Manuale d’uso / di manutenzione del prodotto ci325 del fabbricante CDA
Vai alla pagina of 40
Customer Care Department • The Group Ltd. • Harby R oad • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.
2 Important This appliance must only be used for the purpose for which it is intended, i.e. domestic use . Any other use could be dangerous and may lead to premature failure of the appliance. The CD A Group L td cannot be held responsible for injuries or losses caused by incorrect use or installation of this product.
3 IMPORT ANT INFORMA TION FOR CORRECT DISPOSAL OF THE PRODUCT IN A CCORD ANCE WITH EC DIRECTIVE 2002/96/EC. At the end of its working life, the product must not be disposed of as urban waste. It must be taken to a special local authority dierentiated waste collection centre or to a dealer providing this service.
4 Safety W arnings • If the plug or cord is damaged, do not connect the appliance to the mains power supply . If the cord is damaged it should be replaced by the manufacturer or appointed service agent in order to avoid a hazard. • T o remove the plug from the socket, pull on the body of the plug, not the cable.
5 W arnings T o avoid the risk of fire, electric shocks, injury or damage when using your washing machine, please take the following precautions: • Please read all the instructions before using the washing machine.
6 R ecommendations • R esidues of detergent or softener left in the detergent drawer for long periods will dry and stick to the detergent drawer . T o prevent this put the detergent and softener into the detergent drawer just before washing. • It is recommended that the pre-wash programme should only be used for very dirty clothes.
7 Before First Use When your washing machine has been correctly installed, we recommend that you pre-clean the machine. This is to check that the installation, the connections and the drainage are all correct, and to thoroughly clean the inside of the washing machine before any wash programmes are run.
8 • Fasten all zips and buttons. • T urn garments, such as knitted fabrics, inside out. • Before placing the clothes in the drum, make sure all the pockets are empty . Any small objects may block the drain pump. • W e recommend loading the washing machine to its full capacity for best water and energy eciency .
9 Detergents and Additives Y our washing machine’ s detergent dispenser has three sections as shown in figure 1. Add the required amount of detergent and fabric softener into the specific sections of the detergent dispenser before starting the wash programme.
10 the remainder to the main detergent section. Do not ex ceed the “MAX” level in the fabric softener section and ensure that concentrated fabric softeners are diluted before use for best washing results. R emember that the amount of detergent to be used will always depend on: • The amount of clothes to be washed.
11 Control P anel C B D A E F G H I A Programme Selector B Display C Spin Speed Selection D W ash T emperature E Delay Timer Button F Extra Rinse Button G Intensive Button H Rinse Hold Button I Start / P ause Button g.
12 S tarting a W ash Programme • T urn the “Programme Selector” knob to the required programme . • Select the required spin speed using the “Speed Speed” button. • Select the wash temperature using the “W ash T emperature” button. • Select any required extra options, as detailed below .
13 W ash temperature selection Each selected programme has its own preset wash temperature, as shown in the programme listing below . If you press the “W ash T emperature” button the currently set temperature will show on the display .
14 • Once the required time delay is shown on the display , the washing machine will set after appro ximately three seconds delay . Extra rinse This function adds up to 3 extra rinse cycles to the programme, which is ideal for large loads and garments belonging to people with sensitive skin.
15 Start / P ause Press the “Start / P ause” button to start the selected wash programme running, the indicator light stays on. If this is pressed again while the machine is running a programme the washer will pause and the indicator light will flash.
16 W ash T emperature Options Preset Spin Speed Delay Intense Rinse Hold Index Programme Cold 15 20 30 40 50 60 90 A Prewash ** A A A A P A A A 1000 A A A A B * Cotton A A A A P A A A 1000 A A A A C S.
17 Index Programme Detergent Compart. Max. Spin Load Capacity (kg) Programme Time Type of L aundry A Prewash ** 1 & 2 6 2:04 Heavily soiled cotton and linens B Cotton 2 6 2:49 Cotton and linens C .
18 Index Programme Max Load (kg) T emp. (°C) Energy Consumption (kWh) W ater Consumption (Litre) W ashing Time Spin Drying Performance B Cotton 6 60 0 .808 5 7. 7 3:00 53% B Cotton 3 60 0 .811 45. 0 3:00 - B Cotton 3 40 0.6 0 2 43.5 2:49 - EN60456 T esting Details Energy label program settings: 1.
19 Index Programme Max Load (kg) T emp. (°C) Energy Consumption (kWh) W ater Consumption (Litre) W ashing Time Spin Drying Performance B Cotton 6 60 0 .808 5 7. 7 3:00 53% B Cotton 3 60 0 .811 45. 0 3:00 - B Cotton 3 40 0.6 0 2 43.5 2:49 - Choice of Detergent Notes: The delayed start option is not recommended when using liquid detergent.
20 Care and Maintenance Before beginning any care or maintenance you should always disconnect the appliance from the electricity supply , and also turn o the water supply . If a programme has been run recently , wait for the water in the appliance to cool down to prevent risk of scalding.
21 Pump Filter The pump filter system prevents ingress of lint or foreign objects into the drain pump, reducing the risk of damage. The pump filter should be cleaned regularly , every two to three months at least.
22 g. 5 Detergent Drawer Detergents may cause residue build up in the detergent drawer and the drawer housing over time. The drawer should be cleaned regularly to remove these residues. T o remove the drawer: • Pull the drawer out until it stops.
23 Cleaning the W ashing Machine Exterior The exterior of the washing machine should be cleaned with warm soapy water or a gentle cleaning agent. Do not use abrasive cleaning products or solvents.
24 Practical Information Alcoholic beverages: The stain should first be washed with cold water , then wiped with glycerine and water and be rinsed with water mix ed with vinegar . Shoe Polish: The stain should be slightly scratched without ruining the cloth, rubbed with detergent and rinsed.
25 Blood stain: Soak the item in cold water for 30 minutes. If the stain still does not disappear , soak in a mixture of water and ammonia (3 table-spoons of ammonia in 4 litres of water) for 30 minutes. Cream, ice-cream and milk: Soak the item in cold water and rub the stained area with detergent.
26 Failure Code Probable failure The process to be done Err1 The door is not shut properly . Shut the door properly so that you hear the click then press the “Start / P ause” button. If the error persists, unplug the machine, close the water tap and contact CD A Customer Care.
27 T roubleshooting All repairs which must be done on the machine should only be performed by authorised service agents. When a repairs is required for your machine or you are unable to eliminate the failure with the help of the information given below: • Unplug the machine.
28 Fault Probable cause Methods of elimination The machine does not drain water . The drain hose is obstructed or bent. Check the drain hose. The pump filter is obstructed. Clean the pump filter . The drain hose is above 100cm. Install drain hose at specified height of 80-100cm.
29 Installation T ransit bolts, located at the rear of the appliance, must be removed prior to using the appliance to prevent damage. • R emove the back cover from the machine. • L oosen the transit bolts (T1, T2, T3 & T4 in fig. 6) using a suitable spanner by turning them anti-clockwise and then remove them.
30 installed on a flat, non-slippery and solid surface. The machine must be positioned on a solid support, such as the bare floor or a well-fitting riser , ensuring the machine is unable to fall when subjected to the typical vibrations generated by a washing machine.
31 Fitting the Furniture Door The machine is supplied with a fitting template that aligns with the top of the fascia door and has arrows cut out of it that point toward the door top. NO TE: If this template is aligned with the top of the décor door , the resultant position will align the décor door top with the top of the machine fascia.
32 Connecting to the Mains W ater Supply • Fit the seal included in the hose packing at the end of the water inlet hose on the tap side. • Connect the water inlet hose to a 3/4” BSP water tap.
33 The drain hose must be securely fastened to the outlet to prevent any risk of the drain hose becoming detached and causing ooding. Once the appliance is connected to the water supply and the dra.
34 How to connect an alternative plug If the fitted plug is not suitable for your socket outlet, then it should be cut o and disposed of safely to prevent the risk of electric shock. A suitable alternative plug of at least 13 Amp rating to BS 1363 should be used.
35 International W ashing Symbols W ash up to 90 °C W ash up to 60 °C Wash up to 30 °C Do not wash in a washing machine W ashing temparatur e Do not wash in a washing machine Lukewarm iron Medium hot iron Hot iron Do not iron Do not tumble dry Hang to dry Drip dry Dry flat Do not bleach Handy to bleach All of these are dry cleaning symbols.
36 NO TES.
37 NO TES.
38 NO TES.
39 E & O E. All instructions, dimensions and illustrations are provided for guidance only . CD A reserve the right to change specifications without prior notice.
Please contact our Customer Care Department for Service on the details below . Customer Care Department • The Group Ltd. • Harby R oad • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www .cda.
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il CDA ci325 è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del CDA ci325 - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso CDA ci325 imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul CDA ci325 ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il CDA ci325, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del CDA ci325.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il CDA ci325. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo CDA ci325 insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
