Manuale d’uso / di manutenzione del prodotto PLCD65WXMU del fabbricante PYLE Audio
Vai alla pagina of 16
OWNER’S MANUAL Mobile Audio System • PLL Synthesizer Stereo Radio • CD Player/MP3 Player/WMA Player • Automatic Memory Storing • Full Detachable Panel • Preset Equalization • Electronic Shockpr oof (ESP) Function • USB Interface • Auxiliary Input Function • Remote Control PLCD65WXMU www .
2 CONTENTS Installation ...........................................3 T ake out screw befor e installation.........3 DIN Front-Mount (Method A) ................3 Installing the unit .................................3 Removing the unit .................
3 INST ALLA TION Notes: • Choose the mounting location where the unit will not interfere with the normal driving function of the driver . • Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly .
grounding of the unit. Note to install the short threading terminal of the mounting bolt to the back of the unit and the other long threading terminal to the dashboard. 10. Reconnect the cable to the vehicle battery's negative (-) terminal. Then replace the outer trim ring and install the unit's front panel.
DIN REAR-MOUNT (Method B) If your vehicle is a Nissan, Toyota, follow these mounting instructions. Use the screw holes marked T (T oyota), N (Nissan) located on both sides of the unit to fasten the unit to the factory radio mounting brackets supplied with your vehicle.
USING THE DET ACHABLE FRONT P ANEL REMOVING THE FRONT P ANEL 1. Pr ess the release button ( ) on the front panel and pull of f the front panel. 2. Keep fr ont panel into the case. INST ALLING THE FRONT P ANEL T o install the front panel, insert the panel into the housing and make sure the panel is properly installed.
7 WIRING CONNECTION FRONT Lch SPEAKER GREEN GREEN/BLACK MEMORY BACK-UP (B+) MAIN UNIT Rch RED Lch WHITE AUX IN CABLE IGNITION SWITCH (ACC+) POWER ANTENNA RED GROUND (B – ) YELLOW BLACK BLUE RCA CABL.
8 OPERA TION LOCA TION OF KEYS 12 17 7 18 15 10 5 8 11 9 4 24 21 20 22 2 3 1 6 19 13 16 14 23.
9 OPERA TION SWITCHING ON/OFF THE UNIT Switch on the unit by pressing any button (except button (7) and button (4)). When system is on, press POWER button (9) to turn off the unit. F ACEPLATE RELEASE Press button (7) to detach the removable faceplate.
10 OPERA TION CD OPERA TION • SWITCHING TO CD MODE If there is no CD inserted in the driver: Gently insert the CD with the printed side uppermost into the CD compartment until you feel some resistance. The CD is drawn into the driver automatically .
11 OPERA TION MP3 OPERA TION • SWITCHING TO CD (MP3) MODE If there is no MP3 disc inserted in the driver: Gently insert the MP3 disc with the printed side uppermost into the disc slot (5) until you feel some resistance. The MP3 disc is drawn into the driver automatically .
KEY Assigned IN Searching mode(T able 1) AUDIO KONB (ENCODER) & TUNE/TRACK UP/DOWN buttons: Searching file and dir ectory during Navigation. WMA OPERA TION The unit that can play the WMA disc and the operation is the same with MP3 operation described above.
OPERA TION in the device, the operation is the same with the MP3 operation described above. Note: • The main unit can only support the standard USB-memory disc which is approved by Micr osoft. • USB MP3 player is not a standard which means differ ent brand name or different models have their own standard.
14 REMOTE CONTROL HANDSET FUNCTION KEYS & CONTROL 1. PWR = Power ON/OFF Button 2. DSP (0) = Display Button (_, – , +, 0 For MP3/WMA Operation ) 3. SEL = Sound Mode Select Button (Character Shift Right For MP3/WMA Operation ) 4. VOL = V olume Up Button [Character Select (A, B ~ 8, 9, 0) For MP3/WMA Operation] 5.
15 SPECIFICATION GENERAL P o wer Supply Requirements : DC 12 V olts, Negative Ground Chassis Dimensions : 178 (W) x 160 (D) x 50 (H) Tone Controls - Bass (at 100 Hz) : ± 10 dB - T reble (at 10 KHz) : ± 10 dB Maximum Output P ower : 4 x 50 W atts Current Drain : 15 Ampere (max.
88-C2007-02 TROUBLE SHOOTING Before going thr ough the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer . Symptom Cause Solution No power . The car ignition switch is If the power supply is not on.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il PYLE Audio PLCD65WXMU è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del PYLE Audio PLCD65WXMU - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso PYLE Audio PLCD65WXMU imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul PYLE Audio PLCD65WXMU ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il PYLE Audio PLCD65WXMU, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del PYLE Audio PLCD65WXMU.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il PYLE Audio PLCD65WXMU. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo PYLE Audio PLCD65WXMU insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
