requirements: • 120 V AC • 50/60 Hz. • 1 1.2 amps • All T ouch and Go Blending Stations are built using a U.S. 3 prong grounded cord and require a 20 amp outlet. Blending Station dimensions: • 17-1/2” (44.45 cm) high with lid closed • 21-1/2” (54.
Gasket Installation Instructions: 1. Follow the instructions on page 10 on preparing the counter area for the installation of your In-Counter T ouch and Go TM Blending Station ® . Also, use the T emplate Sheet (provided in your machine’s original package) to assist you in the placement and ventilation of your machine.
lending T ips 1. If your recipe freezes up, try reducing the amount of ice. Compared to other blenders, you do not need as much ice to make an equally frozen drink in a T ouch and Go TM Blending Station. ® 2. Place liquids and soft foods in your container first.
How to operate your Blending Station ® using the six Pre-Set Programmed Buttons. The following is the basic factory settings of the six PRE-SET buttons (your machines PRE-SET buttons may differ due to program revisions or if your Blending Station was programmed specifically for your business).
4. Select desired programmed setting by pressing any of the Pre-Set Buttons one through six. The machine will begin immediately to cycle through the selected program, and turn off when the program is complete. Each button has a different pre-selected combination of speed and length for blending.
1. Follow steps one through three of ‘How T o Operate Y our Blending Station Using The Six Pre-Set Programmed Buttons’ section on page 14. 2. The speed of the motor can be changed with: 3. The PULSE buttons can also be used to quickly increase the motor speed or decrease the motor speed.
Retainer Nut Removal • The retainer nut is easily removed using a standard 6” screwdriver . * T urn container upside down and insert screwdriver shaft between the lobe and drive spline. Push the screwdriver handle counterclockwise to loosen nut. Once loosened, remove by hand.
Item# Part #752 64 oz. - Container without lid assembly or blade assembly #755 64 oz. - Lid plug #756 64 oz. - Container , blade assembly & lid assembly #1 191 64 oz. - 2-piece lid assembly #1 192 64 oz. - Lid only (no plug) PLS145 64 oz. - 1-piece non-latching rubber lid #1 159 48 oz.
#756 #752 #18002 KIT107 RBB161 #18003 #755 #1 192 #1 151 #836 #791 #802 #1 191 #15506 #15502 (container without blade or lid) #15507 #1 159 #1222 19 #18004 PLS145.
Care Note T o ensure that you get the longest possible life from your Vita-Mix product, we recommend the following products, when used as directed by the supplier: Cleaning Product Supplier Solid Supra, Solid Power , . . . . . . . . . . . . .Ecolab, Inc.
CARE NOTE: Do not let mixtures, liquids and food products dry within the container . Rinse throughout use. Drying product may lock around the blade and weaken/tear the bearings seal when restarted.
Container 1. T o clean: Fill pitcher 1/4 full with warm (1 10˚F) water and add a couple drops of dish soap. * Return container to motor base and firmly position the two part lid. Run machine for 30 seconds. Empty container . Repeat this step. * NOTE: For maximum container life do not wash in dishwasher .
THREE PRONG AD APTERS ARE NOT T O BE USED IN CANADA. Blending Station ® On-Counter: Height of unit closed: 22” (54.56 cm) Shipping weight: 21 lbs. (9.534 kg) Dimensions 22” H x 9-1/4” W x 10-1/2” D (54.56 cm x 23.45 cm x 25.86 cm) Blending Station In-Counter: Height of unit above counter: 17-1/2” (44.
1. Problem: • Display Panel reads Solution #1: T urn the machine of f and on again to reset the programming Solution #2: Call Vita-Mix Customer Service.
Cooling the motor: If the machine has overheated: • The motor will stop and the message “MOTOR HAS OVERHEA TED REMOVE THE CONT AINER, THEN PRESS ST ART”, will scroll across the display window , while the words “HOT SHUTDOWN” will remain in the display window alerting you of the problem.
Limited Warranty Vita-Mix ® Corporation warrants your Commercial Blending Station ® to be free from defects in materials and workmanship for a period of three years from the date of purchase when used in accordance with the accompanying instruction booklet.
This Blending Station ® includes a 1-Y ear Service Contract effective from date of purchase. In the event your machine should need parts or repairs, covered under this Service Contract, call Vita-Mix ® customer service immediately for instructions. Proof of date of purchase may be required.
©2002 Vita-Mix Corporation. No part of this publication may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopy , recording or any information storage and retrieval system without the written permission of the Vita-Mix Corporation.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Vita-Mix 120 VAC Models è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Vita-Mix 120 VAC Models - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Vita-Mix 120 VAC Models imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Vita-Mix 120 VAC Models ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Vita-Mix 120 VAC Models, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Vita-Mix 120 VAC Models.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Vita-Mix 120 VAC Models. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Vita-Mix 120 VAC Models insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
