Manuale d’uso / di manutenzione del prodotto P61-2 del fabbricante Harman Stove Company
Vai alla pagina of 24
P61-2 Pellet S tove Owners Manual SAFETY NOTICE PLEASE READ THIS ENTIRE MANUAL BEFORE YOU INST ALL AND USE YOUR NEW ROOM HEA TER.
2 Fig. 1.
3 Please read this entire manual before you install and use your new room heater . Failure to follow instructions may result in property damage, bodily injury , or even death.
4 Unpacking The P61 is bolted to the skid to prevent move- ment during shipping. To free the stove from the skid you must re- move the hold-down bolts in the rear of the pedestal base.
5 Inst alling Place the stove on a noncombustible floor or UL approved floor protector that extends 6 inches to the front, 6 inches to the sides and 1 inch to the rear of the stove.
6 V enting Requirement s for T erminating the V enting W ARNING: V enting terminals must not be re- cessed into a wall or siding.
7 A combustion blower is used to extract the com- bustion gases from the firebox. This causes a nega- tive pressure in the firebox and a positive pressure in the venting system as shown in fig.
8 #2 Preferred method This method also provides excellent venting for normal operation but requires the stove to be installed farther from the wall.
9 #4 Inst alling into an existing chimney ( US only ) This method provides excellent venting for nor- mal operation. This method also provides natural draft in the event of a power failure.
10 #6 Inst alling into an existing fireplace chimney ( US and Canada ) This method provides excellent venting for nor- mal operation. This method also provides natural draft in the event of a power failure.
11 #8 Inst alling through the ceiling vent Through the ceiling vent, follow PLvent manufacturers recommendations when using wall and ceiling pass through.
12 Operation St arting First Fire Be sure the power cord is plugged into a 120 volt receptacle. This can be verified by the red power light on the control panel.
13 When to use "Stove T emp Mode" In "S tove T emp Mode" the S tove T emp Dial de- termines the temperature of the stove. Heat output and fuel consumption will remain constant.
14 ESP CONTROL Feed adjuster Sets the maximum feed ra te Test Runs all motors at full speed for two minutes to check operation.
15 The room sensor is a small temperature sen- sor on the end of a 60" gray wire. This sensor is installed much like a standard wall thermostat.
16 Removing Ashes: When approximatly 1 ton of pellets has been burned it will be necessary to empty the ash pan. Ashes should be placed in a metal con- tainer with a tight fitting lid.
17 Latch "closed "with blower cover in place. Burn pot clean-out is closed. Latch "open "with blower cover partly removed. Burn pot clean-out is open. Exposed blower wheel and flue opening, NOTE: ESP probe is visible.
18 FEEDER DOES NOT FEED 1. No pellets in hopper . 2. Feed motor will not run until ESP senses 165 deg. F. Maybe you did not put enough pellets in the burn pot before lighting the fire.
19 Weight 249 lbs. Blower 135 cfm Feed Rate .75 to 7.5 lbs. per hr . Hopper Capacity 72 lbs. Fuel Wood Pellets Flue Size 3 inch Outside Air Size 2 3/8 I.D. inch Fuse Rating 5 amp 32.
20 P61-2 Wiring Diagram.
21 Door Options Optional T rim To install, lay the frame face down on a sof t surface. Fasten door frame by inserting the 4 threaded post s on the frame through the door .
22 OPTIONS Side Heat Shields Side heat shields are available to reduce the clearance to combustible materials.
23 Description Part Number Hopper Gasket(6 ft.) 0-88-00248 Ash Pan Assembly 1-10-05800 Burn Pot Weldment 1-10-05802 Right Rear Shield 2-00- 06468-1 Left Rea.
24 Harman S tove Company warrants its products to be free from defects in material or workmanship, in normal use and service.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Harman Stove Company P61-2 è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Harman Stove Company P61-2 - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Harman Stove Company P61-2 imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Harman Stove Company P61-2 ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Harman Stove Company P61-2, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Harman Stove Company P61-2.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Harman Stove Company P61-2. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Harman Stove Company P61-2 insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
