Manuale d’uso / di manutenzione del prodotto KD-27A del fabbricante KitchenAid
Vai alla pagina of 16
KD-27A SERIES DISHWASHERS INSTALLATION INSTRUCTIONS FORM 4171083 (153138) 3-86.
THIS PAGE INTENTIONALLY LEFT BLANK.
BEFORE STARTING: Please read these installation instructions COMPLETELY AND CAREFULLY. They will save you time, work, and help to ensure optimum dishwasher performance. For Replacement Installation - Review these complete instructions to be sure that previous connections are compatible.
SPECIFICA T/O/ W Electrical Operating Load Maximum Protective Device Size Minimum Circuit Size Water Temperature Water Pressure (Flowing) Cabinet Opening 115 volts 60 hertz 1 phase 13.
1 CHOOSING THE LOCA T/ON For easy access to plumbing, it is most convenient to have your dishwasher located near the kitchen sink. Any built-in dishwasher must be fully enclosed on the top, both sides, and the back. Therefore, the cabinet space below your kitchen counter is probably the best location.
2 PREPARING THE LOCATION Access holes in the cabinets, floor, or rear wall for the hot water supply line, drain line, and electrical supply must be located within the shaded area in Fig. 3 in order to avoid interference with the dishwasher frame or other components.
For service convenience, a shut-off valve (not supplied) should be installed in the supply line in a readily accessible location (such as beneath the sink) and a union (not supplied) should be installed in the supply line near the dishwasher fill valve.
ELECTRICAL SUPPLY WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE NATIONAL ELECTRICAL CODE AND/OR OTHER LOCAL CODES. WARNING: DISCONNECT ELECTRICAL POWER SUPPLY. The electrical supply must be a 115 volt, 15 amp, properly grounded, positioned as shown in Fig.
3 PLACING THE DISHWASHER IN ITS LOCATION The adjustable kickboard and lower panel (Fig. 9) must be removed for access to dishwasher connections. Remove the kickboard (5) by removing the two screws (one with lock washer) that secure it. Remove two screws (1) and pull out the bottom of lower panel to unhook tabs (2) from frame.
To maintain dishwasher position and alignment, locate the adjustable brackets at the upper tank corners as shown in Fig. 13 and secure them to the counter top with self drilling flat head wood screws (supplied). CAUTION :Make sure screw heads will not interfere with the top of the door.
5 CONNECTING THE DRAIN LINE Remove the red plug from the dishwasher check valve and use a hose clamp (not supplied) to connect the prepared drain line directly to the dishwasher check valve (Fig. 15). Make sure there are no sharp bends or kinks anywhere in the drain line which might restrict water flow.
7 FlNAL CHECK LIST Open the dishwasher door and remove all cardboard, and literature. DO NOT remove the white plastic plug buttons (Fig. 17) from sides of door or the white plastic bumpers on front corners of the lower rack. DO NCrr remove the two spring retainers (Fig.
8 FRONT PANEL VARIATIONS Vari-Front Panel Pack - All KitchenAid dishwashers are equipped with reversible front panels. If you wish to change the color of your dishwasher panels, consult your Use and Care Guide for instructions on how to reverse these panels.
9 SEASONAL STORAGE - CAUTION - To protect against possible rupture of the fill valve, water lines leading to the diwasher, as well as water lines in the dishwasher MUST BE PROTECTED AGAINST FREEZING.
THIS PAGE INTENTIONALLY LEFT BLANK.
KitchenAid Major Appliances FORM 4171083 (153138) 3-86 PRINTED IN U.S.A..
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il KitchenAid KD-27A è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del KitchenAid KD-27A - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso KitchenAid KD-27A imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul KitchenAid KD-27A ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il KitchenAid KD-27A, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del KitchenAid KD-27A.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il KitchenAid KD-27A. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo KitchenAid KD-27A insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
