Manuale d’uso / di manutenzione del prodotto Pharo Skyline 26017XX1 del fabbricante Hans Grohe
Vai alla pagina of 24
Installation Instructions / W arranty Pharo Skyline 26017XX1.
2 Installation Considerations For best results, Hansgrohe recommends that this unit be installed by a licensed, professional plumber . Please read over these instructions thoroughly before beginning installation. Make sure that you have all tools and supplies needed to complete the installation.
3 Suggested installation Minimum ceiling height -- 86 5/8”.
4 Rough-in Install 1/2” NPT male nipples at the positions shown on the rough-in diagram for the hot and cold water supplies. The nipples should extend 5/8” outside the surface of the finished wall. Install the finished wall surface. Make the wall water tight.
5.
6 Seal the wall ar ound the elbows with waterproof sealant. Failure to seal the wall can lead to possible water damage. Installation W rap the threads on the nipples with T eflon tape. Install the elbows. The elbow outlets should face downward. Drill the holes for the mounting screws with an 8 mm bit.
7 Hang the panel over the top screws only (1). With a partner holding the panel out of the way , Install the panel supply hoses on the elbows. T ighten the hose nuts. (2) Raise the panel (3). Push the bottom of the panel over the bottom screws (4). Lower the panel (5) so that the screws are in the narrow parts of the keyways.
8 T ighten the nuts using a 10 mm wrench. Place a black rubber hose washer in one end of the handshower hose. Install this end of the hose on the handshower outlet. Place the screen washer in the other end of the hose. Connect this end of the hose to the handshower .
9 Reset the HIgh T emperature Limit Stop (Optional -- if required by local code) Remove the thermostatic mixer handle and safety set. Remove the clip and stop ring from the thermostatic mixer stem. T ur n the water on to the handshower . T urn the stem until the output water is the desired maximum high temperature -- usually 110°F - 112°F .
10 Justify the handle T ur n the water on to the handshower . T ur n the thermostatic mixer handle until the output water is 100�F . T ur n the water off. Remove the thermostatic mixer handle and safety set. Reinstall the safety set so that the notch is at the 12:00 position.
11 Limited Lifetime Consumer W arranty This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in either the United States or Canada.
Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004 T el. 770-360-9880 • Fax 770-360-9887 www .hansgrohe-usa.com US - Installation Instructions • Part No.
User Instructions / W arranty Pharo Skyline 26017XX1.
2 T echnical Information Recommended water pressure 14.7 - 72.5 psi Minimum water pressure 29 psi Max. water pressure 147 psi Recommended hot water temp. 120� - 140� F* Max. hot water temp 165�F* Max. flow rate: showerhead 2.5 gpm handshower 2.5 gpm neck spray 2.
3 User Instructions T ur n the top volume control clockwise to obtain water from the overhead shower . T ur n the top volume control counter-clockwise to obtain water from the neck spray . It is not possible to run the overhead shower and the neck spray simultaneously .
4 T ur n the bottom volume control counter-clockwise to obtain water from the bodysprays. It is not possible to run the handshower and bodysprays simultaneously .
5 Neck spray and handshower • Neck spray and bodysprays • Using the thermostatic mixer T ur n the thermostatic mixer handle clockwise to make the water cooler . T ur n it counter-clockwise to make it warmer . The handle will stop at the 100° safety stop.
6 Open the overhead shower and neck spray T o open the overhead shower and neck spray , press the lower left hand corner of the cover . T o open the footrest, press the upper left corner of the cover . The showerhead will open to the 95° position. Push it upward to the 110° position, if desired.
7 Adjust the showerhead cover If the showerhead or neckspray cover does not hang straight, loosen or tighten the set screw with a 3 mm Allen wrench to correct.
8 Cleaning the hand and overhead showers The handshower and overhead shower use the Rubit TM self-cleaning system. If scale deposits are noticed in the spray channels, turn the water on lightly and rub over the channels with a finger or a sponge to dislodge them.
9 Replacement Parts 28532XX1 28276XX0 98875XX0 98874XX0 98883000 94082000 94074000 97582000 96509000 97342XX0 98891XX0 98891XX0 97441XX0 94282000 95041000 96519XX1 96483XX0 98879000 98880000 98882001 .
10 Limited Lifetime Consumer W arranty This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in either the United States or Canada.
11 THIS W ARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT P A Y FOR: A. Conditions, malfunctions or damage not resulting from defects in material or workmanship.
Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 3XX04 T el. 770-360-9880 • Fax 770-360-9887 www .hansgrohe-usa.com US - Installation Instructions • Part No.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Hans Grohe Pharo Skyline 26017XX1 è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Hans Grohe Pharo Skyline 26017XX1 - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Hans Grohe Pharo Skyline 26017XX1 imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Hans Grohe Pharo Skyline 26017XX1 ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Hans Grohe Pharo Skyline 26017XX1, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Hans Grohe Pharo Skyline 26017XX1.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Hans Grohe Pharo Skyline 26017XX1. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Hans Grohe Pharo Skyline 26017XX1 insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
