Manuale d’uso / di manutenzione del prodotto BB5T del fabbricante Pelco
Vai alla pagina of 20
Pelco • 3500 Pelco Way, Clovis • CA 93612-5699 USA • www.pelco.com In North America and Canada: Tel (800) 289-9100 or FAX (800) 289-9150 International Customers: Tel (1-559) 292-1981 or FAX (1-5.
2 Pelco Manual C1488M-B (2/99) REVISION HISTOR Y Manual # Date Comments C1488M 6/98 Original version. C1488M-A 9/98 Rev A. Revised the manual to incorporate Spectra™ Lite material. C1448M-B 2/99 Rev B. Revised the input power ratings, certifications, and operating temperatures.
Pelco Manual C1488M-B (2/99) 3 1.0 GENERAL 1.1 IMPORT ANT SAFEGUARDS AND W ARNINGS Prior to installation and use of this product, the following W ARNINGS should be observed. 1. Installation and servicing should only be done by qualified service personnel and conform to all local codes.
4 Pelco Manual C1488M-B (2/99) 1.2 REGULA TOR Y NOTICES NOTE: This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to part 15 of the FCC rules. These limits are de- signed to provide reasonable protection against harmful interference in a residen- tial installation.
Pelco Manual C1488M-B (2/99) 5 Figure 1. Back Box Parts COMPASS TOOL SAFETY BRACKET CONDUIT FITTING & LOCK NUT T -RAIL CLIP 1.3 UNP ACKING INSTRUCTIONS Unpack and inspect all parts carefully . Be sure to save the shipping box and any inserts. They are the safest material in which to make future shipments.
6 Pelco Manual C1488M-B (2/99) 2.0 DESCRIPTION The BB5A Series back boxes are used with the SD5 Series of Spectra™ (Software V ersion 3.0) domes and SD5A Series of Spectra II™ domes. The BB5T Series back boxes are used with the SD5T Series of Spectra™ Lite domes.
Pelco Manual C1488M-B (2/99) 7 3.0 INST ALLA TION FOR IN-CEILING MODELS This manual covers the installation of the BB5A-F , BB5A-PB, BB5A-PG, BB5A-PG-E, BB5T -F , BB5T -PG, and BB5T -PG-E back boxes only . For complete installation and operating instructions for the SD5 Series of Spectra™ (Software V ersion 3.
8 Pelco Manual C1488M-B (2/99) 3.1.2 Suspended Ceiling 1. Remove the ceiling tile from the ceiling. 2. Locate the center point to drill a hole in the tile. 3. Drill a hole in the ceiling tile using a 3/32-inch drill bit. 4. Remove the compass tool from the parts bag (refer to Figure 2).
Pelco Manual C1488M-B (2/99) 9 Figure 4. Installing Back Box Figure 5. Fastening Back Box HARD CEILING OR CEILING TILE T -RAIL CLIP FOR CEILING TILE HARD CEILING OR CEILING TILE T -RAIL CLIP FOR CEILI.
10 Pelco Manual C1488M-B (2/99) Figure 6. Wiring Diagram for Spectra™ (V er . 3.0) and Spectra II™ THUMBSCREW Figure 7. Wiring Diagram for Spectra™ Lite CONTROL (RS-422) 7 +5 to +24 VDC EXTERNAL.
Pelco Manual C1488M-B (2/99) 11 T able B. 24 V AC Wiring Distances The following are the recommended maximum distances for 24 V AC with a 10- percent voltage drop.
12 Pelco Manual C1488M-B (2/99) 3.3 BACK BOX INST ALLA TION 1. Suspended Ceiling Only (for hard ceiling, go to step 2) – Install the ceiling tile with the back box. Attach a T -rail clip on each side of the ceiling tile as shown in Figure 5. 2. Install a safety chain or cable (not supplied) that will support up to 16 pounds (7.
Pelco Manual C1488M-B (2/99) 13 3.4 BACK BOX CONNECTIONS Depending on the type of dome, refer to either Figure 10 or 1 1 to attach the wiring to the interconnect circuit board inside the back box. Also refer to Figure 6 or 7 if necessary . 1. Earth Ground - Connect earth ground to the middle connector on the power connector .
14 Pelco Manual C1488M-B (2/99) From controller T o 4-Wire terminal on circuit board RX- TX- RX+ TX+ TX- RX- TX+ RX+ 4. Control - If you are using a Coaxitron ® controller , control signals will be trans- mitted over the video coax.
Pelco Manual C1488M-B (2/99) 15 4.0 INST ALLA TION FOR PENDANT MODELS 4.1 PENDANT -MOUNT INST ALLA TION 1. Install the pendant dome mount. Refer to the instructions provided with the mount. If the mount is outdoors, make sure it is properly sealed to keep mois- ture out.
16 Pelco Manual C1488M-B (2/99) 5.0 TROUBLESHOOTING Symptom: LED does not light. If the red power LED on the door of the interconnect circuit board in the back box does not light: 1. T urn off power . 2. Open the door to the interconnect circuit board and check the fuse.
Pelco Manual C1488M-B (2/99) 17 6.0 SPECIFICA TIONS MECHANICAL Construction Back box: Aluminum Cable Entry In-Ceiling: .75" (1.91 cm) conduit fitting Pendant: Through 1.
18 Pelco Manual C1488M-B (2/99) Figure 12. SD5 Series Dimension Drawing 6.60 (16.76) 5.25 (13.34) 3.25 (8.26) 7.25 (18.13) 8.25 (20.96) 5.90 (14.99) In-Ceiling Dome Pendant Dome NOTE: V ALUES IN P ARENTHESES ARE CENTIMETERS, ALL OTHERS ARE INCHES. 5.90 (14.
Pelco Manual C1488M-B (2/99) 19 NOTES.
20 Pelco Manual C1488M-B (2/99) 7.0 W ARRANTY AND RETURN INFORMA TION Pelco, the Pelco logo, Camclosure, Esprit, Genex, Legacy, and Spectra are registered trademarks of Pelco. Endura and ExSite are trademarks of Pelco. © Copyright 1999, Pelco. All rights reserved.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Pelco BB5T è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Pelco BB5T - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Pelco BB5T imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Pelco BB5T ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Pelco BB5T, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Pelco BB5T.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Pelco BB5T. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Pelco BB5T insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
