Manuale d’uso / di manutenzione del prodotto 35.1070.IT del fabbricante TFA
Vai alla pagina of 33
37 INTELLIGENT WE A THER STAT ION Instruction M anual INTRODUCTION: Congratulations on purchasi ng this state-of-the-art weat her station as an example of excellent design a nd innovative meas uring technique.
38 FEATURES: The Intelligent Weather Statio n • DCF-77 Radio co ntrolled time with manual setting opti on • DCF reception ON/OFF ( user selectabl e) • 12/24 hour time displ ay • Time zone opti.
39 • “Intelligent” weather informati on display • Can receive up to 3 transmitters • Wireless transmissi on at 868 MHz • Signal reception intervals at 4.
40 temperature and humidi ty should then be di splayed on the Weather station. If this does not happen after 2 mi nutes, the batteries will need to be removed from both units a nd reset from step 1.
41 station. Then within 2 minutes, t he channel 3 outdoor data from the third transmitter wi ll be displayed and the cha nnel icon will shift back to "1" once the t hird transmitter is successf ully received. If this is not happen, user shall restart t he setting up from step 1.
42 HOW TO INSTALL AND REPLACE BATTERIES IN THE OUTDOOR THERMO-HYGRO TR ANSMITTER The outdoor Thermo-hygro tr ansmitter uses 2 x A A IEC LR6, 1.5V batteries. To install and replace the batteries, pl ease follow the steps below: 1. Remove the battery cover wi th a small screwdri ver.
43 frequency signal DCF-77 (77. 5 kHz) and has a tra nsmitting range of approximately 1,500 km. Your r adio-controlled W eather Station receives this signal and converts it to s how the preci se time in summer or wintertime. The quality of the reception depe nds greatl y on the geographic l ocation.
44 FUNCTION KE YS: Weather Station: The Weather Station has 5 easy to use functio n keys. SET key • Press and hold the key to enter ma nual setti ng modes: LCD contrast, 12/24 hour time di splay, ti.
45 CH key (Channel ke y) • Select channel 1, 2, or 3 (if more t han 1 transmitter i s used) • Exit setting mode • Re-detect new transmi tters signal for all channels • Stop the outdoor tempera.
46 Air pressure history bar graph * When the signal form tra nsmitter is successfully received by the Weather station, this s ignal reception icon will be switched on. (If not successful, the icon wil l not be shown in LCD) So user can easil y see whether the last reception was s uccessful (i con on) or not (icon off).
47 • Time zone setting • Manual time setting • Calendar setting • DCF-77 time recepti on ON/OFF setting • °C/ °F temperature unit setti ng • Air pressure unit setti ng • Relative press.
48 The time zone can be set ±12 hour. The default ti me zone is set to “ 0h”. To set a different tim e zone: 1. The current time zo ne value starts flashing. 2. Use the MAX/+ or MIN/- key to set t he time zone. T he MAX/+ key increases the value and the MIN/- k ey decreases t he value in consecutive 1 hour intervals.
49 The date default of the W eather Station is 1. 1. i n the year 2005. Once the radio-controlled ti me signals are received, the date is automatically updated. However, if the sig nals are not recei ved, the date can also be set manually. 1. The year starts flas hing.
50 °C/°F TEMPERATURE UNI T SETTING The temperature displ ay can be selected to show temperat ure data in °C or °F. (default °C) 1. Use the MAX/+ or MIN/- key to tog gle between “°C” or “° F”. 2. Confirm with the SET key a nd enter the Air Pressure Unit setting .
51 be manually set to another val ue within the range of 960 – 1040 hPa (28.30 – 30.80 inHg) for a better refere nce. 1. The current relativ e pressure value will start fl ashing 2. Use the MAX/+ or MIN/- key to i ncrease or decrease t he value. Keep holding the key all ows the value to advance faster.
52 TO EXIT THE M ANUAL SET TING MO DE To exit the manual setti ng anytime from the ma nual setting modes, press the CH key anytime or wai t for automatic timeout.
53 2. Press the MAX/+ or MIN/- key to ac tivate the alarm ON or O FF. 3. Press t he SET key to enter the al arm value setti ng (alarm value flashing) 4. Use the MAX/+ or MIN/- key to set t he alarm val ue. 5. Press t he SET key to confirm a nd enter the HIGH outdoo r temperature alarm setting.
54 1. The O n/ Off icon is flashing. Press t he MAX/+ or MIN/- key to activate the alarm ON/OFF. 2. Press t he SET key to enter the al arm value setti ng (alarm value flashing) 3. Use the MAX/+ or MIN/- key to set t he alarm val ue. 4. Press t he SET key to confirm a nd return to the normal display .
55 WEATHER FOREC AST AND WEATHER TENDENC Y: WEATHER FOREC ASTING ICONS: There are 4 weather icons in t he fourth secti on of LCD which can be displayed in any of the foll owing combinations: For every sudden or signifi cant change in the air press ure, the weather icons will be updated accordingly to represent the c hange in weather.
56 Examples of changing w eather icons: Note: After initial set up of the Intell igent Weather Stati on with the setting of the relative value, readings for weat her forecasts sho uld be disregarded for the next 12-24 hours.
57 Note: • An upward air pressure tende ncy indicator mea ns that there is an increase in air press ure within the past 4 hours. • A downard air pressure tende ncy indicator mea ns that there is an decrease in air pressure wi thin the past 4 hours.
58 (-12, -9, -6, -3, -2, -1, a nd 0 hour). The bars are pl otted at each of the 7 steps and give the trend over t he recorded peri od. The scale on the rig ht compares the result. T he ″ 0 ″ in the middl e of this scale determines the current air pressure.
59 OUTDOOR TEM PERATURE AND HUM IDITY: The first LCD sectio n can show the outdoor temperat ure, the reception indicator, the minim um or maximum reading.
60 2. MAX or MIN indoor temperat ure data with ti me and date of recordings. Data wil l flash 3. MAX or MIN indoor humidity data with time and date of re cordings. Data will fl ash 4. Return to current indoor and o utdoor data. TO VIEW THE MIN/M AX DATA FROM DIFFEREN T TRANSMITTERS When more than 1 trans mitter used 1.
61 transmitters can be set up again. Then The “l ost” channel can be re- learned again by entering the c hannel re-learn mode. To relearn all the transmi tters, press and hol d the CH key for 3 seconds (outdoor reception signal will show again next to c hannel displ ay).
62 Some examples of the intelli gent weather di splay: German English French Italian Spanish.
63 DETAILED IN FORMATION S HOWN I N THE WEATHER DISPLAY: Displayed Information English German French Italian Spanish Time frame for weather forecast Forecast period: 6 hours / 12 hours / 24 hours/ 36 .
64 Probability of glazed frost Glazed frost Index 75% Rauhreif Index 75% Givre Index 75% Indice brina: 75% Indice escarcha: 75% Probability of tempest Tempest Index 80% Gewitter Index 80% Orage Index .
65 another location for the Thermo-hygro Trans mitter and/or the Weather Station. If the outdoor temperature and humidity data are not being received within few minutes after setti ng up (or the outdoor di splay show “--.-“ in the outdoor section of the Intel ligent Weather Stati on).
66 1. Fix a screw (not suppl ied) into the desired wall , leaving the head extended o ut the by about 5mm. 2. Remove the stand from the W eather Station by pulling it away from t he base and hang the station onto the screw. Remem ber to ensure that it locks into place before rel easing.
67 To wall mount: 1. Secure the bracket onto a desi red wall using the screws and plasti c anchors. 2. Clip the remote temperature/hum idity sensor onto the bracket. Note: Before permanently fi xing the transmitter wall base, place all units in the desired locations to check that t he outdoor temperat ure and humidi ty readings are receivable.
68 SPECIFICATIO NS: Temperature meas uring range: Indoor : 0ºC to +59.9ºC wi th 0.1ºC resolution 32°F to +139.8°F wi th 0.2°F resolution ( “OF.L” displ ayed if outside this range) Outdoor : -39.9ºC to +59.9ºC wi th 0.1ºC resolution -39.8°F to +139.
69 shall take an active part in the re use, recycli ng and recovery of the electrical and electronic waste. • The unrestricted disposal of electronic waste may do harm on public health and the quali ty of environment.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il TFA 35.1070.IT è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del TFA 35.1070.IT - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso TFA 35.1070.IT imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul TFA 35.1070.IT ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il TFA 35.1070.IT, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del TFA 35.1070.IT.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il TFA 35.1070.IT. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo TFA 35.1070.IT insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
