Manuale d’uso / di manutenzione del prodotto 56-24UVB del fabbricante Chauvet
Vai alla pagina of 17
LED PAR 56-24UVB User Manual.
CHAUVET®, 2010, All Rights Reserved Information and specifications in this User Manual are subject to change without notice.
1. Before You Begin 3 9/13/2010 2:33 PM 1. B EFORE Y OU B EGIN What is included • 1 x LED PAR 56-24UVB • 1 x Gel Holder • 1 x Warranty Card • 1 x User Manual Unpacking Instructions Immediately.
1. Before You Begin 4 9/13/2010 2:33 PM Safety Instructions • Please keep this User Manual for future consultation. If you sell the unit to another user, be sure that they also receive this instruction booklet.
2. Introduction 5 9/13/2010 2:33 PM 2. I NTRODUCTION Product Overview DMX In Power Input Microphone Microphone Sensitivity Adjustment Knob Fuseholder Bracket Adjustment Knob Attachment Bolt (not meant.
3. Setup 6 9/13/2010 2:33 PM 3. S ETUP AC Power This fixture runs on 100~240 VAC, 50/60 Hz. Before powering on the unit, make sure the line voltage to which you are connecting it is within the range of accepted voltages.
3. Setup 7 9/13/2010 2:33 PM Mounting Orientation The LED PAR 56-24UVB may be mounted in an y position provided there is adequate room for ventilation. Rigging Be sure that the structure can support the wei ght of the fixture. Pl ease see the “Technical Specifications” section of this manual for a detailed weight listing.
4. Operating Instructions 8 9/13/2010 2:33 PM 4. O PERATING I NSTRUCTIONS Configuring the Starting Address The LED PAR 56-24UVB fixture us es two DMX channels. The hi ghest channel that the fixture may be set to in order to function properly is 511. An y address higher than this will prevent access to all of the channels.
4. Operating Instructions 9 9/13/2010 2: 33 PM DMX Operation This operating mode allows control of the fixture with an external DMX controller. You must set the starting address for this mode. If this is your first time using DMX, then it is recommended that you refer to the “DMX Primer” section in the “Appendix” of this manual.
4. Operating Instructions 10 9/13/2010 2:33 PM Automatic This fixture has a preprogrammed pulsating chas e with adjustable speed. Access this via the control panel of the front of the fixture. Please see the instructions below for further d etails. 1.
5. Appendix 11 9/13/2010 2:33 PM 5. A PPENDIX General Troubleshooting S YMPTOM P OSSIBLE C AUS E ( S ) P OSSIBLE A CTION ( S ) Breaker/Fuse keeps blowing • Excessive circuit load • Check total load placed on the electrical circuit. • Short circuit along the power wires • Check for a short in the electrical wiring (internal and/or external).
5. Appendix 12 9/13/2010 2:33 PM DMX Primer There are 512 channels in a DMX connection. A fixt ure capable of receiving DMX will require one or a number of sequential channels. The user must assign a starting address on the fi xture that indicates the first channel reserved in the cont roller.
5. Appendix 13 9/13/2010 2:33 PM Cable Connectors Cabling must have a male XLR connector on one end and a female XLR connector on the other end. Do not allow contact be twe en the common and the fixture’s ch assis ground. Grounding the common can caus e a ground loop, and y our fixture may pe rform erratically.
5. Appendix 14 9/13/2010 2:33 PM 3-Pin to 5-Pin Conversion Chart If you use a controller with a 5-pin DMX outpu t connector, you will ne ed to use a 5-pi n to 3-pin adapter.
5. Appendix 15 9/13/2010 2:33 PM General Maintenance To maintain optimum performance and minimize wear, fixtures should be cleaned frequently. Usage and environment are contributing factors in determining frequency. As a general rule, fixtures should be cleaned at least twice a month.
T ECHNICAL S PECIFICATIONS WEIGHT & DIMENSIONS Length ............................................................................................................. 9.2 in (23 4 mm) Width ............................................................
C ONTACT U S World Wi de General Information CHAUVET® 5200 NW 108 th Ave Sunrise, FL 33351 voice: 954.929.1115 fax: 954.929.5560 toll free: 800.762.1084 Technical Support CHAUVET® 5200 NW 108 th Ave Sunrise, FL 33351 voice: 954.929.1115 (Press 4) fax: 954.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Chauvet 56-24UVB è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Chauvet 56-24UVB - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Chauvet 56-24UVB imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Chauvet 56-24UVB ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Chauvet 56-24UVB, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Chauvet 56-24UVB.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Chauvet 56-24UVB. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Chauvet 56-24UVB insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
