Manuale d’uso / di manutenzione del prodotto CDU924S del fabbricante Sony
Vai alla pagina of 16
CDU924S CD-R Drive Unit User ’s Guide Mode d’emploi Bedienungsanleitung © 1996 by Sony Corporation Rev . 1.0 BKC: 42264600 CDU924S CD-R Drive Unit User ’s Guide.
This unit uses CD-R discs with the following mark. This unit uses CD-ROM discs with the following mark. When you use this unit as a CD player , use compact discs with the following mark. Y ou are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.
Contents Introduction 6 Example of System Setup 7 Location and Function of Parts and Controls 8 Front Panel .............................................................................................................8 Rear Panel .....................
Example of System Setup T o use the CDU924S, at least the following components are necessary . ● Computer (IBM-PC*, HP V ectra**, or compatible equipment) ● CDU924S CD-R Drive Unit ● SCSI host adapter ● Floppy disk drive ● SCSI interface cable (Single ended, 50 pin flat.
Rear Panel 1 Jumper block for SCSI bus Specify assignment of the SCSI bus. 2 T erminators The terminator resistors are inserted into the sockets. Remove the resistors when the SCSI bus is to be terminated externally . Note: Some models are shipped without terminators.
Installing the Drive Unit into the Computer As you go through this section, you may wish to refer to your computer ’ s manual for a more detailed description of how to install internal drives.
Opening the Computer 1 If your computer has its rear side covered by a plastic panel attached with plastic hook pad, pull it of f. 2 Remove the cover mounting screws. 3 Remove the cover of the computer . Installing the Drive Unit into the Computer 13 Remove the jumper to set to OFF , and install the jumper to set to ON.
Connecting the Drive ■ Power-in connector Insert the plug and push it firmly in place. The power supply connector recommended has Molex 8980-3 contacts and a Molex 8981-04P housing. Pin assignment Installing the Drive Unit into the Computer 15 Mounting the Drive 1 Remove the screws and brackets from both sides of the drive spaces.
■ Interface connector 1 Insert one end of the interface cable into the interface connector firmly . 2 Attach the other end of the cable to the host adapter . Installing the Drive Unit into the Computer 17 ■ Frame ground When normally installed, the drive unit is not in contact with the host computer directly and should be grounded.
Reassembling the Computer 1 T uck the cables behind the drives so that they do not come up above the power supply . Check the following before closing the computer: ● Are the connections between the.
Using Discs and Caddies Loading a Caddy with a Disc 1 T o open the caddy lid, press the tabs on the both sides of the caddy at the end opposite to the shutter . 2 Set a disc, with its label upward, in the caddy . Be careful not to touch the recording surface when setting a CD-R disc in the caddy .
Storing Discs and Caddies ● Remove the caddy from the drive unit before moving the drive. ● Do not store the disc and caddy in a location subject to: – high humidity – high temperature – excessive dust – direct sunlight Care of Discs ● Hold the disc by its edge.
In such a case, eject the caddy and re-insert it properly . If the busy indicator remains lit amber , consult your dealer or qualified service personnel. The busy indicator also lights amber during audio play . However , this is not a malfunction. Ejecting a Caddy 1 T urn on the power supply .
Specifications ■ General Host interface SCSI-2, single ended, 50 pin Read Function Acceptable discs: CD-ROM Mode-1 data discs CD-ROM Mode-2 data discs CD-ROM XA discs CD-Audio discs Audio-combined C.
Shock Operating Read: 49 m/s 2 (5 G) at 1 1 ms half sine wave (includes 5 retries) W rite: 4.9 m/s 2 (0.5 G) at 11 ms half sine wave Non-operating 490 m/s 2 (50 G) at 1 1 ms half sine wave T ransportation 76 cm drop (with standard individual package) ■ Dimensions and weight Dimensions 146.
■ Dimension diagram Important Screws must not extend more than 4.0 mm into the side panels or the bottom plate. Specifications 31 ■ Supplied accessory User ’ s Guide (1 each) Disc Caddy OP A-2000 (1 each) ■ Optional accessories CD ROM discs: YHDS-50 “CD-ROM T est Disc T ype 1.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Sony CDU924S è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Sony CDU924S - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Sony CDU924S imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Sony CDU924S ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Sony CDU924S, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Sony CDU924S.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Sony CDU924S. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Sony CDU924S insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.