Manuale d’uso / di manutenzione del prodotto 1528 del fabbricante Taylor
Vai alla pagina of 24
W eatherGuide ™ Syst em with Remote Sensor Instruction Man ual 1 by 1528 MOON PHASE.
W elcome t o the T a ylor ® W eat herGuide Syst em. Simple, r eliable, accurate…it allows y ou to monitor indoor or outdoor locations from one room. T he base unit reads indo or conditio ns, while the remote sens or wir elessl y re ports outd oor we ather co nditio ns back to th e base unit for an all-in-one w eather displa y .
T o Po wer your W eatherGuide ™ Base Unit Y ou r W e ath erG uid e™ ba se un it may be powered by ei the r an AC adaptor (included) or 2 AAA batteries (not included). Adaptor po wer – insert the connector end of the adaptor into the jack on the side of the base unit.
If the t ransmis sion is su ccessfu l, the r emote sens or read ings and a “ ” icon w ill appe ar on the base u nit. If dashes a re still di spla yed on the receiver unit, press the Tx button again.
How to Display y our WeatherGuide™ T able top – use the T able Stand on the back of the base and r emote sensor units W all – u se the k eyh ole o n the b ack of t he ba se an d re mot e sens or un its .
Atomic Clock a nd Calendar Y our W eatherGuide™ has a radio-controlled clock/calendar that sets itself to the radio signal transmitted b y the U.S. Atomic Clock located in Colorado . T o synchronize the atomic clock: 1. P ress an d hol d the “-P MCE/ RCC ” button on the back of the base unit.
7 How to Set the Cl ock Manuall y T o man ually set the clock: 1. P res s and hol d the “SET/ AL ” butto n. The u nit wil l beep . 2. Pr ess “+C/F” or “-PMCE/RCC” to set the seconds to zer o. Press “SE T/AL ” to en ter . 3. Pr ess “+C/F” or “-PMCE/RCC” to cha nge the ho urs.
Tip: Hol d down th e “+C /F” or “-PMCE /RCC” buttons to a dvance the dig- its quickly . Daylight S avings T ime – to t urn D ST on, press “MODE” until “OFF” appears in the c loc k dig its. P ress an d hol d the “SET/AL ” button until it switches to “ON”.
2. Press and hold the “SET/AL ” button. The unit will b eep and the a larm’ s hour digit s will flash. 3. P ress “+ C/F ” or “ -PM CE/ RCC ” to change the hours. Press “SET/AL ” to enter . The minutes will flash. 4. P ress “+ C/F ” or “ -PM CE/ RCC ” to cha nge the minut es.
T o turn off the alar m: Press “MODE” until the Alarm displa y ap- pea rs. Pres s the “S ET/ AL ” butt on. Th e ala rm ico n wil l dis appe ar . The a lar m is turned off. Snooze f eature Pr ess the “Snooz e/Ligh t” button o n the top of the base unit to silence the alarm for 5 minutes.
11 How to r ead your W eatherGuide™ The base unit displa ys indoor conditions from its location. The remote unit will trans mit weather readings fr om its location back to the base unit. Alt erna tely , the remo te se nso r’ s probe cord may be use d.
12 Auto Scro ll feature – the base unit can be set to a utomatic ally scr oll thr ough r ead- ing s. T o ac tiva te Aut o Scrol l, press th e “Channel” button on the back of the base unit u ntil the a uto scr oll sym bol app ears on the LCD . The base unit w ill autom atically disp lay base a nd remot e readi ngs fo r 10 seconds each.
T o Vie w Minimum/Maximum temperature/hum idity readings Y our W eatherGuide™ will store the last recor ded high and low temperatures and hu mi dit y ov er a 2 4 hou r pe rio d. The 2 4 hou r period starts when the batteries are in- sta lled. 1. Press the “Min/Max” button once to see the h igh est te mpe rat ure/h umi dit y of th e da y .
Baro metric Pressure Readings Bar ometri c press ure r efers t o the pre ssure e xerted b y the atmos phere at a gi ven alt itu de . I t may be exp ressed i n eit her m ill iba rs (mb)/ hectopascal s (hPa), or inc hes of mer cur y (inHg).
15 15 For t he most accurat e barom etric pre ssure readings, y ou should program y our curr ent Altitude into your W eatherGuide™. If the curr ent altitude is unknown, one ref erence for altitude maps in the US is: http://www .ngdc.noaa.gov/mgg/topo/state.
Comfort Le vel Readings Y our W eather Guide™ c ombine s temper atur e and hum idity r eadin gs to determine an indoor comfort lev el. If the displa y shows WET or DR Y condition s, you ma y wish to adju st indoor tempe rature or humidity conditions to reach a com for table reading.
Humidity T rend Indicator s Y our W eatherGuide™ will indicate if humidity lev els are rising, falling, or steady . indicates Rising Humidity r eadings (humid- ity has gone up mor e than 2 degrees i.
Moon Phase and Tide The Moon pha se will autom atically displ a y acc ording to the current calendar . Tide levels w ill display as High, Medium or Low based on the curr ent Moon Phase . New Moon - The Moon's dark side is facing the Earth. The Moon is not visible (except during a solar eclipse).
Backlight F eature The base unit has a backlight for easy vie wing of the screen. Press the “Snooze/Light” button to turn the backlight on for 3 seconds. Press SNOOZE/LIGHT for a 3 second backlight T o Switch Betw een °F and °C Pr ess the “+C/F ” butto n to swit ch betw een Fah renhe it an d Cels ius t emp era ture di s- pla ys.
T roubl e-Shooting Disconnected Signals If th e rec eive r unit do es not r ecei ve a tr ansmi ssion f rom a r emo te chan - nel f or 1 hour , the d ispla y will sh ow das hes.T o cor rec t this pr obl em: 1. Check that the remote i s properly positioned, within the appr o- pri ate tr ans mis sio n ran ge .
21 T ransmission Collision Signals f rom othe r household de vices, such as do orbells, home s ecurity systems and entry controls, ma y interfere. This is normal and does not affect the general performance of thi s product. The transmission will resume once the interf erence recedes.
Pr ecautions 1. The rec eiver i s inte nde d for in doo r use o nly . I t is no t sea led against moisture and could be dam aged if used outdoors. 2. Do not immerse the unit in water . If you spill liquid on it, dr y im- mediately with a soft, lint-free cloth.
Specifications Range of temperature measur ement: Receiver unit (indoor onl y): 14°F to 158°F (-10°C to 70°C) Remote unit: -40°F to 158°F (-40°C to 70°C) Indoor Humidity: 20% - 99% RH Resolution: 0.
1528 8.08 24 One Y ear W arranty This pr oduct is warranted ag ainst defects in materia ls or workmanship for one (1) y ear from date of original pur chase . It does not cover damages or wear r esulting from accident, misuse , abuse , commercial use, or unauthorized adjustment and/or repair .
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Taylor 1528 è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Taylor 1528 - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Taylor 1528 imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Taylor 1528 ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Taylor 1528, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Taylor 1528.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Taylor 1528. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Taylor 1528 insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
