Manuale d’uso / di manutenzione del prodotto E4-S3000 del fabbricante Swisher
Vai alla pagina of 20
SWISH ER OWNER'S/OPERATOR'S MAN UAL E4--$3000 FR|MMER E4-$3000 Minimize the risk of injury to yourself and others! Read this manual and familiarize yourself with the contents. Always wear eye and hearing protection when operating this unit. Part Number 81950 Rev.
introduction The Swisher E4-$3000 hand held power equipment has been designed and built to deliver superior performance and reliability without compromise to quality, comfort, safety or durability.
General Safety Instructions Work Safely Swisher trimmers operate at very high speeds and can do serious damage or injury if they are misused or abused. Never allow a person without la_ainingor insh_uction to operate this unit! lk WARNING! Never make unauthorized attachment installations.
Be Aware of the Working Environment Avoid long-term operation in very hot or very cold weather. Reduce the risk of bystanders being by flying debris. Make sure no one is within 50 feet (15 meters)--that's about 16 paces--of an operating attachment.
Product Description Outer Tube Cutting Attachment Shield E4-$3000 TRIMMER Throttle Interlock Fuel Tank Gear Case Throttle Trigger Ignition Switch Handle Using the accompanying illustrations as a guide, familiarize yourself with this unit and its various components.
Assemb|y and Adjustments Handle 1. Position the handle on the outer tube as shown. See Figure 3. 2. Install the mounting bracket with the socket head cap screws. Tighten the screws finger-tight ONLY at this time. 3. Ix)care the handle in the best position for operator comfort (usually about 10 inches ahead of the throttle assembly).
Assembly and Adjustments Cutting Attachment Shield Head Cap __ Screw Bracket __-_-i Outer Tube E4-$3000 Cutting Attachment Shield Shim __ Nuts I Cutting Attachment Retaining Mounting Plate Nut Figure 9 Shim Line Cutter Figure 9A Scre ws Install the Cutting Attachment Shield E4-$3000 1.
Install the Trimmer Head _ WARNING! A standard grass trimmer machine should NEVER be oper- ated with blade-type attachments. 1. Turn the trimmer over so that the gearcase output shaft faces UR See Figure 5. 2. Remove and discard the plastic retain- ing plug.
Starting the Engine ,_ WARNING! The cutting attachment may rotate when the engine is started! _ WARNING! Never start the engine with- out the tool assembly and cutting attachments installed to the engine. Failure to do so could damage the engine and increase unexpected risk to the operator and any bystander.
Stopping the Engine OFF ure 21 E4-$3000 Idle the engine briefly before stopping (about 2 minutes), then slide the ignition switch to the "O" (Engine OFF) position. Adjusting Engine |die __lJ Figure 22 Idle The engine must return to idle speed whenever the throttle lever is released.
Shoulder Strap Operating With A Trimmer Head Although a shoulder strap accessory is not required for use with a grass trimmer, a shoulder strap can increase operator comfort during extended periods of operation.
General Maintenance MAINTENANCE, REPLACEMENT OR RE-PAIR OF EMISSION CONTROL DEVICES AND SYSTEMS MAY BE PER- FORMED BYANY REPAIR ESTABLISH- MENT OR INDIVIDUAL; HOWEVER, WARRANTY REPAIRS MUST BE PER- FORMED BYA DEALER OR SERVICE CENTER AUTHORIZED BY SWISHER.
10/15-Hour Maintenance 0.024-0.028 inch (0.6-0. 7 mm) Clean the spark plug and check the gap at the electrode. Figure 29 Every 10 to 15 hours of operation: Remove and clean the spark plug. Adjust the spark plug electrode gap to 0.024 - 0.028 inch (0.6 - 0.
139/150-Hour Maintenance Maintenance after first 139-hours, then every 150-hours thereafter. Combustion chamber should be decar- bonized, and the valve clearance should be adjusted. It is highly recommended that this is done by a Swisher-trained service technician.
Long Term Storage Whenever the unit will not be used for 30 days or longer, use the following proce- dures to prepare it for storage: II Clean external parts thoroughly.
Troub|eshootin Guide What To Check Does the engine crank? YES 1 Good compression? YES Does the tank contain fresh fuel of the proper grade? Possible Cause _ aulty recoil starter. Flnkt in the crankcase. Internal damage. I NO I Ix)ose spark plug. Excess wear on cylinder, piston, rings.
Troubleshooting Guide (continued) Symptom Poor acceleration. Engine stops abruptly. [Engine difficult to shut off._ Possible Cause Clogged air filter, Clogged fuel filter, Lean fuel/air mixture. Idle speed set too low. Switch turned off. Fuel tank empty, Clogged fuel filter, Water in the fuel, Shorted spark plug or loose terminal, Ignition failure.
NOTES 18.
NOTES 19.
Emission System Warranty Statement (Administered by Shindaiwa Corporation) Your Warranty Rights and Obligations The California Air Resources Board, the U.S. Environmental Protection Agency and Shindaiwa Corporation are pleased to explain the exhaust and evaporative emission control system war- ranty on your new small off-road (non-road) engine.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Swisher E4-S3000 è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Swisher E4-S3000 - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Swisher E4-S3000 imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Swisher E4-S3000 ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Swisher E4-S3000, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Swisher E4-S3000.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Swisher E4-S3000. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Swisher E4-S3000 insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
