Manuale d’uso / di manutenzione del prodotto SD-M1711 del fabbricante Toshiba
Vai alla pagina of 18
TOSHIBA AMERICA INFORMA TION SYSTEMS STORAGE DEVICE DIVISION IRVINE, CALIFORNIA SD-M1711 D VD-R OM SCSI DRIVE USER MANU AL.
CONTENTS Introductio n .............................................................................. 1 Setup ........................................................................................ 3 Using the D VD- ROM Drive ........................
1 INTR ODUCTION – SD-M1711 D VD-ROM Drive General Features Tray Loading Mechanism 3-way Disc Eject (ej ect button, software, emergency eject hole ) Average Random Access Time CD-ROM 85ms DVD 105ms D.
CD • CD-D A • CD+(E)G • CD-MIDI • CD-TEXT • CD-R OM • CD-ROM-XA • CD-I Bridge (Photo-CD , Video CD) • CD-I • Multi-session (Photo-CD , CD Extra, CD-RW , CD-R) • CD-R (Read) • CD-RW (Read) Front Panel Figure 1.SD-M1711 DVD-ROM Drive Front Panel Loading Tray Load disc using tray.
3 SETUP – SD-M1711 D VD-ROM The following steps must be performe d to properly install your drive: • Set D VD-ROM Drive J umper Settings: SCSI ID , P arity , T ermination, 512/2K, P ower • Conne.
4 Terminator ON/OFF - This jumper turns termination power ON or OFF. If you are connecting more than one SCSI device to your system, and the DVD-ROM is not at the end of the chain, then terminator jumper is not required. 512/2K (Block Size Selectability) - This jumper is used to select default block size.
5 Audio Cable (optional) - If you ha v e a sound card and speak ers, and w ould like t o play a udio CDs on your computer , you will need to install a CD/D VD audio cab le. T oshiba's D VD-ROM driv es use a standard 4-pin audio cable that ca n be purchased from most local com puter suppliers .
6 Completing Installation After you ha v e connected all the necessary cables, push the D VD-R OM drive completely into the computers drive slot. Mount drive per y our computers instructions. T he screw len gth should not e xceed 30.5mm (measured from outside surf ace of side or bottom of drive to tip of scre w).
7 USING THE D VD D VD-R OM Drive – SD-M1711 Drive Operation Inserting a Disc - Horizontally T o inser t a disc into a driv e that is mounted horizontally , perf or m the follo wing steps: Figure 1.Inserting Disc 1. Open the drive's L oading tra y b y pressing the Eject Button.
8 Removing a Disc T o remove a disc from the D VD-ROM d r iv e, perf or m the follo wing steps: 1. Open the Loading T r a y by pressing the Eject Button. 2. Grasp disc by edges , and lift out of loading tra y . 3. Press Eject Button again to close Loading T ray .
9 Handling Media D VD media is sen sitive to dust an d fingerpr ints. Care fu lly handle media b y its edges only . If a D VD movie skips or hangs du ring playbac k , clean the media. Mo st D VD video pla ybac k issues are media-related and can be remedied b y proper handling and ca re of media.
10 TR OUBLESHOO TING – SD-M1711 Problem Solution Disc tra y cannot be opened • Check that there is pow er to drive. • Use Emergency Eject instructi ons to open tray . Drive is not recognized by system • Is the drive connected proper ly? Are all cables plugged in proper ly (e.
11 SPECIFICA TIONS –SD-M1711 General Interf ace SCSI Compatible DVD-ROM Standards DVD DVD-ROM (DVD-5, DV D-9, DVD-10, DV D-18) DVD-R, DVD-RW , DVD-RAM CD CD-DA CD-ROM CD-I Bridge (Photo-CD, Video CD) Multi-session (Photo-CD, CD Extra, CD-RW, CD-R) CD-MINI CD-TEXT CD+(E)G CD-ROM-XA CD-I CD-R (Read) CD-RW (Read) Storage Capacities DVD 4.
12 Data T r ansfer Rate D VD (Single) 6,750 – 16,200 KBytes/s D VD (Dual) 5,540 - 13,500 KBytes/s D VD-Video 2,704 – 6,536 KBytes/s D VD-R, D VD-R W 2,704 – 6,536 KBytes/s D VD-RAM ( V er 1.
13 Environmental Ambient T emperature Operating 5° to 50° C (41° to 122° F) Storage -10° to 60° C (-14° to 140° F) Shipping -40° to 65° C (-40° to 149° F) T emperature Gradient Operating 1.
14 Lasers CD Laser T ype Semiconductor La ser and 3-beam System W a ve Length 770 - 795 nm DV D L a s e r T ype Semiconductor La ser and 1-beam System W a ve Length 770 - 650 nm Regulatory The SD-M1711 D VD-ROM drive has be en cer tified by the f ollo wing regulatory agencies: • UL 1950 • CSA C22.
15 DRIVE CONNECT ORS –SD-M1711 Figure 1.SD-M1711 DVD-ROM Dri ve Rear Panel - Connectors Power Connector Power is supplied to your DVD-ROM drive b y the connection with your computer's +5V/+12V power cable to the powe r socket at the back of drive.
16 Table 1.Interface Pin Assignments PIN NO. SIGNAL NAME PIN NO SIGNAL NAME 1 GND 2 -DB0 3 GND 4 -DB1 5 GND 6 -DB2 7 GND 8 -DB3 9 GND 10 -DB4 11 GND 12 -DB5 13 GND 14 -DB6 15 GND 16 -DB7 17 GND 18 -DB.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Toshiba SD-M1711 è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Toshiba SD-M1711 - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Toshiba SD-M1711 imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Toshiba SD-M1711 ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Toshiba SD-M1711, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Toshiba SD-M1711.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Toshiba SD-M1711. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Toshiba SD-M1711 insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
