Manuale d’uso / di manutenzione del prodotto TAD 1130 del fabbricante Radio Shack
Vai alla pagina of 24
Owner’s Manual Please read before using this equipment. TAD 1130 2.4 GHz Digital Spread Spectrum Cordless Speakerphone with Digital Answering System 43-1130.
2 ˆ Contents Features ........... .............. .............. .............. .............. ................. .............. .............. ...... ........ .... 6 Installation ....... .............. .............. .............. .............. ....
3 Adjusting the T AD’S V olume ..................... .............. .............. ................. .............. ........... 19 Deleting Messages ................... ................ .............. .............. .............. ................. .
4 9. Do not use this product near water , for example, near a bath tub, wash bowl, kitchen sink, or laundry tub, i n a wet basement, or near a swimming pool. 10. Do not place this product on an unstable cart, stand, or table. Th e product may fall, causing serious damag e to the product.
5 BATTERY SAFETY INSTRUCTIONS CAUTION: TO REDUCE THE RISK OF FIRE OR INJURY, READ AND FOLLOW THESE INSTRUCTIONS. 1. Use only the appropriate type and size battery pack specified in the instru ction manual provided for this product. 2. Do not dispose of the battery pa ck in a fire.
6 Features THE FCC W ANTS Y OU TO KNOW In the unlikely event that your ph one causes problems on the phone line, the phone com- pany can temporarily d iscontinue your ser- vice.
7 Features T ELEPHONE FEATURES 10 Number Memory Dialing — lets you store 10 numbers in memory fo r easy dialing. Page — lets you send a paging signal from the base to the handset to page someone or locate the handset if you misplace it. 30 Channels — automaticall y selects a clear channel when you ma ke or answer a ca ll.
8 Installation ˆ Installation MOUNTING THE PHONE You can place the TAD’s base on a desk or table, or mount it on a standard wall plate or directly on a wall.
9 Installation 7. Lift the base’s antenna to a vertical posi- tion. On a W all Plate or W all 1. Insert the bracket’s tabs into the base’s lower tab slots, then press down on the bracket’s clips and insert them into the clip slots. 2. Plug one end of the suppl ied sh ort mod- ular cord into the TEL LINE jack on the back of the base.
10 Installation CONNECTING, CHARGING, AND REPLACING THE BATTERY PACK The TAD comes w ith a rechargeable ni ckel- cadmium battery pack installed in the hand- set, but not connected . Before using your phone, you must connect the battery pack, then charge it for about 24 ho urs.
11 Installation Warning: Di spose of the ol d battery pack promptly and properly. Do not burn or bury it (see “Battery Safety Instructions” on Page 5 for additional informa tion on proper battery handling). If you have trouble replacing the battery pack, take the phone to your local Ra- dioShack for assistance.
12 Installation A QUICK LOOK AT THE HANDSET Note: The handset window has plastic film on it to protect it during shipment. Careful ly peel off the film befo re using your ph one for th e first time. SETTING THE DIALING MODE Set PULSE-TONE on the back of the base for the type of service you have.
13 Installation 4. Press TA L K or place the handset on the base to hang up. T URNING THE BASE’ S RINGER ON AND OFF To turn off the base’s ringer, set RIN GER on the back of the base to OFF .
14 Telephone Operation ˆ T elephone Operation MAKING AND RECEIVING CALLS WITH THE HANDSET To make a call, lift th e handset and press TA L K . The TA LK/LOW BATT indicat or on the handset and the CHARGE/IN USE indicator on the base light. Dial the number.
15 Telephone Operation Note: If you hear a high-pitched noise from the base’s speaker, the handset and the base are too close togethe r. Move them away from each other. USING FLASH FLASH performs the electronic eq uivalent of a switchhook operation for special services, such as Call Waiting.
16 Telephone Operation • If you receive a call while entering a number in memory , the T AD exits the storing process. 1. Lift the handset. 2. Press MEMOR Y . The T ALK/BA TT LOW indicator flashes. 3. Enter the phone number and any tone or pause entries (see “Usin g T one Services on a Pulse Line” o n Page 15 and “Enter- ing a Pause”).
17 TAD Operation Notes: • Connecting a headset disconnects the handset’s earpiece and microphone. • VOL 8 8 8 8 or 9 9 9 9 or MUTE on the handset also controls the connected head set’s volume. • If you place the handset on th e base to recharge it while the headset is co n- nected, be sure the handset seats p rop- erly .
18 TAD Operation ANN (announcement onl y) — The T AD plays the outgoing message but do es not let callers leave a message. SETTING THE T AD TO ANSWER CALLS To set the TAD to answer calls, press AN- SWER on the base.
19 TAD Operation To start recording a ph one conversa tion, hold down MEMO on the base until th e TAD beeps and –– appears. To sto p recording, press PLA Y /STOP or MEMO . The TAD stores a recorded conversation as a message (see “Playing Messages”).
20 TAD Operation Note: If you press SPEAKER or PLA Y/STOP while changing the PIN, th e TAD exits. Begin again with Step 1. REMOTE OPERATION While you are away from your home or of- fice, you can use a.
21 TAD Operation To enter a remote command, press # and (within 2 seconds) the number for the com- mand you want. Note: The remote operati on stops when someone picks up the handset or any p hone on the same phone line. Remote Commands Press # then To 1 Repeat the current message durin g playback.
22 Troubleshooting ˆ T roubleshooting We do not expect you to have any problems with your TAD , but if you do, these suggestions might help. Problem Suggestion Low volume or unusual sounds. Someone has picked up another phone on the same line. Hang up the other phone.
23 Troubleshooting If you still have problems, disconne ct the TAD. If other phones on the same line work properly, the fault is in thi s phone or its install ation. If you cannot find the probl em, take your phone to your local RadioShack store for assistance.
43-1 130 UCZZ01691BZ 05A00 Printed in China RadioShack Corporation Fort Worth, Texas 76102 Limited One-Y ear W arranty This product is warranted by RadioShack against manufactu ring defects in materia.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Radio Shack TAD 1130 è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Radio Shack TAD 1130 - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Radio Shack TAD 1130 imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Radio Shack TAD 1130 ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Radio Shack TAD 1130, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Radio Shack TAD 1130.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Radio Shack TAD 1130. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Radio Shack TAD 1130 insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
